How to Use Cruise Control in ATSL?

What is the current emission standard?

Now the emission standard for new vehicles is China 6. Below is relevant information about China 6: Introduction to China 6: The China 6 standard is an upgrade from the China 5 standard, requiring carbon monoxide emissions and total hydrocarbons to be reduced by more than 50% compared to the previous standard. It has been implemented since July 1, 2019. The China 6 motor vehicle pollutant emission standard is established to implement the Environmental Protection Law of the People's Republic of China and the Air Pollution Prevention and Control Law of the People's Republic of China, to prevent pollution from exhaust emissions of compression-ignition and gas-fueled spark-ignition engine vehicles, protect the ecological environment, and safeguard human health. Implementation timeline of China 6: According to the plan, the China 6 standard will be implemented in two phases: 6A and 6B. The first phase started on July 1, 2020, and the second phase will begin on July 1, 2023.

19

1

Share

How Early Can Vehicle Inspection Stickers Be Obtained?

Vehicle inspection stickers can be obtained up to three months in advance. Below are the time regulations for vehicle inspections and the consequences of not adhering to the inspection schedule: Vehicle inspection time regulations: For vehicles over 6 years but under 10 years old, only two on-site inspections are required, specifically in the 6th and 8th years. Vehicles over 10 years old must be inspected annually; those over 15 years old require inspections every six months. For commercial passenger vehicles, inspections are required annually within the first 5 years; after 5 years, inspections are required every 6 months. Consequences of not adhering to the inspection schedule: If an uninspected vehicle is driven on the road and an accident occurs, the insurance company may refuse to compensate, leaving all liabilities to the driver. If a vehicle fails to pass the inspection and obtain the inspection sticker for three consecutive inspection cycles, the vehicle will be deregistered and subject to mandatory scrapping.

13

2

Share

What is the purpose of laser lights on highways?

The purpose of laser lights on highways is to serve as warning signals. Here are precautions for driving on highways: Check your vehicle in advance: Focus on fuel, engine oil, tire pressure, lights, etc., and plan your route. It's advisable to have a driver with at least 3 years of driving experience accompany you. Pay attention to speed limits: The minimum speed on highways should not be less than 60 kilometers per hour, and the maximum speed should not exceed 120 kilometers per hour. Maintain a safe distance: Control your speed and try to keep a considerable distance from the vehicle ahead. Change lanes correctly: Avoid crossing multiple lanes at once. Before changing lanes, carefully observe traffic conditions, use turn signals, and honk to alert other vehicles.

8

3

Share

How to Check if the Car Air Conditioning is Working Properly?

Methods to check if the car air conditioning is working properly: 1. Turn on the air conditioning while driving the car; if the engine is running, otherwise the air conditioning will not function normally; 2. Listen for any abnormal noises from the air conditioning. If there are no noises, it indicates the air conditioning is working properly. Loud noises suggest a problem with the compressor, which may require repair or replacement. Common symptoms of car air conditioning malfunctions include: the compressor engages, but the air conditioning system does not cool; the surface temperature of the compressor discharge pipe is very high; there is no temperature difference between the inlet and outlet pipes of the expansion valve; after the compressor engages, the high pressure does not change, but the low pressure is very low. The reason for this is: the temperature sensing bulb of the expansion valve is worn out, causing all the sealed refrigerant to leak, which closes the valve orifice of the expansion valve and prevents the refrigerant from circulating. Solution: Replace the expansion valve, then perform vacuuming, pressure testing, and recharge the refrigerant according to the specified amount for the air conditioning system.

17

2

Share

What lights to use when meeting another vehicle at 150 meters at night?

When meeting another vehicle at 150 meters at night, use low beam headlights. Using high beam headlights when meeting another vehicle at night can easily create a blind spot for the oncoming driver at about 10 meters. This obstructed vision can last for four to five seconds, which is highly likely to cause a traffic accident. In winter, when the road is slippery due to snow and ice, using high beams during a meeting can more easily lead to accidents. In cases of heavy fog, snow, or heavy rain where visibility is obstructed, low beam headlights must be used even during the day. When meeting another vehicle at night, you should switch to low beam headlights at a distance of 150 meters from the oncoming vehicle. On narrow roads, narrow bridges, or when meeting non-motorized vehicles, low beam headlights should be used. During a meeting, the high beam's intense brightness directly shines into the oncoming vehicle, making it difficult for the other driver to see the road ahead, which can easily lead to a traffic accident. Using low beam headlights can prevent this situation, so it is important to actively use low beams.

13

4

Share

Is it allowed to be late for the Subject 3 driving test?

Being late for the Subject 3 driving test is not allowed. Here are the precautions for the C1 Subject 3 test: Subject 3 test regulations: The turn signal must be turned on for no less than 3 seconds. Turning with less than 3 seconds will result in a 10-point deduction. When turning at an intersection, use the correct lights and alternate between high and low beams no less than 2 times. Precautions for using turn signals in Subject 3: Do not start immediately after turning on the turn signal; the correct way is to wait for 3 seconds to confirm safety before starting. When making a U-turn, use the left turn signal. U-turns are generally made to the left, and the left signal is used to alert vehicles behind to slow down to avoid collisions. If the right signal is mistakenly used, it may result in driving against traffic, which is a violation.

3

0

Share

How to Use Cruise Control in ATSL?

What is the current emission standard?

How Early Can Vehicle Inspection Stickers Be Obtained?

What is the purpose of laser lights on highways?

How to Check if the Car Air Conditioning is Working Properly?

What lights to use when meeting another vehicle at 150 meters at night?

Is it allowed to be late for the Subject 3 driving test?

How to Release Excess Car Refrigerant?

What is the difference between two-valve and four-valve motorcycle engines?

Can a used car purchased abroad be shipped back to China?

What products does Kawasaki mainly manufacture?