How to Use a Self-Balancing Scooter?

What are the causes of abnormal rail pressure?

Abnormal rail pressure may occur due to the following reasons: Faulty pressure switch: The engine utilizes a high-pressure common rail injection system to control fuel supply, where multiple cylinder injectors are fed by a single high-pressure fuel rail. If the fuel in the rail becomes insufficient due to pressure-related issues, it reduces the engine's power output per unit time, leading to abnormal rail pressure. Clogged oil passage: As engine oil passes through the fine pores of the oil filter, solid particles and viscous substances are trapped in the filter. A clogged filter prevents smooth oil flow, potentially rupturing the filter element or activating the safety valve, allowing unfiltered oil to bypass through the relief valve and carry contaminants back to lubrication points. Airborne pollutants may accumulate around the PCV valve, potentially causing blockage. A clogged PCV valve can cause contaminated gases to flow backward into the air cleaner, polluting the filter element and reducing filtration efficiency. This results in dirtier air-fuel mixture intake, further contaminating the crankcase, increasing fuel consumption, and causing abnormal rail pressure.

10

3

Share

Is it acceptable if one side is wide and the other side is narrow in the reverse parking test for Subject 2?

In the reverse parking test for Subject 2, as long as the vehicle does not touch the solid line throughout the process, it is acceptable if one side is wide and the other side is narrow after parking in the garage. For example, one side being 25 cm and the other 35 cm, or one side 20 cm and the other 40 cm, are both acceptable. Although having one side wide and the other narrow does not result in point deduction, it may lead to some unnecessary operations, making the entire reversing process more complicated and harder to remember. If one side is too narrow and the other too wide, when exiting the garage and turning towards the narrow side, you must wait until the rear wheel of the narrow side reaches the corner of the garage before turning the steering wheel. If exiting towards the wide side, you can turn the steering wheel a little earlier, carefully observing the relationship between the wheel and the garage corner in the rearview mirror. If it is too close, you must adjust the steering wheel to the right, wait until the rear wheel passes, and then turn the steering wheel again to exit the test area.

7

5

Share

What faults will occur if the spark plug is broken?

Symptoms of a damaged spark plug: The car may experience difficulties in starting, low power, excessive exhaust emissions, increased fuel consumption, and other faults. Methods to determine if the spark plug is damaged: Remove the spark plug and observe its appearance color to judge its condition. A normal spark plug has an insulator skirt and electrodes that appear gray-white, gray-yellow, or light brown. A properly functioning spark plug has a reddish-brown insulator skirt, an electrode gap between 0.8-0.9mm, and no signs of electrode burning. If the spark plug is covered with oil or deposits but is not damaged, it can continue to be used after cleaning off the oil and deposits. If the spark plug is severely damaged, with signs such as blistering at the top, black streaks, cracks, or melted electrodes, the cause of the damage should be identified. After troubleshooting, replace the spark plug with a new one. Additionally, if the spark plug appears black as if smoked, it indicates that the wrong heat range was selected or the mixture is too rich, and oil is leaking into the combustion chamber.

8

1

Share

What is the diameter of a 6.5-inch speaker in centimeters?

6.5-inch speakers generally have a diameter of approximately 16.5 centimeters. Working principle of speakers: The working principle of an air horn is to use the airflow of compressed air to vibrate a metal diaphragm and produce sound. Therefore, it can only be used on vehicles equipped with an air compressor. Air horns are generally installed on large buses and heavy-duty trucks, especially for long-distance transport vehicles driving in mountainous areas or curves. Using an air horn can effectively alert pedestrians and oncoming drivers. This is because air horns have high volume, good sustain, pleasant sound, and can be heard over long distances. Air horns are typically cylindrical and use a combination of high-pitch and low-pitch horns. The working principle of an electric horn is to use electromagnetic force to vibrate a metal diaphragm and produce sound. It is a widely used type of horn in automobiles, classified into three structural forms: cylindrical, spiral, and cone-shaped, with spiral and cone-shaped being the most common. Classification of horns: Automobile horns are divided into air horns and electric horns based on their sound power; into cylindrical, spiral, and cone-shaped based on their appearance; and into high-pitch and low-pitch horns based on their frequency.

5

0

Share

Method for Adjusting Left and Right Rearview Mirrors in Subject 2 Parallel Parking

Method for adjusting left and right rearview mirrors in Subject 2 parallel parking: 1. First adjust the right rearview mirror so that the upper edge allows visibility of the rear door handle, while ensuring the front door handle is centered in the mirror (vertical position). The car body should occupy 1/4 of the mirror's area (the less the better, but too small may cause inconsistent width perception of ground lines compared to the left mirror). This setup allows better right-side visibility. 2. For the left rearview mirror adjustment, refer to the right mirror settings. However, the left mirror has an additional function - it must allow visibility of the left rear wheel during parallel parking. Ensure you can see the left rear wheel by leaning slightly, regardless of adjustment method (when the left rear wheel crosses the line at a 40-degree angle during parallel parking, full steering will guarantee entry). 3. During reverse parking, if the front guideline is absent in the test area and only the base line of the parking space is visible, you'll need to rely on the left rearview mirror. 4. With the front door handle centered vertically in the mirror, observe the left mirror during reversing. Stop when the front door handle aligns with the base line of the parking space. Note that individual height and seat position may require slight forward/backward adjustments, but the door handle and mirror positions remain constant reference points.

20

1

Share

What are the tips for the subject one exam?

Subject one exam tips are as follows: Traffic regulation related answering techniques: There is only one principle for answering - safety, choose the safest option. In judgment questions, all extreme behaviors in emergency situations are wrong, such as slamming (forcefully stepping on) the throttle (brake), sudden steering, and similar choices in multiple-choice questions are incorrect. Always yield when possible, help when possible, avoid when possible, as long as you don't rush or act hastily, it's correct. The principle for rescuing the injured is to save lives first, and the principle for saving lives is to stop bleeding first. At intersections without signs, lights, or police, judge according to the order of yielding to the right - yielding to left turns - yielding to straight traffic. Vehicles must use turn signals when changing positions, the only exception is entering a roundabout. Eight types of traffic police hand signal answering techniques: Stop signal: Left arm extended straight forward, palm facing forward; Go straight signal: Both hands extended, right hand waving; Left turn signal: Right arm extended forward, left hand waving to the right; Right turn signal: Left arm extended forward, right hand waving to the left; Left turn waiting signal: Left arm extended to the left at 45 degrees, waving up and down; Lane change signal: Right arm extended forward, palm facing left, right arm waving horizontally to the left; Slow down signal: Right arm extended to the right front, palm facing down, waving straight down; Signal for pulling over: Left arm extended straight forward, palm facing forward, right arm waving forward.

12

3

Share

How to Use a Self-Balancing Scooter?

What are the causes of abnormal rail pressure?

Is it acceptable if one side is wide and the other side is narrow in the reverse parking test for Subject 2?

What faults will occur if the spark plug is broken?

What is the diameter of a 6.5-inch speaker in centimeters?

Method for Adjusting Left and Right Rearview Mirrors in Subject 2 Parallel Parking

What are the tips for the subject one exam?

What Causes the Keyless Entry Door Handle Button to Malfunction?

What are the requirements for the reverse parking test in Subject 2?

How are spark plug models classified?

Should the Positive or Negative Terminal Be Removed First When Disconnecting a Car Battery?