How to Use a Mercedes-Benz Car Key?

1 Answers
McBethany
07/29/25 3:30am
Mercedes-Benz car key usage instructions: 1. Press and hold the lock button to close all windows and lock the car simultaneously. 2. Press and hold the unlock button to unlock the car and lower all windows at the same time. 3. Aim the key at the left front door handle of the car, keeping the distance within one meter, then press the lock button to automatically raise all windows and close the sunroof. 4. Pressing both the lock and unlock buttons together switches between two modes: one mode unlocks the entire car with a single press, while the other mode unlocks only the driver's side with a single press. For the trunk button, press and hold it longer to release.
Was this review help?
19
2
Share
More Forum Discussions

How to Repair Cylinder Scoring?

Minor cylinder scoring is easy to repair. Just replace the piston and piston rings, and lightly hone the cylinder walls. However, if the grooves reach 0.15mm, repair becomes impossible. For diesel engines, the cylinder liner can be replaced for repair. For gasoline engines, boring the cylinder and replacing the liner can be done for repair. After repair, there will be a break-in period, but the performance will be as good as new.
12
5
Share

How to Match the Remote Key for Chevrolet Lova?

Turn the ignition key off and on three times, wait until the anti-theft light goes off, then turn the ignition switch OFF. At this point, press and hold the unlock button on the remote until the warning light on the instrument panel lights up. Turn the ignition switch ON, press any button on the remote, and then immediately press any button on the other remote keys. Start the engine with the key and turn the main switch of the remote door lock system off and then on again.
10
5
Share

How to turn off the engine when parking a VV5?

The owner only needs to carry the induction card and stand within the detection range, then directly open the car door for convenient access to the vehicle. Pressing the one-touch start button turns on the vehicle's power. Press and hold the brake pedal, shift to N gear, then press the button to start the engine. When parking, shift to P gear or N gear. With the engine running, lightly press the one-touch start button once to turn off the engine.
7
5
Share

How to Install the Power Steering Pump Belt on the Lavida 1.4T?

Use a 12mm open-end wrench to loosen the screw on the power steering pump pulley and remove the power steering pump belt. First, align the four holes of the pulley with the main wheel, then place the power steering belt over that wheel and the power steering pump pulley. Finally, tighten the four screws in the middle. After pressing the middle part of the power steering belt and the middle part of the generator belt, ensure there is a free gap of at least 5mm. Inspect it. If there are no issues, the replacement is successful.
9
0
Share

How to Reset the Service Wrench on Lavida Hatchback?

First, open the car door and enter the vehicle, then insert the key into the ignition switch without starting the engine. Locate the protruding black button on the dashboard and hold it down. Next, turn the key to the second position, which is the ON position. The car will power on and begin self-check, during which all warning lights will illuminate—this is normal. Wait for the self-check to complete (keep the button pressed throughout this process). After about 5 seconds, the wrench icon will disappear.
10
3
Share

How to adjust the Kuangbazi tire pressure monitoring?

Tire pressure monitoring is displayed on the multifunction display screen, with sensors installed inside the four tires. Press the up or down arrow button to select tire pressure, then press the OK button to display the tire pressure of each tire on the multifunction display screen. When the pressure is too high or too low, a warning will be issued. The standards for too high or too low are based on the safe tire pressure set by the car owner.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.