How to Use a Car Spare Tire?

2 Answers
DiChristian
07/29/25 6:08am
How to use a car spare tire: Before installing the spare tire, place the removed tire under the vehicle to prevent accidents. When installing, ensure all the tire fixing screws are tightened before removing the jack. Tighten the screws in a diagonal sequence, not in a clockwise or counterclockwise order. Precautions for car spare tires: 1. Regularly inspect the spare tire: Check for any wear or cracks. If the wear reaches the indicator line, replace it as soon as possible. 2. Spare tires should not be used for extended periods: Due to low usage frequency and minimal friction with the ground, some spare tires may be smaller in size than regular tires, with differences in aspect ratio, width, or diameter. Prolonged use can affect the vehicle's braking system, steering system, and suspension system, posing potential safety hazards.
Was this review help?
16
1
Share
SimonLynn
08/12/25 9:38am
Changing a car spare tire is actually quite simple. I was really nervous when I first learned to drive, but now I'm much more skilled. First, pull over to a safe spot, turn on the hazard lights, and place a warning triangle behind the car to prevent other vehicles from hitting it. Then open the trunk and take out the spare tire, jack, and wrench—some cars have the spare tire mounted underneath the chassis. Use the wrench to loosen the lug nuts on the flat tire, but don't remove them completely—leave them half on. Locate the jacking point under the car (usually marked) and slowly raise the vehicle until the tire is off the ground. Next, remove the flat tire and align the spare tire to install it, tightening the lug nuts in a crisscross pattern to ensure balance. After lowering the jack, tighten all the lug nuts again with extra force. Finally, pack up the tools and drive away, but remember that spare tires are only for temporary use—don't exceed 80 km/h, and get to a repair shop as soon as possible. Make it a habit to check the spare tire's pressure monthly to keep it functional. There are many steps, but following them isn't hard—beginners will gain confidence after practicing a few times.
Was this review help?
4
4
Share
Expand All
More Forum Discussions

How to Remove the Exterior Handle of a 2020 Bora?

Tap off the small black cover to reveal a Torx 20 screw. Hold the door handle without releasing it, then loosen the Torx 20 screw until the door handle has a noticeable resistance and locks in place. For the decorative cover, as indicated by the red circle. Hold the door handle and apply force in the direction of the arrow. The door handle can then be removed.
15
2
Share

How to adjust the mirrors of Volkswagen CC?

First, the driver should sit in the driver's seat and locate the electric adjustment button on the left door. Observe the white dot on the adjustment button and the letters next to it: "L" represents the left rearview mirror, and "R" represents the right rearview mirror. To adjust the angle of the left rearview mirror, rotate the adjustment knob's white dot to the "L" position. Lift the knob upwards to change the mirror's viewing angle upwards.
5
1
Share

How to Reset the Odometer on a Geely Emgrand?

First, press the vehicle's one-touch start button to power on the vehicle; otherwise, the odometer cannot be reset. Then, locate the trip meter reset button at the lower right of the instrument panel. After hearing a beep sound, the trip meter will be reset. Next, press the RES resume button on the left side of the multifunction steering wheel to confirm the successful reset of the trip meter.
5
1
Share

How to Resolve Corolla Hybrid System Malfunction?

If the vehicle has a malfunction, simply clearing the fault codes cannot completely resolve the issue. Do not be misled by the dealership staff. It is recommended to first request the dealership to inspect the cause of the vehicle malfunction and ensure that a corresponding work order is issued for each inspection. If the dealership still cannot identify the cause of the malfunction or handles it by merely clearing the fault codes, you may refer to the relevant automotive three-guarantee regulations for further action.
15
3
Share

How to Connect Bluetooth for Music in Volkswagen Passat?

Enable the Bluetooth function on both your phone and the car's Bluetooth device. Set your phone's Bluetooth to "Visible to All", "Discoverable", or "Open for Detection" in the Bluetooth settings. Press the PHONE button on the Passat's Bluetooth interface, then select Pair. Open your phone's Bluetooth search and start scanning. When you see a name starting with "VW", click to pair and connect. Then open your phone's music player and start playing music.
20
3
Share

How to Modify the Exterior of the Haval H6 Third Generation to Look Good?

For exterior modifications, you can decorate with stickers or purchase some chrome trims online. However, try not to make the modifications too extensive, otherwise, it may not pass the annual inspection. There is a limit to this. Not only is it not recommended to change the vehicle's exterior excessively, but it also won't pass the annual inspection.
6
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.