How to Use a Cadillac Dash Cam?

1 Answers
OLeila
07/29/25 4:03pm
Here are the precautions for using a Cadillac dash cam: 1. Do not route the wiring in areas with airbags to avoid interfering with their deployment or causing injury due to high-speed airbag inflation. 2. Connect the wire from the upper edge of the front windshield to the exterior trim panel of the A-pillar, pass it through the sealing strip on the side of the center console, and route it from under the glove compartment to the cigarette lighter, or from the lower edge of the door frame to the rear door or trunk. 3. The manufacturer provides several options or different lengths of original wiring. Starting from one end of the recorder, you can leave excess wiring at the other end for easier securing and concealment. However, avoid routing the wiring through the seat's sliding track, as it may get crushed or damaged when adjusting the seat.
Was this review help?
17
2
Share
More Forum Discussions

Why is U-turn prohibited at railway crossings?

Reasons for prohibiting U-turns at railway crossings: Making a U-turn at a railway crossing can easily cause traffic accidents. According to relevant regulations, motor vehicles are not allowed to make U-turns at locations with no U-turn or no left-turn signs or markings, as well as at railway crossings, pedestrian crossings, bridges, sharp curves, steep slopes, tunnels, or other dangerous sections of the road. Motor vehicles can make U-turns at locations without no U-turn or no left-turn signs or markings, but they must not obstruct the passage of other normally moving vehicles and pedestrians; at locations where U-turns are permitted and special U-turn traffic lights are installed, U-turns should be made during the green light. If there are no U-turn traffic lights but there are corresponding signs indicating U-turns during red or green lights, the U-turn should be made following the instructions of the signs.
20
5
Share

Should I Use Putty or Bondo for Cars?

It is recommended to use putty for cars. Putty consists of A epoxy resin and B polyamide hardener. A common hardening method is to add more hardener when kneading the putty. The chemical method involves using ethylene glycol and acetic acid, but this only theoretically accelerates the curing process of this type of AB epoxy resin. Both putty and bondo are used for repairing models, as well as for creating modifications and custom parts. Before drying, they are used to adhere to the model. Once dried, they become hard. However, bondo is toxic, so it is not recommended unless absolutely necessary. Even when used, it should only be operated in a well-ventilated area while wearing a gas mask.
17
0
Share

What are the methods to remove fog inside the car?

The methods to remove fog inside the car are: 1. Open windows for air convection. If the fog inside the car is not heavy, you can slightly open both side windows to create air convection between the inside and outside of the car, reducing the temperature difference and gradually eliminating the fog; 2. Use defogging spray. Spray the defogging agent on the inner surface of the car windows and wipe it clean. This not only removes dirt from the glass but also forms a protective film to prevent the formation of fog caused by condensation of moisture on the glass; 3. Use the air conditioning system. There are air vents under the front windshield of the car. Simply adjust the air conditioning to the appropriate setting to use the air blown by the air conditioning to remove fog. Using warm air to blow the glass is more effective than using cold air. Initially, the fog inside the car may become heavier due to the increased temperature difference between the inside and outside of the car, but once the warm air dries the moisture inside the car, the fog will disappear.
9
4
Share

How to use the Prado 4WD system?

Prado 4WD operation method: The Prado features full-time four-wheel drive. Only older models require using the small gear lever on the right side to switch between high-range (H) and low-range (L) 4WD. Normally, it remains in H (high-range) position. When driving on muddy roads or mountain paths, shift the transmission to neutral, then press the brake pedal and move the small right-hand lever to L (low-range) position. If wheel slippage occurs, engage the differential lock button. The Prado is a model under FAW Toyota, with body dimensions of 4760mm in length, 1885mm in width, and 1845mm in height. As part of Toyota's Land Cruiser series, the Prado delivers excellent power performance meeting Euro III emission standards. Its advanced engine provides strong output power and torque, combined with a highly rigid frame and reinforced suspension system, making rough journeys comfortable and smooth.
11
4
Share

How to Turn on the Air Conditioning in a Chevrolet?

Taking the Chevrolet Cruze as an example, here's how to turn on the air conditioning: 1. Press the AUTO button to automatically adjust air distribution and fan speed, with activation indicated by the LED light on the button; 2. Press the AC button to activate cooling and defogging functions, with activation indicated by the LED light on the right knob; 3. Rotate the right knob to set the desired temperature. The Chevrolet Cruze has body dimensions of 4666mm in length, 1807mm in width, and 1460mm in height, with a wheelbase of 2700mm. The Cruze offers six exterior colors: Aurora White, Obsidian Black, Cold Platinum Silver, Glacier Blue, Titanium Gray, and Blazing Red, along with four interior color schemes: Starry Deep Gray, Brocade Deep Gray, Elegant Gray-Black, and Saddle Brown.
1
3
Share

Which province does the license plate 'Qing' represent?

Currently, there is no license plate 'Qing', but there is a license plate 'Qing' which represents Qinghai Province. The license plate codes for various regions in Qinghai Province are: Qing A - Xining, Qing B - Haidong Region, Qing C - Haibei Tibetan Autonomous Prefecture, Qing D - Huangnan Tibetan Autonomous Prefecture, Qing E - Hainan Tibetan Autonomous Prefecture, Qing F - Golog Tibetan Autonomous Prefecture, Qing G - Yushu Tibetan Autonomous Prefecture, Qing H - Haixi Mongol and Tibetan Autonomous Prefecture. License plates, commonly known as car plates, are panels hung on the front and rear of vehicles, usually made of aluminum, sheet metal, plastic, or paper, engraved with the vehicle's registration number, registration region, or other relevant information. License plates serve as a numbering and information registration system for vehicles, primarily allowing identification of the vehicle's region of registration and enabling the tracing of the vehicle's owner and registration details through the plate.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.