How to Turn On the Rear Overhead Air Conditioning in the Land Cruiser?

How to Clean the Front Windshield Drainage Trough of a Car?

Open the engine hood and locate the front windshield drainage trough, which is below the wiper linkage. Use a 14# tool to remove them and take off the wipers. Remove the triangular deflector plates indicated by the arrows, one on each side. Pull out the windshield washer hose from the windshield drainage trough, and use a plastic pry tool to remove the four plastic clips. Then, take off the front windshield drainage trough. Rinse the removed drainage trough with water and reassemble all the components.

1

Share

How to Overtake in Subject Three?

After hearing the voice prompt to overtake, turn on the left turn signal, maintain it for three seconds, slow down, and confirm safety. You may honk to signal the overtaking intention to the vehicle being overtaken, and observe the traffic conditions behind and to the left through the rearview mirror. After the vehicle ahead yields, maintain a safe distance from the vehicle being overtaken, downshift, and then accelerate to overtake from the left. After completing the overtaking, turn on the right turn signal, return to the original lane without affecting the vehicle being overtaken, and turn off the turn signal. Pay attention to whether the vehicle being overtaken consciously gives way, accurately grasp the timing of overtaking, and also pay attention to the road conditions ahead of the vehicle being overtaken to ensure safe overtaking.

14

2

Share

How to Operate the Rearview Mirror Button Switch?

Locate the rearview mirror button, which is generally positioned on both the left and right sides of the car's front and inside the vehicle. Move it to the L position and rotate left or right to adjust the left rearview mirror. Move it to the R position and rotate left or right to adjust the right rearview mirror. Moving it to the 0 position will disable the adjustment. Once the position is set, it expands the driver's field of vision, reflecting the rear, side, and lower parts of the vehicle to ensure safe driving.

7

0

Share

Where to Check the Electronic Insurance Policy for a Car?

Find the official website of the insurance company you use. Open the official website of the insurance company and locate "Auto Insurance" on the insurance products page. Click on "Auto Insurance Services" to enter the auto insurance service page, then click "Query Policy Information," which will automatically redirect to the login interface. On the login interface, enter information such as the license plate number, ID card number, and mobile verification code to verify the identity of the login user and proceed. On the "My Policy" page, you can view the information of the insured auto insurance policy.

5

3

Share

How to Prevent Car from Sun Exposure

Car sunshades can effectively protect the vehicle from the impact of sun exposure. For the front windshield, using a dedicated front windshield sunshade is sufficient. Try to park the car in a garage or in shaded areas such as under buildings or trees. Choosing a full-car heat-insulating window film can provide relatively good heat insulation. It is best to have the film installed at a reputable car beauty shop for better quality. Car covers also offer some sun protection and can prevent dust. Opt for thicker ones to extend their lifespan. Choose a cover that fits your car model.

10

0

Share

How to Remove the Speed Limit on Xinlei 48V

Locate the power switch of the Xinlei 48V and check if the power is on. Do not turn on the power. Hold the brake lever and turn the throttle to the maximum. Turn on the power while holding the brake lever and rotate the throttle to the maximum three times consecutively. On the third time, keep the throttle turned to the maximum for 5 to 8 seconds. The speed limit wire of the electric vehicle is generally located on the controller under the seat. Next to the controller, there is a single white power wire, which is a standalone wire. Cut this white wire. With the power lock off, hold the brake lever and turn the throttle to the maximum. Turn on the power lock, keep the throttle and brake engaged for 3-5 seconds to enter full-speed mode.

18

3

Share

How to Turn On the Rear Overhead Air Conditioning in the Land Cruiser?

How to Clean the Front Windshield Drainage Trough of a Car?

How to Overtake in Subject Three?

How to Operate the Rearview Mirror Button Switch?

Where to Check the Electronic Insurance Policy for a Car?

How to Prevent Car from Sun Exposure

How to Remove the Speed Limit on Xinlei 48V

How to Adjust the Brightness of the Mercedes-Benz GLC Infotainment Screen?

What to Do When the Car Key Can't Unlock the Door?

How to Install All-Season Seat Covers?

How to Turn on the Air Conditioning on the Highway?