How to Turn on the High Beam of Lynk & Co 06
3 Answers
The vehicle's light switch includes lever-type and rotary knob-type switches, with the lever-type being the primary one. To activate the high beam, gently press the lever downward. Rotate the light control handle to the high beam position to illuminate it. Whether it's a lever-type or rotary knob-type light switch, the high beam is activated by moving the lever.
When I first bought the Lynk & Co 06, it took me several tries to figure out how to turn on the high beams. Initially, I fumbled around the lever on the left rear side of the steering wheel—it was there, a bit small but had a nice feel to it. First step, you need to turn on the headlights—after starting the car by turning the ignition key, rotate the light switch to the low beam position, which is clearly marked on the control panel. Then, when high beams are needed, just gently push the lever forward to switch over; pull it back to return to low beams. I also tested it out by turning them on in an empty lot before heading out at night, to avoid confusion on the road. It's best not to use them when meeting other cars or near pedestrians to avoid blinding them. If the car has an automatic high beam feature, check the settings first to see how to enable it, saving yourself the hassle. Remember to check the lights regularly to prevent malfunctions that could affect safety.
I've repaired thousands of cars, and the high beam setting on the Lynk & Co 06 is super simple. The control lever is located below the left side of the steering wheel, easily within reach. Before activating the high beams, make sure your low beams are on; just push the lever forward to engage, and pull it back to turn off. Don't underestimate this action—it's easy to push the wrong direction when unfamiliar, but the system will automatically reset as protection if you make a mistake. Always check the filaments and wiring harness when turning on the lights. If there's an issue with illumination, start by inspecting the fuses. Regularly replacing bulbs can prevent problems while driving. Safety comes first—use high beams only on rural roads or highways, otherwise it's both illegal and dangerous.
