How to Turn on the Heater in Trumpchi GS8?
3 Answers
Trumpchi GS8's heater usage method is as follows: 1. After starting the car, it is not advisable to turn on the heater immediately. Wait for about 3-5 minutes until the water temperature rises to the normal level, i.e., when the water temperature reaches the middle, then turn on the heater. 2. There is no need to turn on the air conditioning (i.e., the AC cooling switch) because the heater utilizes the car's own heat cycle, which saves fuel. 3. Set the air conditioning circulation mode to the internal circulation mode to help the car interior heat up quickly. Then, switch to external circulation as needed to facilitate air circulation inside the car. When the engine is running, incomplete fuel combustion will produce high concentrations of carbon monoxide.
Operating the heater in the GAC GS8 is quite straightforward, and I often do this in winter. First, start the vehicle and let the engine run for a few minutes to warm up, as the heater relies on engine heat transfer. Then, locate the air conditioning control panel on the center console and press the power button to activate the AC system. Turn the temperature adjustment knob to the high-temperature zone, such as 28°C or above. If you have automatic climate control, simply rotate the knob to set the desired temperature. Next, select an air outlet mode—I prefer the foot or windshield mode, especially in winter for effective defogging. Adjust the fan speed to increase airflow, but avoid setting it to the highest immediately after a cold start; waiting about half a minute will feel more comfortable. Remember, the heater doesn’t consume extra fuel since it uses engine waste heat, but insufficient engine warm-up before starting may result in cold air. I recommend preheating for 1-2 minutes before turning it on. Regularly checking the coolant level is also crucial to avoid heater inefficiency. A handy trick I use is turning off the recirculation mode in traffic to save fuel. In short, a few taps on the control panel get the job done—safe and hassle-free.
I've driven the GAC GS8 a few times, and the heating system is quite user-friendly. After starting the car, wait for the engine temperature to rise before operating the air conditioning. Press the AC button, usually the center button on the panel knob, then turn the temperature setting to high—the red zone indicates heating. Select the airflow direction, such as defrosting the windshield or blowing at the feet, and adjust the fan speed gradually using the increase button. Why wait for the engine to warm up? Because the heater core relies on hot water circulation, and a cold start won’t produce warm air. Here’s a fuel-saving tip: Heating itself doesn’t consume extra fuel, but turning on the A/C compressor does—turning it off in dry weather can save fuel. If the heating isn’t warm enough, it might be due to low coolant or air in the system; a simple coolant level check can help. For safety, use the defrost mode more often in winter to avoid foggy windows. The whole process takes less than a minute, making daily driving effortless.
