How to Turn on the Heater in GAC Trumpchi GS4?
3 Answers
Method to turn on the heater in GAC Trumpchi GS4: First, press the AUTO button to activate the car's air conditioning system, then adjust the fan speed, and press the temperature increase button to turn on the heater. After preheating for 3 to 5 minutes, observe the temperature gauge needle reaching the middle value before turning on the air conditioning. Avoid stepping on the accelerator immediately after starting the engine, as this will increase the engine load and affect the car's lifespan. The GAC Trumpchi GS4 is positioned as an international new-generation SUV, equipped with a plug-in hybrid system composed of a 1.5L Atkinson cycle engine and a GMC electric coupling system. In terms of body size, the GAC Trumpchi GS4 measures 4510mm in length, 1852mm in width, and 1708mm in height.
Last time I drove the GAC Trumpchi GS4, turning on the heater was quite convenient. First, start the engine and wait a bit until the temperature gauge rises to the middle position, indicating the engine is warm. Then, look at the air conditioning panel, usually located in the center console area, find the temperature knob, and turn it to the red or high-temperature section, such as setting it to the highest. Press the fan button to turn on the airflow and adjust the fan speed to your preference. Don't forget to adjust the air direction knob to blow towards the windshield or foot area to prevent fogging. If it's an automatic air conditioning system, simply press the AUTO button, and it will automatically adjust the airflow. In cold weather, it's recommended to preheat the engine for a few minutes before turning on the heater, as this allows the warm air to come out faster and doesn't harm the engine. Additionally, regularly replace the air conditioning filter; I check it every six months to remove odors and maintain fresh air. Avoid operating the controls while driving; adjust them only after parking safely.
As a GAC GS4 owner, I also figured out the heating system when I first got the car. Start the engine, wait until the dashboard water temperature gauge shows normal readings. The climate control panel is located near the steering wheel - look for the round knob and turn it clockwise toward the warm setting (usually marked with higher temperature indicators). Press the fan button to activate airflow, then use the +/- buttons to set medium fan speed. Adjust the air vent selector to your preferred position (like face or foot level). For automatic climate control, simply press AUTO and set your desired temperature. Note: The heater won't produce warm air immediately when the engine is cold - be patient for a few minutes. Pro tip: Avoid high fan speed right after cold starts in winter as cold air may blow out first. Maintenance-wise, regularly clean air vents to prevent dust accumulation and maintain long-term heating efficiency.