How to Turn on the Heater in a Geely Boyue in Winter?
3 Answers
To turn on the heater in a Geely Boyue during winter, locate the heater switch near the air conditioning control button's recirculation knob. Heating should be initiated after the car has been running for approximately 8-15 minutes, once the water temperature has risen to the normal operating level. At this point, you can activate the heater. Adjust the air conditioning's circulation mode to internal recirculation, and then use the temperature control to increase the temperature. Below are some relevant details about the car's heating system: 1. Switch to the heating mode, which may be indicated by a red zone or a sun symbol in some vehicles. Do not turn on the air conditioning (do not activate the AC switch) because the heater utilizes the car's own heat cycle, saving energy. 2. There is no need to turn on the A/C when using the heater in winter, as the car's heating system does not rely on the compressor. Instead, it uses the coolant and the heater core to provide warmth. Activating the A/C forces the system to cool, which unnecessarily increases wear and fuel consumption.
When I first started driving the Geely Boyue, using the heater in winter was actually quite simple. After getting in the car, don’t rush to turn on the AC—start the engine and let it run for a minute or two to warm up first, since the heater relies on the engine’s heat. Then, once inside, turn the temperature knob on the AC control panel toward the red zone to increase the heat—I usually set it around 25°C. Press the fan button at the same time, starting with a low airflow to avoid blasting uncomfortably hot air right away. If the car has an automatic AC function, just press AUTO for convenience—it will adjust the temperature and airflow automatically. Remember to turn on the recirculation button in winter to keep the warm air circulating inside the cabin instead of letting cold air in. Also, since the windshield tends to fog up, switch to defrost mode after running the heater for a while to clear the windshield for better visibility. Regularly check the cabin air filter to ensure it’s not clogged, as a blocked filter can reduce heating efficiency and waste fuel. These small tricks keep me warm and cozy while saving a bit of money.
I have a lot of experience with this issue. When driving the Boyue, there are indeed some tricks to using the heater in winter. First, start the engine as soon as you get in the car, but don’t rush to drive off. Wait 30-40 seconds for the engine coolant temperature gauge to rise a bit before setting off—only then will the heater truly warm up. Next, find the temperature adjustment knob on the AC panel, usually marked with red and blue, and turn it to the red zone to set the temperature high. For the fan speed, I prefer starting at the lowest setting and gradually increasing to medium—too strong a blast can be uncomfortable. If it’s an automatic AC version, I usually just set the temperature above 24°C, and the system will automatically control the airflow and temperature distribution, which is very convenient. In winter, remember to turn on the recirculation mode to prevent heat from escaping, while also keeping an eye on the windows to avoid fogging. Using the heater increases engine load and fuel consumption, so it’s fine to skip it for short trips, but for long drives, it’s best to keep it on to maintain a stable cabin temperature and avoid catching a cold. Regularly check the AC lines at a service shop to ensure there are no leaks, guaranteeing efficient heat output. This method has worked well for me over the years—safe, comfortable, and hassle-free.
