How to turn on the fog lights on the Tiguan L?

2 Answers
CassidyAnn
07/25/25 12:34pm
First, turn on the lights, and rotate the light lever to any position. Then, pull it outward once for the front fog lights, and pull it outward again for the rear fog lights. Here is more information about fog lights: 1. Fog lights generally refer to automotive fog lights. Automotive fog lights are installed on the front and rear of the car to illuminate the road and provide safety warnings during rainy or foggy weather, improving visibility for the driver and other traffic participants. 2. Fog lights are divided into front fog lights and rear fog lights. Front fog lights are usually bright yellow, while rear fog lights are red. The symbol for the rear fog light is slightly different from that of the front fog light. The front fog light symbol has downward light lines, while the rear fog light symbol has parallel lines, typically located on the dashboard inside the car. 3. Due to their high brightness and strong penetration, fog lights do not produce diffuse reflection caused by fog, so correct usage can effectively prevent accidents. In foggy weather, both front and rear fog lights are usually used together.
Was this review help?
9
2
Share
HopeRose
08/11/25 8:24pm
Turning on the fog lights of the Tiguan L is quite simple, something I learned from my own driving experience, as I often encounter foggy weather while driving. First, ensure that the headlights are already on, usually by turning the knob to the Auto or Low Beam position, which is located on the left-hand stalk near the steering wheel. Next, locate the fog light switch. The fog light control for the Tiguan L is typically on the same stalk, activated by rotating the outer knob to turn on the front fog lights. Some versions may require pressing a button on the knob. Once activated, a small indicator light on the dashboard will illuminate, confirming that the fog lights are on. Remember, fog lights should only be used in conditions of heavy fog, heavy rain, or low visibility, as they can otherwise be glaring and affect other drivers, as well as drain the car battery. It’s a good habit to check if the switch is reset before each drive. I’ve personally experienced the fog light switch getting stuck, so regularly wiping the control panel can prevent poor contact issues. Overall, the operation is quite intuitive, and beginners can quickly get the hang of it once they familiarize themselves with the controls—the key is safe and compliant driving.
Was this review help?
8
3
Share
Expand All
More Forum Discussions

What to Do When the Wheel is Locked?

Solutions for a locked wheel are as follows: 1. Contact a locksmith or a 4S store for unlocking. 2. Remove the tire and replace it with a spare. 3. If the car is maliciously locked, keep evidence and seek police assistance. Additional information: The wheel lock is made of full steel plate, featuring anti-violence, anti-technical opening, anti-wheel removal, anti-key duplication, and many other characteristics. It can conveniently and firmly lock the illegal tire, effectively preventing the illegal vehicle from evading punishment. At the same time, it is easy to operate, and one person can independently handle it, providing great convenience for the law enforcement of management departments.
1
2
Share

What Causes Abnormal Noise in the Fuel Pump?

The fuel pump is a component of the fuel injection system in electronic fuel injection vehicles, installed inside the fuel tank. Its main function is to draw fuel from the tank, pressurize it, and then deliver it to the fuel supply line. Abnormal noise in the fuel pump may be caused by the following reasons: 1. Damage to the fuel pump check valve: results in no residual pressure, making it difficult to start. 2. Wear of the centrifugal pump impeller: leads to reduced fuel supply pressure and weak acceleration. 3. Wear of the carbon brushes: causes the fuel pump to stop, preventing the vehicle from starting. 4. Mechanical failures such as rotor jamming: increases the working current of the pump, potentially damaging the relay or fuse.
5
2
Share

How Many Kilometers Should the Transmission Fluid Be Changed for a New Car?

In general, the automatic transmission fluid (ATF) in a car should be changed every two years or every 40,000 kilometers. Here is a detailed introduction to car transmissions: 1. Introduction: A device that changes the speed ratio and direction of motion. It is used in cars, tractors, ships, machine tools, and various machines to alter the torque, speed, and direction of motion transmitted from the driving shaft to the driven shaft under different working conditions. A gear-driven transmission generally consists of a housing and several gear pairs. 2. Function: While driving, to adapt to different working conditions, the car's driving force and speed need to vary within a certain range. However, the existing engine's torque and speed variation range cannot meet this requirement, hence the need for a transmission.
9
2
Share

What does ETC displayed on the car mean?

The ETC on the car refers to a vehicle equipped with an ETC on-board unit. Here is relevant information: ETC stands for Electronic Toll Collection in Chinese, which is a microwave-dedicated short-range communication between the on-board electronic tag installed on the vehicle's windshield and the microwave antenna on the ETC lane at the toll station. The benefits of installing ETC are: 1. Time-saving and convenient, as it eliminates the need to queue at toll stations, reducing waiting time on the road. 2. Labor-saving, as using ETC provides discounts on highway tolls and reduces the need for manual labor. ETC is an electronic automatic toll collection system for roads, bridges, and tunnels that is being actively developed and promoted internationally.
8
3
Share

Can I sign the driving test (Subject 3) later?

Subject 3 can be signed later. If you just left the examination room and remembered that you forgot to sign, you can generally go back and sign. If you remember it long after the test, you can also explain to the staff at the test center or ask your instructor for help. Under normal circumstances, the staff can sign it for you. Signing after Subject 3 test: Signing on the test score sheet does not mean passing the test, but theoretically, whether you pass or not, you need to receive the score sheet and sign it. However, in actual operation, many students do not go to receive the score sheet and sign it because they know they did not pass the test, and they leave the examination room directly.
10
2
Share

What is the relationship between Seres and Huawei?

Partnership. Here are the details: 1. Ecosystem Integration: The collaboration between Seres and Huawei extends beyond technical aspects to mutual ecosystem integration, focusing on technology, channels, and products to deeply advance cooperation in the smart terminal field and jointly create high-performance, intelligent mobility solutions. 2. Role of the Partnership: Huawei has evolved from helping automakers build better cars to assisting companies in selling them effectively. Leveraging its experience in high-end brand operations, marketing, and sales networks accumulated in the consumer electronics industry, Huawei has engaged in deep channel collaboration with Seres, empowering each other. This partnership also marks the world's first instance of channel interoperability between a technology brand and a smart car brand, fully ushering in the era of automotive new retail 3.0.
6
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.