How to Turn on the Fog Lights of the Volkswagen Tharu?

1 Answers
LeAdelyn
07/30/25 3:30am
To turn on the fog lights of the Volkswagen Tharu, follow these steps: The switch is located below the left side of the steering wheel. First, turn on the headlight switch, then pull the knob outward. Pulling it once activates the front fog lights, and pulling it again activates the rear fog lights. Functions of fog lights: 1. Front fog lights are used to improve illumination when road conditions ahead are unclear, serving to alert oncoming drivers; 2. Rear fog lights help vehicles behind to spot your car in low-visibility conditions. The Tharu features a MacPherson strut front suspension and a multi-link independent rear suspension. In terms of configuration, the Tharu comes standard with a tire pressure monitoring system, front and rear parking radar, drive mode switching, auto hold, and other features.
Was this review help?
13
0
Share
More Forum Discussions

What are the differences between the 2013 Touran and the 2015 model?

The biggest difference between the 2013 Touran and the 2015 model is the addition of two new body colors. In terms of configuration, the 2015 model features new LED daytime running lights. Below are the detailed descriptions of the 2015 Touran's gear positions: 1. P (Parking Gear): The transmission locking mechanism activates in this position, so it should only be engaged when the vehicle is completely stationary. 2. R (Reverse Gear): Engage this gear when reversing the vehicle. Note that the vehicle must be stationary before shifting into reverse. 3. N (Neutral Gear): Typically used for short stops, with the engine idling. 4. D (Drive Gear): The automatic transmission operates automatically during driving, and the driver only needs to control acceleration and deceleration. 5. S (Sport Gear): In Sport mode (S gear), the transmission can shift freely. The gear lever can be pushed directly into S while the car is moving, usually used for climbing hills and overtaking.
20
4
Share

What is the introduction to license plate numbers in various regions of Hunan?

Hunan license plate number introduction: A Changsha City, B Zhuzhou City, C Xiangtan City, D Hengyang City, E Shaoyang City, F Yueyang City, G Zhangjiajie City, H Yiyang City, J Changde City, K Loudi City, L Chenzhou City, M Yongzhou City, N Huaihua City, U Xiangxi Tujia and Miao Autonomous Prefecture. The following is the relevant introduction about license plates: 1. Function: Through the license plate, the region to which the vehicle belongs can be known, and the owner of the vehicle and the registration information of the vehicle can also be found based on the license plate. 2. License plate authority code: The first character of the license plate is a Chinese character, and the second is an English letter. When arranging the English letter codes for prefecture-level administrative regions, I and O are skipped, and O is often used for police cars or government units.
10
0
Share

How to Troubleshoot Abnormal Noise from the Chassis?

Abnormal noise from the chassis can affect the vehicle's operation, requiring a detailed inspection to identify and resolve the issue. Below are common causes of chassis noise: 1. Loose components: Due to severe impacts, parts may interfere with each other. This can be resolved by reshaping or replacing the affected components to eliminate interference. 2. Loose bolts or nuts: Prolonged driving on rough roads or improper disassembly may cause bolts to loosen or become damaged. Tighten or replace the bolts as necessary. 3. Abnormal noise caused by damaged ball joints, suspension, or brackets: Over time, ball joints may become loose, and rubber bushings may wear out, leading to noise. In such cases, replacing the ball joints or brackets is required.
3
2
Share

How often is the trip mileage reset?

Trip mileage does not reset automatically, but it will be reset when the battery is disconnected. Here are specific details about trip mileage: 1. Definition: The trip mileage in a car can be used to record the distance traveled for each trip, representing the mileage before the next reset. The 'trip' displayed on the car dashboard refers to the trip mileage. To restart recording the mileage, you can press and hold the reset button. 2. Fuel consumption calculation: Trip mileage can help calculate the amount of fuel consumed during a trip. It can be used to measure fuel consumption at different speeds. After familiarizing yourself with the trip mileage data, you can estimate how much farther the remaining fuel can take you based on the trip mileage figures.
2
4
Share

Can Carbonated Drinks Be Stored in the Trunk During Summer?

Carbonated drinks should not be stored in the trunk during summer. Here are the specific reasons: 1. Hazards: High temperatures can cause explosions, posing a danger. Perfume should also not be left in the car. Plastic containers holding liquid gases with a volume exceeding 40 milliliters can explode when the gas expands due to heat, causing the plastic shell to rupture. The vaporized gas from perfume is also flammable, and the area where perfume is placed on the dashboard has the highest gas concentration, which is directly exposed to sunlight. When the temperature reaches a certain level, it can easily cause an explosion. 2. Other items: Small items such as lighters, perfume bottles, cigarette lighters, etc., should not be left in the car either.
14
0
Share

How Many Cylinders Does an F1 Engine Have?

F1 racing cars typically use engines with fewer than 12 cylinders and a displacement of 3L. Below is a related introduction: 1. F1 Racing Regulations: FISA requires F1 cars to use naturally aspirated engines with a displacement of 3L, fewer than 12 cylinders, and no superchargers. The chassis of an F1 car is made of carbon fiber, which is very light and strong. The chassis is very low, with a minimum ground clearance of only 50-70 mm. F1 cars have many unique features: their bodies are slender and low, with wide wheels that are highly noticeable and fully exposed, known as "open wheels." 2. The Origin and Development of F1 Racing: The first Formula One (F1) race was held in 1950. After more than 50 years of development, the FIA's regulations for racing cars have long gone beyond simple requirements for engine displacement. Racing cars must be designed and manufactured according to the technical rules set by the FIA, including all technical parameters such as body dimensions, weight, engine displacement, maximum power, whether a supercharger is used, and tire tread and size. Simply put, they are produced according to a formula (not a mathematical equation), hence the name Formula One racing cars.
3
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.