How to Turn on the Fog Lights of the New Sylphy?

2 Answers
VonHolden
07/25/25 12:00am
The steps to turn on the fog lights of the New Sylphy are as follows: First, turn on the headlight switch, ensuring it is not in the OFF position. Then, rotate the lever to the fog light position. The first gear is for the front fog lights, and the second is for both front and rear fog lights. Below are detailed descriptions about fog lights: 1. Fog lights are divided into front fog lights and rear fog lights. Front fog lights are usually bright yellow, while rear fog lights are red. 2. The symbol for the rear fog light is slightly different from that of the front fog light. The front fog light symbol has downward light lines, whereas the rear fog light symbol has parallel light lines, generally located on the dashboard inside the car. 3. Due to their high brightness and strong penetration, fog lights do not cause diffuse reflection from fog. Proper use can effectively prevent accidents. 4. In foggy weather, front and rear fog lights are usually used together. Yellow is the purest color, and the car's yellow fog lights can penetrate thick fog and illuminate far distances.
Was this review help?
12
1
Share
McSawyer
08/10/25 3:36pm
After driving for so many years, I've found that the steps to turn on the fog lights are actually quite intuitive. In the new Sylphy, you'll first need to start the engine, then make sure the headlights are on (usually by switching to auto or manual light position). Next, locate the control stalk on the left side of the steering wheel, which will be marked with a fog light icon. Gently rotate that knob or press the button, and the front fog lights will illuminate with an indicator to confirm activation. These should only be used in low visibility conditions like fog, heavy rain, or snow - they significantly improve forward visibility and help prevent accidents. Don't use them for fun during normal conditions as their high brightness can dazzle other drivers. Remember that rear fog lights have separate controls, typically differentiated on the same stalk. Developing safe habits is what matters most.
Was this review help?
17
3
Share
Expand All
More Forum Discussions

Why Does a Manual Transmission Car Jerk When Starting?

Manual transmission cars may jerk when starting due to the following reasons: Improper operation: The jerking sensation during startup could be caused by improper operation. Many people experience a couple of jerks when releasing the clutch after engaging the gear. The most direct reasons are releasing the clutch too quickly or not matching it with the throttle. Spark plugs overdue for replacement: Jerking might also occur if the spark plugs are not igniting smoothly. Spark plugs generally need to be replaced every 20,000 to 40,000 kilometers. Transmission clutch slipping: Slipping of the transmission clutch can also cause jerking during startup. Check if there is a burnt smell or excessive dirt in the transmission, and replace the transmission fluid if necessary.
2
5
Share

Can halogen headlights be replaced after three years of use?

Halogen headlights can be replaced after 3 years of use. Service life: Ordinary halogen car headlights typically have a service life of only 500 hours. Replacement cycle: With an average daily usage of 2.5 hours, the replacement cycle for headlights is 200 days. Headlights don't necessarily need to be replaced only when they stop working; they should be replaced when the brightness becomes insufficient or dim. Replacement recommendations: More expensive headlights aren't always better. You should choose models suitable for your vehicle. Additionally, xenon headlight modifications have strict requirements for the lighting system wiring. Poor-quality headlights have a short lifespan and cannot guarantee stable quality. High-quality headlights offer good light distribution and high brightness, while inferior ones lack sufficient brightness, poor focus, and short projection distance.
19
1
Share

What is the principle of steering when reversing a car?

The steering principle when reversing a car is that the direction in which the steering wheel is turned is the same as the direction in which the tires turn. Below is relevant information about reversing: Precautions: Whether you're a novice or an experienced driver reversing, this is a crucial point to note. Not only should you avoid pressing the accelerator while reversing, but you should also avoid half-pressing the brake. Especially for novices, reversing should be done at a speed slower than idle speed. This allows more time to observe the surrounding environment. Basic essentials: When parking in a parking lot, first, visually estimate the width of the parking space, check for any obstacles behind, whether there are vehicles parked on either side, and whether the length is suitable for your vehicle model. If visibility is poor at night, get out and observe the exact position before reversing.
8
0
Share

When to Use Hill Descent Control?

Hill Descent Control should be used in the following situations: 1. When driving on steep slopes; 2. When driving on long downhill sections; 3. When navigating mountain switchbacks. Also known as a slope control system, Hill Descent Control allows drivers to smoothly descend steep slopes without needing to press the brake pedal. The system automatically applies braking to individual wheels as needed, maintaining a speed slightly faster than walking pace while allowing the driver to focus entirely on steering. The function of Hill Descent Control is to enhance vehicle controllability on steep slopes by applying temporary braking force to the front axle, compensating for engine braking.
14
0
Share

Is There a Labor Charge for Tire Replacement?

Is there a labor charge for tire replacement. Tire replacement cost requirements: After replacement, a wheel balance is generally required. "Tire rotation" will incur a portion of the labor charge. Prices may also vary depending on the specific region. Tire prices differ based on the brand. Preparations before tire replacement: Turn off the vehicle and engage the handbrake to prevent the car from rolling. All passengers must exit the vehicle. Cars should have their front and rear tires on the same side swapped approximately every 10,000 kilometers. Most family cars are front-wheel drive, where the front wheels are responsible for both steering and driving the entire vehicle, leading to uneven wear between the front and rear tires. Additionally, tire wear is related to the distribution of the vehicle's weight, and tire rotation greatly helps in achieving even tire wear.
19
5
Share

Can the Honda CB400 be modified into a retro style and still be registered?

Honda CB400 modified into a retro style cannot be registered, as the Honda CB400 has not been officially introduced in China and is considered a smuggled vehicle. Legal regulations on modifications: No organization or individual is permitted to engage in the following activities: assembling motor vehicles or altering the registered structure, construction, or characteristics of a vehicle without authorization. As long as the modifications do not violate the prohibited activities specified in the regulations, reasonable modifications are allowed. Smuggled vehicles: Smuggled vehicles refer to imported vehicles that have not entered through the country's normal import channels and have not paid the required taxes. Purchasing smuggled vehicles carries certain legal liabilities. The country strictly prohibits the import of used vehicles, in accordance with the "Customs Supervision Measures for Non-resident Long-term Travelers' Personal Articles for Self-use" and the "Customs Supervision Measures for Resident Institutions' Public Articles."
1
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.