How to Turn On the Cruise Control in the Envision?

What are the steps to replace a car's cabin air filter?

Steps to replace a car's cabin air filter: Open the clips on the air filter housing, remove the air filter cover, take out the air filter element, remove the filter element from the air filter, install the new air filter element into the air filter housing, and then secure the edge clips to complete the installation. The cabin air filter, commonly known as the pollen filter, is designed to filter the air entering the car's interior from the outside, improving air cleanliness. It typically filters out impurities in the air, such as tiny particles, pollen, bacteria, industrial exhaust, and dust. The cabin air filter helps prevent these substances from entering the air conditioning system, which could damage it, and provides a good air environment for passengers, protecting their health. It also helps prevent window fogging.

11

5

Share

Where to Add Windshield Washer Fluid in a Volkswagen?

The windshield washer fluid filler port for the Volkswagen Lavida is located on the right side of the engine compartment. The process for adding windshield washer fluid to a Volkswagen is as follows: 1. There is a windshield washer fluid level indicator light on the car's dashboard. If the windshield washer fluid runs out while driving, this light will start flashing, indicating that it's time to add more. 2. To add windshield washer fluid, first open the front hood. The hood release is usually located under the dashboard in front of the driver's seat. Simply pull the release gently to open the hood. 3. After opening the hood, locate the washer fluid reservoir. The cap of the reservoir has the same symbol as the indicator light. Open the cap and add the windshield washer fluid, being careful not to exceed the marked level on the reservoir.

10

0

Share

How to Report Modified Daytime Running Lights to the Vehicle Management Office?

To report modified daytime running lights, go directly to the vehicle management office and explain the situation to the relevant staff. You can then complete the necessary procedures, including annotating the changes in the motor vehicle registration certificate, retrieving the old driving license, and issuing a new one. Below is additional information: 1. If the modification of daytime running lights is not approved by the traffic management department in advance, the vehicle will not pass the annual inspection. 2. According to the relevant provisions of the current "Motor Vehicle Registration Regulations," any changes to the body color, model, performance, purpose, or structure of a licensed motor vehicle, as well as the replacement of the frame, body, or engine, must be reported to the vehicle management office for registration changes. 3. Installing spoilers, body kits, or modifying exhaust pipes is not permitted.

18

4

Share

Are the Three Major Components of the Territory from Ford?

The three major components of the Territory are not from Ford. The Territory is equipped with a Miller-cycle Ecoboost 1.5T engine, model JX4G15C5L. It offers two transmission options: a 5-speed manual transmission and a CVT transmission, with the CVT being supplied by Punch. The front suspension of the Territory uses the common MacPherson strut setup, while the rear suspension features the classic E-type multi-link load-bearing structure. The Territory is positioned as a compact SUV, and across the lineup, it is powered by a 1.5T inline 4-cylinder turbocharged engine, delivering a maximum power of 103 kW and a maximum torque of 225 Nm.

6

4

Share

What maintenance items are required for a car at 25,000 kilometers?

Maintenance items required for a car at 25,000 kilometers: 1. Replace engine oil and oil filter, clean intake valves, check clutch pedal travel, steering lower arm ball joint clearance, fastening condition, and dust covers; 2. Check tire tread depth, tire pressure, and tire wear condition, perform wheel alignment if necessary; 3. Check whether the throttle body and idle air control valve are dirty, clean them if necessary; 4. Check spark plug condition, replace if necessary, and perform fuel injector cleaning without disassembly. It is recommended to consider cleaning engine carbon deposits, replacing the air filter, and cabin air filter to ensure proper functioning of all vehicle systems. Maintenance items at 25,000 kilometers may vary depending on the vehicle model, so the best approach is to follow the maintenance manual.

1

Share

How to adjust the time on an old Mazda 6?

The method to adjust the time on an old Mazda 6: The adjustment button is located on the left side of the car's steering wheel, marked with a clock symbol. First, press the clock adjustment button, then use the plus button on the left side of the steering wheel to adjust the time, and finally press the SET button to confirm. The dimensions of the old Mazda 6 are 4670mm in length, 1780mm in width, and 1435mm in height. The old Mazda 6 is equipped with a 2.3-liter inline four-cylinder engine, utilizing continuous timing valve control technology and variable valve timing technology (VVT). These two technologies can significantly improve engine power, output more torque and greater power, while also enhancing fuel economy and reducing exhaust emissions.

4

3

Share

How to Turn On the Cruise Control in the Envision?

What are the steps to replace a car's cabin air filter?

Where to Add Windshield Washer Fluid in a Volkswagen?

How to Report Modified Daytime Running Lights to the Vehicle Management Office?

Are the Three Major Components of the Territory from Ford?

What maintenance items are required for a car at 25,000 kilometers?

How to adjust the time on an old Mazda 6?

Where is the cabin air filter located in the older Teana models?

How to reset the tire pressure of Lavida Plus?

What are the reasons for the dash cam not displaying images?

How to Deal with Cement on a Car?