How to turn on the cold air conditioning in the BMW 320 Series?

1 Answers
AshleyRose
07/29/25 6:40pm
To turn on the cold air conditioning in the BMW 320 Series: 1. Rotate the air conditioning to cooling mode; 2. Press the AC button. Taking the 2021 BMW 320 Sport Package as an example, it belongs to the mid-size car category, with body dimensions of length 4829mm, width 1827mm, height 1463mm, a wheelbase of 2961mm, and a fuel tank capacity of 59L. The 2021 BMW 320 Sport Package is equipped with a 2.0T turbocharged engine, delivering a maximum power of 115kW at 4500 to 6500rpm, and a maximum torque of 250Nm at 1250 to 4000rpm.
Was this review help?
10
5
Share
More Forum Discussions

Why does the electric scooter's lights turn on but it doesn't move when twisting the throttle?

Here are the reasons why the electric scooter's lights turn on but it doesn't move when twisting the throttle: Blown fuse: Replace the fuse. Faulty power switch: Replace the power switch. Damaged Hall throttle: Use a multimeter to measure the DC voltage output from the green wire at the throttle output terminal. If there is a 1-4.2V output, the throttle is normal. If there is no voltage output, the throttle is burnt out and needs replacement. Damaged controller: Use a multimeter to measure the DC voltage output from the red wire at the controller output terminal (connected to the throttle wire plug). If there is approximately 5V output, the controller is normal. If there is no voltage output, the controller is burnt out and needs replacement. Burnt power cut-off switch: If all the above possibilities are ruled out, unplug the power cut-off switch connector. If the motor runs normally, replace the power cut-off switch.
19
3
Share

How many meters away from the intersection can you cross the solid line without being photographed?

The captured image size is approximately between 15-30 meters. Electronic police typically use two cameras: one panoramic camera and one capture camera, though some may not require a panoramic view (but these are rare). Only vehicles traveling at speeds around 250 km/h might avoid being photographed, or if the flash doesn't illuminate at night. In all other cases, crossing the solid line will be captured unless the equipment is damaged. Below is an introduction to traffic signals: The function of traffic signals: Traffic signals are lights that direct traffic flow, generally consisting of red, green, and yellow lights. A red light indicates prohibition of passage, a green light permits passage, and a yellow light serves as a warning. Classification of traffic signals: Traffic signals are divided into motor vehicle signals, non-motor vehicle signals, pedestrian crossing signals, directional indicator signals (arrow signals), lane signals, flashing warning signals, and signals at railway crossings.
19
3
Share

Is a 7-speed wet dual-clutch transmission a manual transmission?

7-speed wet dual-clutch transmission is an automatic transmission, also known as a manual-automatic transmission. Both manual-automatic transmissions and dual-clutch transmissions are types of automatic transmissions, representing an upgraded product for automatic vehicles, providing drivers with a more comfortable driving experience. When these two types of transmissions are used in manual mode, shifting only requires moving the transmission lever. Below is an introduction to dual-clutch transmissions: Types: Dual-clutch transmissions come in dry and wet types. Wet dual-clutch: A wet dual-clutch refers to a multi-plate clutch system where one large and one small clutch are coaxially installed together, both housed in a sealed oil chamber filled with hydraulic fluid. Therefore, the wet clutch structure offers better adjustability and excellent thermal properties, capable of transmitting higher torque. Dry dual-clutch: The dry dual-clutch was developed based on the technology of the 6-speed DQ250 wet dual-clutch, simplifying the related hydraulic systems. Structure of dual-clutch transmissions: The structure of a dual-clutch transmission is very similar to that of a manual transmission. It has two sets of clutches, each responsible for shifting between even and odd gears, significantly improving shift speed.
8
4
Share

What is the traffic police hand signal for pulling over?

The traffic police hand signal for pulling over is: extend the left arm forward and upward with the palm facing forward; extend the right arm forward and downward with the palm facing left; swing the right arm horizontally to the left, indicating that the vehicle should pull over. The pulling-over signal is based on the stop signal, where the left hand indicates stopping and the right hand indicates pulling over. Below are some parking precautions: No parking is allowed in areas with no-parking signs: No-parking signs indicate that within the specified range, all vehicles are prohibited from parking temporarily or for an extended period. No parking is allowed within yellow grid lines: Yellow grid lines indicate that parking is prohibited in this area for any reason. They are commonly found at intersections, entrances, and exits. Yellow solid lines: Roads with yellow solid lines prohibit parking. The length of the yellow solid line indicates the size of the no-parking area. No parking is allowed near bus stops: Parking is prohibited in areas such as bus stops, gas stations, emergency stations, fire hydrants, etc.
18
4
Share

Is there an examiner in the car during Subject 2?

There is no examiner in the car during Subject 2; the entire process is monitored electronically. Subject 2, also known as the small road test, is part of the motor vehicle driver's license examination and refers to the field driving skills test. For small vehicles (C1 and C2), the test items include five mandatory components: reversing into a garage, parallel parking, stopping and starting on a slope, turning at a right angle, and driving through curves (commonly known as S-turns). Below is an introduction to other test subjects: Subject 1: Also known as the Subject 1 theory test or driver theory test, it is part of the motor vehicle driver's license examination. Subject 3: Also known as the big road test, it is the road driving skills test in the motor vehicle driver's examination. Subject 4: Also known as the Subject 4 theory test or driver theory test.
20
0
Share

What are the dress code requirements for the Subject 4 exam?

Unlike Subject 2 and Subject 3 which require actual driving, the Subject 4 exam has no specific dress code requirements - normal casual wear is acceptable. However, you'll need to remove scarves, masks or other facial coverings during the facial recognition process. Here are detailed introductions about Subject 4: Concept: Subject 4 is an additional safety and civilization knowledge test following Subject 3 road test. Officially, there's no designation as 'Subject 4'. Exam format: The test consists of 50 questions presented through case studies, images, animations, etc., with a perfect score of 100 and passing mark at 90. Exam content: Main test areas include safe driving operation requirements, safety knowledge for severe weather and complex road conditions, emergency handling methods for situations like tire blowouts, and post-accident disposal procedures.
2
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.