How to Turn On the Audio When It's Off in the Envision?

What is the passenger limit for sedans?

Sedans are generally designed to seat 5 people, including the driver. Exceeding 5 people including the driver is considered overloading. Penalties for sedan overloading: For example, if the vehicle is overloaded with passengers, penalties are imposed as follows: exceeding the approved passenger capacity by less than 20% results in a fine, exceeding by 20% to less than 50% results in a fine, and exceeding by 50% or more results in a fine. Sedan overloading standards: Sedans can generally accommodate five passengers, and carrying six would constitute overloading. If the overload reaches 20%, or if cargo is carried in violation of regulations when exceeding the approved passenger capacity by 20%, corresponding fines will be imposed.

3

4

Share

How Many Pieces Are There in the Rear Brake Pads?

A set of foot brake rear brake pads consists of 4 pieces, while the hand brake has a separate set of 2 pieces. Function of Brake Pads: Brake pads, as the name suggests, are used for braking. In a car's braking system, brake pads are the most critical safety components. The effectiveness of all braking actions is decisively determined by the brake pads. Good quality brake pads act as protectors for both the driver and the vehicle. Structure of Brake Pads: Brake pads are generally composed of a steel plate, an adhesive heat insulation layer, and a friction block. The steel plate is coated to prevent rust, and the coating process is monitored using an SMT-4 oven temperature tracker to ensure the temperature distribution during coating meets quality standards. The heat insulation layer is made of non-heat-conductive materials, designed to insulate heat.

8

3

Share

What Causes Car Window Rattling Noises?

Car window rattling noises can be caused by the following reasons: 1. Aging of the window glass sealing rubber strip. Aging rubber strips are the most likely cause of window glass rattling noises. If the noise occurs in a new car, there is no need to immediately replace the rubber strip. Simply purchase a lubricant online, apply it evenly on the rubber strip, and then repeatedly raise and lower the window a few times to see if the noise diminishes. If the rubber strip is severely aged, it is best to replace it directly. 2. Debris in the window glass guide rail. The gaps in the sealing strips of the window slot can easily allow dust and particles to enter during the window raising and lowering process, which can cause rattling noises due to window glass vibration. If dust and particles accumulate over time, they can damage the lifting motor, leading to rattling noises and even affecting the window's raising and lowering function. 3. Loose screws or clips. When driving on bumpy roads, rattling noises from the car window may be caused by loose internal fastening screws or clips of the window glass, including glass fixing screws, lifting guide rail fixing screws, door trim clips, and other internal screws of the door trim.

4

5

Share

Do motorcycles need to follow directional markings?

Motorcycles are classified as motor vehicles and must follow directional markings. Motorcycle traffic regulations: Motorcycles must always keep to the right side of the road under any circumstances, as all motor vehicles are required to drive on the right side. Failing to do so would violate fundamental traffic laws. However, this right-side driving rule refers to vehicle direction and lane regulations, not permission to drive arbitrarily in the right lane. Reasons for motorcycles keeping right: Lane guidance: Urban roads typically have multiple lanes, with vehicles in the right lane generally moving at slower speeds. This arrangement enhances motorcycle safety to some extent and avoids disrupting normal traffic flow for other vehicles. Traffic flow management: Without rules, there would be chaos. Random lane usage would cause congestion, while keeping right improves traffic efficiency and strengthens management.

11

3

Share

What Causes Abnormal Engine Ignition Sounds?

Engine ignition sounds abnormal for the following reasons: Belt Slippage: When starting the car, there is a sharp squealing noise. This squealing sound is caused by belt slippage, which may be due to insufficient tension from the tensioner pulley or the belt being stretched from prolonged use, making it too loose. For a normal belt and tensioner pulley, when you twist the belt slightly with your hand, it should not twist more than 90 degrees. If the belt can be twisted over 90 degrees with little effort, it indicates that the belt or tensioner pulley is loose. Gear Grinding: When starting the car, there is a clicking or grinding noise. This sound is caused by the starter gear grinding against the engine flywheel gear. The reason is that after prolonged and frequent use, the gears on both the starter and flywheel wear down significantly, leading to misalignment and grinding sounds.

1

5

Share

Why is the transmission too hot?

The reasons for transmission overheating are as follows: 1. Dual-clutch transmissions become hot due to the continuous engagement and disengagement of clutch plates; 2. CVT transmissions overheat because of slippage in the steel belt or chain; The functions of a transmission are as follows: 1. To change the gear ratio, expanding the range of torque and speed variation in the driving wheels; 2. To adapt to constantly changing driving conditions, allowing the engine to operate under favorable circumstances; 3. To enable the vehicle to reverse while maintaining the same engine rotation direction; 4. To utilize neutral gear to interrupt power transmission, facilitating gear shifting or power output in the transmission.

7

5

Share

How to Turn On the Audio When It's Off in the Envision?

What is the passenger limit for sedans?

How Many Pieces Are There in the Rear Brake Pads?

What Causes Car Window Rattling Noises?

Do motorcycles need to follow directional markings?

What Causes Abnormal Engine Ignition Sounds?

Why is the transmission too hot?

What is the method for changing brake fluid?

What Causes a Modified One-Button Start to Fail to Ignite?

What are the symptoms of chassis abnormal noise?

What does it mean that parking is not allowed in Subject 2 test?