How to turn on the air conditioning to blow cool air in the Baojun 510?

Can ETC be installed without being placed on the glass top?

ETC can be used without being attached to the glass. Installing ETC on the upper part of the windshield is to minimize obstruction of the driver's view while ensuring better recognition by the equipment at highway toll stations. If you don't want to install it on the glass, try to place it in an open position where it can be seen through the windshield. The general installation position for ETC in small cars is in the upper middle part of the front windshield, while for large vehicles like trucks and buses, it is installed in the lower middle part. The appropriate installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with factory-installed or aftermarket explosion-proof film, which may affect microwave communication signal transmission, ETC should be installed in the microwave window strip. Here are some considerations for installing ETC: Do not obstruct the view; it's best to install it behind the rearview mirror: Many car models have windshields with a large rearward tilt angle, which reduces the driver's field of vision. If ETC is installed without considering this, it can increase the driver's blind spots. Installing it behind the rearview mirror on the right side can help avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement, as it has a solar panel on the back for self-charging. Therefore, during installation, avoid the blackened areas on the windshield and positions that may block the solar panel. Once installed, do not remove it arbitrarily: The button in the middle of the adhesive is an anti-removal lever connected to a switch. After installation, the windshield presses the anti-removal lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You would then need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device. Notes for using ETC: The ETC transaction sensing range is 8 meters. To prevent issues caused by the ETC device of the vehicle in front malfunctioning, maintain a distance of more than 10 meters from the vehicle ahead to avoid automatic toll deduction for the wrong vehicle. The ETC lane recognition speed is 20 kilometers per hour; driving too fast may result in failure to read the vehicle's device information, leading to toll deduction failure. When using a debit card linked to ETC, insufficient balance can also cause toll deduction failure.

13

0

Share

What are the reasons for the engine warning light in Ford Focus?

The engine warning light in Focus may illuminate due to the following 7 main reasons: Sensor malfunction: The sensors mentioned here include coolant temperature, crankshaft position, air flow, intake air temperature, oxygen sensors, etc. When these sensors are damaged, have poor contact, or signal interruption, the vehicle's ECU cannot accurately obtain engine data, which will trigger the engine warning light. Fuel/oil quality issues: If fuel and engine oil are not added according to the manufacturer's requirements, it may cause engine wear and trigger the warning light. Poor mixture combustion: Poor combustion can lead to engine carbon deposits or knocking. When detected by oxygen sensors and reported to the ECU, the warning light will illuminate as an alert. Spark plug failure, ignition coil failure, fuel pump failure, or fuel line blockage can all cause poor mixture combustion. Turbocharging issues: Intake turbocharging pipelines or turbochargers can also trigger the engine warning light. The most common is turbocharger damage, accompanied by symptoms like oil leaks, excessive oil consumption, power loss, metallic noises, or blue/black smoke from the exhaust. Intake issues: Problems with the car's intake system may cause engine pipeline blockages, and severe cases will trigger the warning light. A dirty air filter that isn't cleaned regularly can lead to intake problems. Exhaust issues: Exhaust faults can also cause the engine warning light to illuminate. Rear oxygen sensor, catalytic converter, exhaust camshaft, and bearing failures are common causes, with the catalytic converter being most frequent. Using leaded gasoline, lead/silicon-containing lubricant additives, physical damage to the catalytic converter, or fuel supply system failures can easily cause catalytic converter problems. Anti-theft system malfunction: If the electronic anti-theft system fails or the anti-theft controller doesn't match the engine ECU, the system may prevent normal engine operation while illuminating the warning light. When the engine warning light illuminates, follow these steps: First, check if the engine operates normally. If there's shaking, black smoke, etc., avoid restarting. Particularly, never restart if the red warning light is on. If the engine can start, turn off for 5-10 minutes, then press the start button without braking, or turn the key halfway to ON position without depressing the clutch. The vehicle will initiate self-check upon power-on. Observe if the warning light turns off after 5-10 seconds. If the light persists, visit a service center promptly. Technicians can read fault codes via portable diagnostic tools to obtain specific failure information for targeted repairs.

14

0

Share

How Often Should You Start a Car That's Not Driven for Long Periods?

If a car is not driven for an extended period, it's recommended to start it approximately every two weeks. Prolonged parking can make it difficult to start the engine. Even when a car is turned off and unused, the battery continues to discharge. Over time, the battery may become completely drained, and its lifespan will also be shortened. Maintenance tips for long-term car storage: 1. Clean the exterior and interior of the vehicle beforehand. Dirt left on the car's paint for too long can damage it. 2. Keep the battery fully charged and perform regular inspections and maintenance to prevent battery discharge.

13

0

Share

What is the tire model for the Corolla?

Tires are one of the most important components of a vehicle. Below is a detailed introduction to the functions of tires: 1. Support the entire weight of the vehicle, bear the load of the car, and transmit forces and moments in other directions. 2. Transmit traction and braking torque, ensuring good adhesion between the wheels and the road surface to improve the vehicle's power, braking, and passability; together with the car suspension, they mitigate the impact during driving and dampen the resulting vibrations. 3. Prevent severe vibrations and early damage to vehicle components, adapt to the high-speed performance of the vehicle, reduce driving noise, and ensure driving safety, handling stability, comfort, and energy efficiency.

13

3

Share

How long does it take to fully charge a car battery while the engine is running?

It takes about 20 minutes of engine operation to fully charge a car battery, provided that the battery is in good condition. The battery is a crucial component in a vehicle. When the engine is not running, the battery supplies power to all the electrical devices in the car and is also responsible for starting the engine. Once the engine is started, the alternator takes over the role of powering all the electrical devices and simultaneously charges the battery. An engine is a machine that converts other forms of energy into mechanical energy, including internal combustion engines, external combustion engines, jet engines, electric motors, etc. For example, an internal combustion engine typically converts chemical energy into mechanical energy.

10

4

Share

What is the difference between Total Quartz Ineo and Total Quartz?

The differences between Total Quartz Ineo and Total Quartz are: 1. Different origins: Total Quartz Ineo series is fully synthetic oil produced domestically in China; Ineo is imported from France. 2. Different viscosity levels: Total Quartz Ineo is only available in 0W-30 viscosity grade in China; Quartz comes in 5W-30 and 5W-40. Total 9000 oil features fuel economy, cleaning capability, smooth low-temperature flow, and high-temperature protection. It can easily handle harsh driving conditions, providing more efficient and powerful protection for the engine, extending engine life, with high viscosity index and stability, enhancing oil film strength and elasticity.

11

1

Share

How to turn on the air conditioning to blow cool air in the Baojun 510?

Can ETC be installed without being placed on the glass top?

What are the reasons for the engine warning light in Ford Focus?

How Often Should You Start a Car That's Not Driven for Long Periods?

What is the tire model for the Corolla?

How long does it take to fully charge a car battery while the engine is running?

What is the difference between Total Quartz Ineo and Total Quartz?

What Causes the Mustang Engine Warning Light to Illuminate?

What are the differences in appearance between the BMW X3 and X5?

What is the size of the Lingdong fog light?

How many seconds does the Oshan X5 take to accelerate from 0 to 100 km/h?