How to Turn on the Air Conditioning in Wuling Hongguang?

What is the 0-100 km/h acceleration time of the Excelle?

According to official data, the Excelle with a 1.3L engine has a 0-100 km/h acceleration time of 11.2 seconds. The factors affecting a vehicle's 0-100 km/h acceleration time are as follows: Torque: Torque, in simple terms, represents the magnitude of force. The greater the torque, the stronger the force pushing the vehicle, resulting in faster acceleration. The Excelle 1.3L has a maximum torque of 133 N·m, achieving a 0-100 km/h acceleration time of 11.2 seconds. In comparison, the Lexus 2.0L naturally aspirated engine has a maximum torque of 208 N·m but a slower 0-100 km/h acceleration time of 12.5 seconds. Transmission efficiency: The transmission acts as a medium for power delivery, inevitably involving power loss. Higher transmission efficiency leads to better acceleration performance. Generally, the ranking of transmission efficiency is as follows: manual transmission > dry dual-clutch transmission > wet dual-clutch transmission > AT transmission > CVT transmission. The Excelle is available with either a 5-speed manual transmission or a CVT transmission.

11

2

Share

Is it necessary to warm up the car after starting it in winter?

It is necessary to warm up the car after starting it in winter. Driving without warming up the car in winter can cause wear and tear on various parts of the car's engine, transmission, and other engine components, leading to a shortened lifespan; it also increases the fuel consumption of the engine, making it easier for carbon deposits to form inside the engine. Reasons for warming up the car in winter: After the car has been parked for a long time, the engine oil inside the engine flows back into the oil pan at the bottom of the engine; before the engine reaches its operating temperature, the fuel supply system, due to the low temperature, cannot effectively vaporize the gasoline completely; in a cold engine, the gear oil flows to the lower part of the transmission. Specific process for warming up the car in winter: Start the car for 30 seconds to one minute, allowing the engine's water temperature to reach the normal temperature, then you can drive. However, do not drive at high speeds at this time; maintain a low speed and do not exceed 2000 RPM. While driving at low speed, observe the water temperature gauge. If it rises slightly, you can appropriately shift to a higher gear and proceed. After driving about one kilometer, the car will be fully warmed up, and you can then drive normally.

9

0

Share

How many seconds does it take for the Mazda CX-4 to accelerate from 0 to 100 km/h?

According to official data, the Mazda CX-4 comes with two engine options: 2.0L and 2.5L. The 2.0L model accelerates from 0 to 100 km/h in 10.5 seconds, while the 2.5L model does it in 9.5 seconds. The factors affecting the vehicle's acceleration time from 0 to 100 km/h are as follows: Torque: Torque, in simple terms, indicates how much force is available. The greater the torque, the more force is available to propel the vehicle, resulting in faster acceleration. The Mazda CX-4 2.0L has a maximum torque of 202 Nm, achieving 0-100 km/h in 10.5 seconds. The 2.5L model has a maximum torque of 252 Nm, achieving 0-100 km/h in 9.5 seconds. Transmission efficiency: The transmission acts as a medium for power delivery, inevitably involving power loss. Higher transmission efficiency leads to better acceleration performance. Generally, the ranking of transmission efficiency is as follows: manual transmission > dry dual-clutch transmission > wet dual-clutch transmission > AT transmission > CVT transmission. The Mazda CX-4 is equipped with a 6-speed automatic transmission with manual shift mode. Power-to-weight ratio: The relationship between horsepower and vehicle weight is referred to as the power-to-weight ratio (measured in Hp/T). The power-to-weight

5

2

Share

What does ECU mean in cars?

ECU in cars stands for Engine Control Unit. The ECU control unit makes adjustments to the vehicle's operating system by comprehensively analyzing driving data such as vehicle speed, engine RPM, transmission gear position, etc. Introduction to ECU: ECU is known as the brain of the engine. During engine operation, the ECU collects data, processes it, and then controls the engine's operation through control mechanisms. Engine sensors transmit data to the ECU. After processing, the ECU adjusts the engine's operating state through actuators. The ECU is generally installed in the engine compartment. Function of ECU: The purpose of the electronic control unit is to compute, process, and judge the information input from the air flow meter and various sensors based on the programs and data stored in its memory, then output commands to provide the fuel injector with electrical pulse signals of a certain width to control the fuel injection volume. The electronic control unit consists of a microcomputer, input, output, and control circuits. Capabilities of ECU: ECUs generally have self-diagnosis and protection functions. When a fault occurs in the system, it can automatically record the fault code in RAM and take protective measures to read substitute programs from the aforementioned inherent programs to keep the engine running. At the same time, these fault messages will be displayed on the dashboard and remain illuminated, allowing the owner to promptly identify the issue and drive the car to the repair shop.

20

1

Share

Where to Buy Car License Plate Screws?

Car license plate screws can be purchased at the Department of Motor Vehicles (DMV), 4S stores, large-scale auto repair shops, and auto parts markets. Additional Information: Car License Plate: Commonly known as a license plate or vehicle number plate, it refers to the plates attached to the front and rear of a vehicle. These plates are typically made of aluminum, sheet metal, plastic, or paper, and display the vehicle's registration number, registration region, and other relevant information. Function of License Plates: License plates serve as a unique identifier and information record for each vehicle. Their primary purpose is to indicate the vehicle's registered region and to enable tracking of the vehicle's owner and registration details through the license plate number.

19

3

Share

What Causes Water Leakage at the Car Door Edge?

Common causes of water leakage at the car door edge include aging door seals, deteriorated window glass channels, and clogged door drainage outlets. Here's a detailed analysis: Aging seals: Water leakage may be caused by aged door seals. Inspect the vehicle's rubber seals and replace them if worn out. Deteriorated glass channels: Leakage can also occur due to degraded window glass channels, requiring replacement. Clogged drainage outlets: Blockages from debris in door drainage outlets may prevent water from draining properly, necessitating debris removal from the drainage ports.

20

0

Share

How to Turn on the Air Conditioning in Wuling Hongguang?

What is the 0-100 km/h acceleration time of the Excelle?

Is it necessary to warm up the car after starting it in winter?

How many seconds does it take for the Mazda CX-4 to accelerate from 0 to 100 km/h?

What does ECU mean in cars?

Where to Buy Car License Plate Screws?

What Causes Water Leakage at the Car Door Edge?

What type of sound wave does a parking sensor utilize?

What are the buttons on the 2013 Focus?

How often should the spark plugs be replaced on the new Mondeo?

How to Use the Manual Mode in a Tiptronic Transmission Car?