How to Turn on the Air Conditioning in a Passat?

What Causes the Steering Gear Noise in Tang DM?

Tang DM steering gear noise is caused by lack of lubrication oil, steering gear failure, insufficient tire pressure, etc. The details are as follows: Lack of Lubrication Oil: The screws inside the steering wheel lack lubrication oil. You need to remove the steering wheel cover and add lubrication oil inside. Steering Gear Failure: The steering gear may also malfunction. Normally, if the steering is turned too fully during turning, it puts a greater load on the steering gear, leading to severe wear and resulting in noise. It is recommended to inspect and replace the components. Insufficient Tire Pressure: Uneven tire pressure in the left front or right front tire causes the front of the car to deviate, leading to unbalanced car bearings and misaligned steering gear, resulting in noise and deviation.

6

3

Share

What Causes the Loud Noise When Accelerating in a Teana?

Teana produces loud noise when accelerating due to reasons such as throttle carbon buildup, low water temperature, and engine overheating, as detailed below: Throttle Carbon Buildup: This causes the throttle opening to be too small during startup. The system's adaptive response increases the throttle opening, resulting in the sound of the engine accelerating. Low Water Temperature: The ECM perceives the water temperature as too low and automatically increases the idle speed to raise the water temperature, hence the loud noise when accelerating. Once normal temperature is reached, the idle speed returns to normal, and the noise subsides. Engine Overheating: The engine may produce a hissing sound, similar to steam or air escaping from the engine. Typically, after hearing this sound, the engine rapidly loses power. In case of engine overheating, check the cooling system.

2

3

Share

What is the wheelbase of the Lavida?

The front wheelbase of the Lavida is 1517 mm, and the rear wheelbase is 1493 mm. Introduction to Wheelbase: Wheelbase refers to the distance between the center lines of the tracks left by the wheels on the vehicle's supporting plane (generally the ground). If there are dual wheels at both ends of the axle, the wheelbase is the distance between the center planes of the dual wheels. Generally speaking, the wider the wheelbase, the higher the driving comfort. Function of Wheelbase: Generally, a wider wheelbase provides higher driving comfort and better stability. When the vehicle tilts laterally, the outer wheels can offer better support. In curves, the vehicle's roll angle is smaller, and the limit of the outer wheels appears later. However, some domestic cars lack power steering, and if the front wheelbase is too wide, the steering wheel can feel very 'heavy,' affecting driving comfort. Additionally, wheelbase also influences the vehicle's total width, total weight, and safety.

3

Share

What are the reasons for oil leakage in the Audi Q7 4.2 engine?

Audi Q7 engine oil leakage and smoke emission reasons are as follows: Aging and hardening of sealing rings: Over 90 percent of oil leakage problems are caused by rubber sealing rings losing a large amount of plasticizers and softeners due to prolonged exposure to alternating cold and warm temperatures, leading to corrosion, aging, and hardening. Incomplete combustion: Small injection advance angle, incomplete combustion, slight water leakage in the cylinder liner, water content in the fuel, white smoke emission during cold starts, which disappears as the engine temperature rises. Smoke limiter failure: Air-fuel ratio imbalance, decreased cylinder pressure, premature injection timing, failure of the smoke limiter on the injection pump, malfunction of the exhaust brake system, engine cylinder liner wear, stuck rings, misalignment, aging and deformation of valve sealing rings, excessive valve guide clearance.

7

3

Share

How to Start a Volvo XC90 When the Key Fob Battery is Dead?

Volvo XC90 vehicles are equipped with an induction area near the steering column, glove compartment, and ignition button. When the key fob battery is dead, you can place the key close to the induction area and then press the start button to attempt starting the vehicle. If it doesn't work on the first try, adjust the key's position near the induction area and try a few more times. 1. The keyless start system utilizes radio frequency identification (RFID) technology. The chip in the smart card automatically senses and controls the door locks. When the driver approaches the vehicle within a certain distance, the door locks will automatically unlock and deactivate the anti-theft system. When the driver leaves the vehicle, the door locks will automatically lock and activate the anti-theft system. 2. Vehicles equipped with a keyless system generally have both an induction system and a key slot. This is to ensure that if the smart card is damaged or the battery dies, the owner can still unlock the doors using the traditional method.

17

0

Share

Is the Emgrand GS engine equipped with a belt or chain?

The Emgrand GS engine uses a timing chain. Structure of the timing chain lubrication oil passage in the engine: It includes the engine block and oil passages. The front end face of the block is equipped with an oil nozzle. Inside the engine block, there are a short oil passage, a main bearing lubrication oil passage, and the engine main oil passage. The oil nozzle is positioned above the timing chain and is connected to the main bearing lubrication oil passage via the short oil passage. The other end of the main bearing lubrication oil passage connects to the engine main oil passage. Distance between the oil nozzle and the timing chain: The oil nozzle is close to the timing chain, allowing lubricating oil to be directly sprayed onto the timing chain, ensuring simple and reliable lubrication. The lubrication oil passage connected to the oil nozzle is short in length and close to the main oil passage, resulting in minimal oil pressure loss. This setup ensures higher oil pressure for the lubricating oil, guaranteeing that the timing chain receives sufficient, stable, and timely cooling and lubrication during operation.

5

2

Share

How to Turn on the Air Conditioning in a Passat?

What Causes the Steering Gear Noise in Tang DM?

What Causes the Loud Noise When Accelerating in a Teana?

What is the wheelbase of the Lavida?

What are the reasons for oil leakage in the Audi Q7 4.2 engine?

How to Start a Volvo XC90 When the Key Fob Battery is Dead?

Is the Emgrand GS engine equipped with a belt or chain?

Where is the HOWO exhaust brake button located?

Difference Between BMW 730 and 740?

What is the correct way to use a manual-automatic transmission?

What is the fuel consumption of the BYD Song Pro Second Generation Xiaoyun Edition?