How to Turn on the Air Conditioning Cooling in the Honda 10th-Generation Civic?

1 Answers
LaAva
07/30/25 4:18am
Method to turn on the air conditioning cooling in the Honda 10th-Generation Civic: 1. First, press the ON/OFF button on the center console to turn on the air conditioning. 2. Rotate the temperature control knob counterclockwise to adjust to the desired temperature. 3. The Civic has two temperature control buttons: the left one corresponds to the driver's side, and the right one is for the passenger side; select accordingly. 4. To activate cooling, press the ON button next to A/C on the screen. Below is an introduction to the 10th-Generation Civic: 1. The Civic is a compact sedan produced by Dongfeng Honda, with the current model being the 10th generation. 2. The 10th-Generation Civic has body dimensions of 4658*1800*1416mm, available in 1.0L and 1.5L engine options, with transmission choices of 6-speed manual or CVT. 3. 1.0L version: Equipped with a 1.0L three-cylinder turbocharged engine, producing a maximum horsepower of 125, maximum power of 92kw, maximum torque of 173N·m, 0-100km/h acceleration time of 11.2 seconds, and a combined fuel consumption of 5L/100km as per the MIIT. 4. 1.5L version: Equipped with a 1.5L four-cylinder turbocharged engine, producing a maximum horsepower of 177, maximum power of 130kw, maximum torque of 220N·m, 0-100km/h acceleration time of 8.5 seconds, and a combined fuel consumption of 5.4L/100km as per the MIIT.
Was this review help?
6
5
Share
More Forum Discussions

What to Do When the Paint on the Front of the Car is Scratched?

After the paint on the front of the car is scratched, handle it according to the following situations: 1. Slight paint damage: Basically, no action is needed. Minor scratches on a car are inevitable; even stones flying off the road can cause scratches. This is a minor scrape, leaving a mark that can often be wiped off with a wet towel after a couple of wipes. If the scratch isn't very noticeable, simply applying wax is sufficient; even a non-abrasive polish wax can work well. 2. Mild paint damage: After wiping with a wet towel, there will still be relatively obvious scratches that cannot be removed with water. It's best to apply wax, such as water wax or soft wax containing abrasives, which can be either solid or liquid. Alternatively, a touch-up paint pen can be used for minor repairs. 3. Moderate paint damage: Seek repair at a maintenance shop.
11
0
Share

Is the Rear Vehicle Fully Liable for a Rear-End Collision When the Front Vehicle Brakes Suddenly on the Highway?

When the front vehicle brakes suddenly on the highway, resulting in a rear-end collision, the rear vehicle is generally liable. However, if evidence proves that the front vehicle braked abruptly, the front vehicle may also share responsibility. Related details: 1. Liability Determination: Even if the front vehicle brakes suddenly, the rear vehicle must always maintain a safe distance and speed. If a rear-end collision occurs, the rear vehicle is typically at fault. However, if evidence shows the front vehicle braked abruptly, the front vehicle may also be held accountable. 2. Prevention Measures: Generally, vehicles on the road should maintain sufficient distance between each other. The rear vehicle should not follow too closely, as adequate space and reaction time are necessary to prevent accidents.
7
2
Share

Does the vehicle owner need to be present for re-stamping the VIN?

Re-stamping the VIN does not require the vehicle owner to be present in person, but the owner's ID card is required for the procedure. Relevant information: 1. Required materials: The vehicle registration certificate, purchase certificate, and the owner's ID card need to be brought to the vehicle management office to apply for the procedure, and then the re-stamping will be done at a designated location. 2. Additional information: The full name of the VIN is the Vehicle Identification Number, which is a unique set of alphanumeric characters assigned by the manufacturer to identify a vehicle. It consists of a 17-character code, also known as the 17-digit identification code, chassis number, or 17-digit number. The combination of characters in the VIN ensures that no two vehicles of the same model will have the same number within 30 years, making it a unique identifier for the vehicle, hence it can be referred to as the 'vehicle's ID card'.
18
4
Share

What Causes the Car Air Conditioner to Alternate Between Hot and Cold?

Introduction to the reasons why a car air conditioner alternates between hot and cold: 1. Damaged compressor capacitor: For the air conditioner to function properly, both the internal and external units need to work together. If the car air conditioner exhibits alternating hot and cold air, check if the external unit's compressor start capacitor is damaged. If so, it needs to be replaced. 2. Dirty filter: If the air conditioner hasn't been cleaned for a long time, it can also cause the air conditioner to alternate between hot and cold. A dirty filter or evaporator can easily lead to poor ventilation and heat dissipation, causing the compressor to overheat and shut down. Therefore, regular cleaning is necessary to maintain cleanliness. 3. Insufficient refrigerant: The air conditioner requires an adequate amount of refrigerant, commonly known as Freon, to cool. If the temperature inside the car alternates between hot and cold, check if the refrigerant in the air conditioning system is insufficient. If so, use other methods to address the issue. 4. Moisture in the air conditioning system: When high-temperature, high-pressure liquid passes through the expansion valve, all the liquid undergoes a rapid change, turning into low-temperature, low-pressure liquid. This low-temperature, low-pressure liquid causes the temperature of the evaporator to drop rapidly, so the air blown by the air conditioner motor becomes cold after passing through the evaporator.
7
0
Share

What Can Be Used to Clean Paint Off a Car?

Paint on a car can be cleaned using the following methods: 1. Olive Oil: If you have olive oil at home, apply some to the painted area of the car and gently rub it a few times. Let it soak in for a while, then wash it off with soap after a few minutes. Olive oil is rich in monounsaturated fatty acids, and this method avoids harming your hands. 2. Floral Water: If you can't find olive oil, you can use floral water on the painted area. After a while, wash it with soap to clean it. The main ingredients of floral water are neroli oil, rose geranium oil, lemon oil, benzoic acid, bergamot oil, and alcohol. 3. Peanut Oil or Salad Oil: If neither of the above is available, you can use peanut oil or salad oil. Rub it on the painted area, add some dishwashing liquid, and rub again. Finally, wipe it off with a cloth, and the paint will be removed. 4. Banana Oil: Also known as thinner, its main component is xylene, which is highly volatile, flammable, explosive, and toxic, making it a hazardous material. However, if you are concerned about strong odors, you can use banana oil on the painted area and wash it off. Banana oil does not leave a bad smell. Alternatively, you can directly purchase some turpentine from a paint store for cleaning.
10
0
Share

Where Can I Check the Vehicle Environmental Protection List?

Vehicle environmental protection lists can be queried by opening the Motor Vehicle Environmental Protection Network of the Motor Vehicle Emission Monitoring Center under the Ministry of Ecology and Environment on a computer. Below is relevant information about the environmental protection list: 1. Introduction: The full name of the environmental protection list is "Motor Vehicle Environmental Protection Information Accompanying Vehicle List," such as the Light Gasoline Vehicle Environmental Protection Information Accompanying Vehicle List, Electric Vehicle Environmental Protection Information Accompanying Vehicle List, etc. According to the "Announcement on the Disclosure of Environmental Protection Information for Motor Vehicles and Non-Road Mobile Machinery" issued by the National Environmental Protection Department, starting from January 1, 2017, motor vehicle manufacturers and importers are required to disclose major environmental protection information in the form of a "Motor Vehicle Environmental Protection Information Accompanying Vehicle List" before the product leaves the factory or the goods enter the country. 2. For parallel imports: Import companies need to disclose the information of imported vehicles before the commodity vehicles enter the country to prove that the vehicles comply with national environmental protection standards.
13
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.