How to Turn Off the Rear Lights on the New Magotan?

1 Answers
VonDeclan
07/29/25 6:29pm
The method to turn off the rear lights on the new Magotan is: you can turn them off from the driver's seat or from the control panel in the rear. The Magotan is a mid-size car launched by FAW-Volkswagen, with body dimensions of 4865mm in length, 1832mm in width, and 1471mm in height, and a wheelbase of 2871mm. In terms of power, this car offers two powertrain options: a 1.4T turbocharged engine and a 2.0T turbocharged engine with high and low power outputs. The transmission system paired with the engines is a 7-speed dual-clutch transmission.
Was this review help?
19
5
Share
More Forum Discussions

What are the incorrect requirements for hydraulic oil?

An incorrect requirement for hydraulic oil is a low flash point. The flash point refers to the minimum temperature at which a petroleum product, under specified conditions, is heated to the point where its vapor comes into contact with a flame and causes instantaneous ignition. The flash point is an index of the liquid's hazard level; the lower the flash point, the more likely it is to cause a fire. Additional information: Below is an introduction to hydraulic oil: 1. Hydraulic oil is the hydraulic medium used in hydraulic systems that utilize liquid pressure energy. Its functions include: energy transmission, anti-wear, system lubrication, corrosion prevention, rust prevention, and cooling. 2. Hydraulic systems in vehicles and construction machinery use hydraulic oil as the working medium. In these systems, the fluid velocity is relatively low while the pressure is high, hence it is referred to as hydrostatic transmission. 3. Hydraulic oil has a wide range of applications and is the most widely used industrial oil product. Currently, hydraulic components are being developed to be smaller in size and higher in power, leading to increasingly higher system pressures.
20
0
Share

What is Hill Start Assist?

Hill Start Assist is a function derived from the ESP system, which allows the vehicle to start on a slope without using the handbrake and prevents rolling back. The driver can release the right foot from the brake pedal while the vehicle still maintains braking for a few seconds, enabling the driver to easily move the foot from the brake pedal to the accelerator pedal. This avoids the hassle of using the parking brake for hill starts, which can cause panic for the driver. Conditions for activating the Hill Start Assist system: 1. The gear lever is not in the P position and the accelerator pedal is not pressed; 2. The vehicle must be in a stationary state; 3. The driver has not engaged the handbrake, foot brake, or electronic brake.
16
2
Share

How is Fatigued Driving Determined?

Fatigued driving is determined under the following conditions: 1. The vehicle driver's daily driving time exceeds eight hours; 2. The driver experiences drowsiness, sleepiness, or physical weakness due to excessive physical labor or lack of sleep, leading to an inability to promptly detect and accurately handle road traffic situations. Meeting any one of these conditions constitutes fatigued driving. Fatigued driving significantly increases the risk of traffic accidents, so it should be avoided whenever possible. If caught fatigued driving, penalties include demerit points and fines. In cases of major traffic accidents, criminal liability may be incurred.
10
0
Share

How to Solve the Handlebar Vibration Issue of SYM FNX150?

Troubleshooting tip: Eliminate the gap by adjusting the steering stem bearing nut. If the bearing nut is already tightened to the limit and the gap still persists, disassemble and inspect the ball bearings. Check whether the upper and lower bearing races are damaged. If damaged, replace with new ball bearings or upper/lower bearing races.
9
3
Share

What are the differences between parallel imported cars and 4S store cars?

Parallel imported cars and 4S store cars differ in the following aspects: 1. Product difference: Parallel imports allow purchasing overseas models not available domestically; 4S stores only sell manufacturer-released China-spec vehicles. 2. Price difference: Parallel imported cars are generally cheaper; 4S store cars are more expensive. 3. Registration difference: Parallel imported cars must comply with domestic traffic regulations to be registered; vehicles sold by 4S stores all comply with Chinese traffic regulations and can be registered normally. When purchasing a car, pay attention to: 1. Check the vehicle's production date; 2. Inspect vehicle documents; 3. Check if the exterior is intact; 4. Inspect doors and trunk; 5. Check tires; 6. Examine seat interiors; 7. Test electrical systems; 8. Perform startup inspection.
1
1
Share

What are the differences between parallel imported vehicles and China-spec vehicles?

Differences between parallel imported vehicles and China-spec vehicles: 1. Even for the same model, there are certain differences in configurations and optional content between parallel imported vehicles and China-spec vehicles; 2. Parallel imported vehicles are generally 10% to 20% cheaper than China-spec vehicles; 3. Owners of parallel imported vehicles can choose to install various optional configurations according to their needs, while for China-spec vehicles, since manufacturers have not introduced more configurations, owners cannot purchase and install them. China-spec vehicles are those that comply with Chinese standards in terms of road conditions, safety, performance, emissions, and environmental protection, tailored to China's national conditions. Parallel imported vehicles, fully known as parallel trade imported vehicles, abbreviated as parallel trade vehicles, refer to cars purchased by traders from overseas markets and introduced into the Chinese market for sale without authorization from the brand manufacturers. Depending on the import source, they can be classified as US-spec vehicles, Middle East version vehicles, Canada-spec vehicles, European version vehicles, etc.
10
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.