How to turn off the Q3 wiper
2 Answers
Here is the method to turn off the wiper: Lift the lever on the right side of the steering wheel up one notch, and the wiper will stop. Below is some related information: 1. The wiper, also known as the windshield wiper, water wiper, or windscreen wiper, is a device used to wipe away raindrops and dust attached to the vehicle's windshield to improve the driver's visibility and enhance driving safety. 2. Operating principle: The power source of the wiper comes from the motor, which is the core of the entire wiper system. The quality requirements for the wiper motor are quite high. It uses a DC permanent magnet motor, and the wiper motor installed on the front windshield is generally integrated with the worm gear mechanical part. The function of the worm gear mechanism is to reduce speed and increase torque, and its output shaft drives the four-bar linkage, which converts continuous rotational motion into left-right swinging motion. 3. The wiper motor adopts a 3-brush structure to facilitate speed change. The intermittent time is controlled by the intermittent relay, using the motor's return switch contacts and the relay's resistor-capacitor charge-discharge function to make the wiper wipe at a certain cycle. The wiper blade is the tool that directly removes rainwater and dirt from the glass. The blade is pressed against the glass surface by a spring strip, and its lip must match the angle of the glass to achieve the required performance.
Actually, many beginners ask this question, and I also struggled with it when I first started driving. The control lever on the right side of the steering wheel is the key to operating the wipers. You see, it has four positions: the bottom is OFF (turn off), one notch up is INT (intermittent wiping), further up is LO (low-speed continuous wiping), and the top is HI (high-speed continuous wiping). To turn it off, just gently push the lever all the way down until you hear a click, and it will return to the OFF position. Modern car models usually come with an automatic wiper function, indicated by an AUTO mark on the lever. In this case, you need to press the button to exit the automatic mode first, then push it back to the OFF position. Don't use too much force when operating it; a gentle touch will do the trick.
