How to Turn Off the Power with One-Key Start?

2 Answers
DeEliana
07/25/25 7:06am
Press the start button repeatedly to turn on the power. Activate the system and start the engine. Move the gear lever to the P position. After shifting to P, press the start button once more to turn off the power.
Was this review help?
12
2
Share
DelRose
08/10/25 6:25pm
After driving for so many years, I'm used to the one-button start feature. When you press the button once to power on the car (meaning the dashboard lights up but the engine isn't started) and want to turn it off, it's simple—just press the start button again. The whole system is cyclical: off -> acc (accessory power only) -> on (fully powered) -> off, so pressing it once more will automatically return it to the off state. Just make sure not to press the brake or accelerator pedal, or you might accidentally start the engine. If you forget to turn it off normally, the battery will slowly drain, making it hard to start next time—especially troublesome in winter. It's best to develop a habit of confirming the shutdown when parking to protect the vehicle's electrical components. Familiarizing yourself with your car's button layout can prevent a lot of trouble.
Was this review help?
1
5
Share
Expand All
More Forum Discussions

What does 'one step on the brake, two shift to neutral, three pull the handbrake' mean?

It should mean stepping on the brake first, then shifting to neutral, and finally pulling the handbrake. Because during the final parking in Subject 2, the vehicle must not exceed 50 cm from the boundary line. If you find that the distance between the vehicle and the boundary line is a bit large when you are about to stop, shifting to neutral first can allow you to adjust the distance by utilizing the vehicle's own inertia. If you pull the handbrake first, the test vehicle will stop immediately, leaving no room for adjustment. More relevant information is as follows:  Note 1: The operation for reverse gear varies for each car model, so the corresponding operation is also different. For some car models, the reverse gear is more intuitive—you just need to push the gear to the right and then pull it back to engage reverse gear. Note 2: For car models like Volkswagen, the reverse gear is more hidden because the reverse gear and first gear share the same position on Volkswagen cars. Therefore, to engage reverse gear on a Volkswagen training car, you must press the entire gear lever down and then shift it to the first gear position.
4
1
Share

Can Run-Flat Tires Be Punctured?

Run-flat tires can be punctured, but they are designed to prevent blowouts. Here is relevant information: 1. Characteristics of run-flat tires: After a blowout, the vehicle can still travel up to approximately 80 kilometers at a maximum speed of 80 km/h, which is sufficient to reach the nearest repair shop for tire replacement. 2. Functionality: Run-flat tires not only allow continued driving after losing pressure but also ensure safety. After a blowout, run-flat tires do not immediately collapse because their sidewalls are particularly thick, providing strong support to prevent the vehicle from rolling over. Additionally, vehicles equipped with run-flat tires do not have a spare tire. They can continue driving after a blowout without needing immediate tire replacement, offering convenience and increasing trunk space.
15
0
Share

What is the ground clearance height of the Audi A6L?

The minimum ground clearance of the Audi A6L is 117 millimeters. The minimum ground clearance of the Audi A6L refers to the distance between the lowest point (excluding the wheels) and the supporting plane, which is used to characterize the vehicle's ability to pass over obstacles such as stones and tree stumps without collision. The higher the ground clearance of the Audi A6L, the better its off-road capability. However, if the ground clearance is too high, the stability at high speeds will decrease. The Audi A6L is a mid-to-large luxury sedan. The length, width, and height dimensions of the Audi A6L are 5038 millimeters, 1886 millimeters, and 1475 millimeters respectively, with a wheelbase of 3024 millimeters. Generally, the ground clearance of sedans ranges between 110 millimeters and 150 millimeters, while SUVs have a ground clearance between 200 millimeters and 250 millimeters. However, the ground clearance of the Audi A6L is not static; it also depends on the load condition. Therefore, changes in ground clearance should be considered based on the load variations of the Audi A6L. When selecting a vehicle, ground clearance can be one of the reference factors. The choice should depend on the vehicle's intended use and the road conditions. For urban areas with well-paved roads, vehicles with lower ground clearance can enhance stability and comfort. If the vehicle is frequently used in remote areas or on poor road conditions, considering off-road performance, a vehicle with higher ground clearance may be preferable to avoid scraping or damaging the chassis.
10
1
Share

What is the top speed of Ferrari and Lamborghini?

Ferrari's top speed is 350 km/h. Lamborghini's maximum speed can reach: 305 km/h. The following is a related introduction to the Ferrari 488: 1. In terms of appearance: The front face adopts a double vertical bar design and a concave style, the front hood features a rugged design with slim headlights, the side profile showcases sporty and dynamic waistlines along with aggressive side air intakes, and the five-spoke wheel design is very clean. The rear adopts a simple design with a black diffuser shape below. 2. Interior: It features a red and black dual-tone sporty style, and the dashboard design has a very racing-inspired look.
10
5
Share

Is Water Leakage in the Engine Compartment Serious?

Water leakage in the engine compartment is serious and may likely cause accidents, so it should be repaired promptly. Here is relevant information: 1. Precautions for engine water ingress: When the engine compartment is flooded, do not start the engine immediately. If the car is on a waterlogged road, push it out to a dry area, allow all the water in the engine compartment to drain out, open the engine hood to let the sun dry it or use a blower to dry it. In short, the engine must be completely dry before starting. 2. Hazards of engine water ingress: Never attempt to start the engine if it has been flooded. If you do, even with water ingress insurance and vehicle damage insurance, the insurance company will not cover the costs. The engine works by igniting compressed gas, and water is difficult to compress. Forcing the engine to start can result in severe consequences, such as completely bent or even broken connecting rods, leading to major engine repairs.
2
1
Share

What is the solution for the Fit's low-speed jerking?

The low-speed jerking in the Fit is due to a problem with the transmission, which can be resolved by replacing the transmission. Below is an introduction to the Fit: 1. Introduction: The Honda Fit is one of Honda's global strategic models, following the Accord and Civic. While maintaining consistent high quality and reliability, it is designed, spacious, safe, controllable, fuel-efficient, and practical to meet the highest global standards, reaffirming its comprehensive leading edge in this segment. 2. Powertrain: Earth Dreams Technology engine (1.5L direct-injection DOHC i-VTEC engine and a new CVT transmission). 3. Market Positioning: As one of Honda's global strategic models, the Fit has sold over 4.7 million units in 115 countries worldwide since its launch in 2001, making it a true leader in the global compact car market.
14
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.