How to Turn Off the Maintenance Reminder on a Volkswagen?

2 Answers
SkylarAnn
07/29/25 1:36am
Turn off the ignition, press and hold the clock adjustment button SET while turning on the ignition, then release the SET button and press it once more; turn off the ignition, then turn it back on to check if the reminder has been reset. If not, you must start the process from the beginning. Different models may have varying methods to cancel the maintenance reminder. You can try the following steps to cancel the maintenance reminder: 1. First, insert the key into the ignition but do not turn it. 2. Next, press and hold the button on the lower right side of the dashboard without releasing it, then turn the key to the power-on position. 3. Finally, after holding for ten seconds, release the button and immediately press the button on the left side to cancel the maintenance reminder.
Was this review help?
11
1
Share
OMargaret
08/12/25 5:42am
I've been driving a Volkswagen for several years, and every time the maintenance reminder pops up, I manually turn it off. The method is to not start the engine first, just turn on the ignition switch, then use the buttons on the steering wheel to scroll through the menu, find the service or maintenance settings option, and select reset reminder. The whole process takes a few minutes and is quite convenient. Actually, this reminder is well-designed, reminding us to change the oil and filter in time to avoid engine wear. I usually advise friends not to ignore it directly, but to go to the shop for maintenance first and then reset it. Long-term lack of maintenance can cause problems with the car, such as increased fuel consumption or sluggish acceleration, which can be costly and time-consuming to repair. Before turning it off yourself, make sure you are familiar with the steps, as the menu location may vary for different Volkswagen models. Flipping through the manual or searching for video tutorials can help you get it done.
Was this review help?
18
0
Share
Expand All
More Forum Discussions

Where is the reverse radar switch for the Buick Excelle?

The switch for the Buick Excelle's reverse radar is located under the left taillight in the trunk. Generally, when the gear is shifted into reverse (R position), the reverse radar system activates. If the self-check is normal, the system will emit a brief beep to indicate readiness. When shifting out of reverse, the reverse assist system automatically turns off. More information about the reverse radar is as follows: 1. The reverse radar is a safety auxiliary device when parking or reversing the car, which can inform the driver of the surrounding obstacles through sound or more intuitive display. 2. It relieves the driver's troubles caused by looking around when parking, reversing, and starting the vehicle, and helps eliminate blind spots and unclear vision defects.
16
2
Share

Why is the fuel gauge inaccurate?

The reasons for an inaccurate fuel gauge include fuel sloshing and sensor issues. The specific causes and refueling precautions are as follows: Specific causes of an inaccurate fuel gauge: If the fuel gauge shows only a slight deviation, it is likely caused by fuel sloshing in the tank. If the deviation is significant, then the fuel sensor may be faulty. In this case, the fuel sensor should be inspected, and if damaged, it needs to be replaced promptly. Refueling precautions: Refuel when the fuel gauge needle reaches the red line. Avoid waiting until the fuel is completely depleted before refueling, as this can damage the car's engine.
9
5
Share

What is the reason for the fuel light being on when there is fuel in the tank?

The reason for the fuel light being on when there is fuel in the tank may be due to a malfunction in the car's fuel gauge. Fuel tanks can be divided into two types: open tanks and closed tanks. The fuel tank must have a sufficiently large volume; the suction pipe and return pipe should be inserted below the lowest liquid level to prevent air suction and oil splashing, which can cause bubbles. Relevant information about gasoline additives is as follows: 1. Introduction: Gasoline additives are liquids that enable car gasoline to fully combust, usually added directly to the fuel tank along with gasoline. 2. Function: Using gasoline additives to clean the fuel system and regularly using them to control carbon deposit formation can always keep the engine in optimal condition.
4
4
Share

Does the Original Factory Bumper Need Painting?

The original factory bumper comes pre-painted from the factory and does not require additional painting. Currently, there are two main types of bumpers available on the market: original factory bumpers and original vehicle bumpers. Original factory bumpers are supplied directly by the manufacturer, while original vehicle bumpers are typically manufactured by aftermarket suppliers, and some are even produced by small workshops. Relevant information about car waxing is as follows: 1. Introduction: Car waxing, as a traditional aspect of car care, primarily serves to waterproof and protect against acid rain. The protective layer of wax reduces the amount of water droplets adhering to the car body. 2. Waxing Frequency: Theoretically, the interval for car waxing depends on how long the wax layer remains effective on the paint surface, which in turn depends on the quality of the wax used.
17
4
Share

What are the differences between original factory keys and aftermarket keys?

The differences between original factory keys and aftermarket keys are as follows: 1. Different nature: Original factory parts are produced by the original equipment manufacturer (OEM) or authorized by the OEM. They may have minor quality issues such as imperfect appearance, insufficient materials, or inadequate craftsmanship, and any parts with such issues are typically rejected. Aftermarket parts are a general term for components outside the OEM supply chain (original parts), regardless of their quality, they are referred to as aftermarket parts. 2. Different characteristics: Genuine OEM parts usually feature the vehicle manufacturer's logo on the packaging and appearance, along with the manufacturer's part number, and they tend to be more expensive. Aftermarket parts, on the other hand, are generally cheaper.
4
2
Share

Where are the locations for driver's license renewal in Liuzhou City?

For driver's licenses registered in Liuzhou, renewal can be processed at any vehicle management office in the districts of Liuzhou when the license expires. The medical examination items for driver's license renewal include: 1. Height: Applicants for large buses, tractors, city buses, large trucks, or trolleybuses must be at least 155 cm tall. 2. Vision: Applicants for large buses, tractors, city buses, medium-sized buses, large trucks, trolleybuses, or trams must have naked or corrected visual acuity of at least 5.0 on the logarithmic visual acuity chart. 3. Color vision: No red-green color blindness. The actual driving school medical examination content is consistent with the vision requirements.
17
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.