···
Log in / Register

How to Turn Off the Auto Start-Stop Function in Toyota Izoa?

4 Answers
JeremiahAnn
09/08/25 2:40am

Confirm that the auto start-stop function is working properly. First, start the vehicle and wait until the water temperature light changes from blue to off, then the i-stop light turns green. When the vehicle is driving normally and needs to stop temporarily at a traffic light or for other reasons, press the brake pedal for automatic transmission. Under normal circumstances, after the i-stop is activated, the engine will idle stop after completing the stopping action. However, in heavy rain or when there is standing water on the road, it needs to be turned off. When starting in the car, press and hold the button, observe the i-stop indicator light on the dashboard turning off, and the function will be deactivated.

Was this review help?
9
2
Share
MasonDella
09/19/25 8:19am

I've been driving a Toyota IZOA for two years now. While the auto start-stop feature does save fuel, it can be quite annoying in certain situations, such as during stop-and-go traffic in congested areas where the repeated engine restarts cause noticeable vibrations, affecting driving comfort. Turning it off is actually very simple: there's a small button near the steering wheel with an "A OFF" icon—just press it lightly. Remember to press it each time you start the car, and the feature will be temporarily deactivated. However, note that this isn't a permanent disable; it only works for the current drive cycle, and the system will reactivate upon the next restart. If you're driving on slippery roads or using the air conditioning to cool down, I recommend turning it off, as frequent engine restarts may place additional strain on the battery, potentially shortening its lifespan over time. In short, for a more comfortable ride, just make it a habit to turn it off when needed—after all, safe travel is what matters most.

Was this review help?
3
1
Share
Expand All
SarahAnn
11/02/25 8:40am

When I first bought the Toyota IZOA, I was quite unfamiliar with the auto start-stop feature, but later discovered it could be turned off. The specific operation is to find a button on the center console labeled 'A OFF' after getting in the car, press it gently, and the light will indicate it's deactivated. I often drive in the city, and at red lights, it shuts off the engine. When restarting, the car gives a slight shake, especially noticeable in summer with the AC on as temperatures rise, so I always turn it off immediately. However, this feature saves fuel—Toyota designed it for environmental reasons. Turning it off is just a temporary fix, not a long-term solution. Occasionally, in heavy traffic, I forget to turn it off and regret not doing it sooner. Friends say if the battery is severely aged, the auto start-stop will activate more frequently, so regular battery checks are a good habit. With a few more tries, you’ll get the hang of it—drive long enough, and you’ll pick up all the tricks.

Was this review help?
3
2
Share
Expand All
VanHector
12/16/25 8:44am

The Toyota IZOA's auto start-stop is quite handy but sometimes annoying, like when parking briefly—it shuts off the engine and restarts sluggishly. Fortunately, turning it off is simple: after starting the car, press the button near the instrument panel with the "A" symbol; it deactivates when lit. I usually turn it off while driving to avoid unstable engine restarts in traffic jams or on slopes. Staying mindful of this can also help prolong the engine and battery life.

Was this review help?
16
3
Share
Expand All
More Forum Discussions

Where is the Mercedes-Benz radiator located?

The radiator of the Mercedes-Benz E-Class is located on the right side of the engine compartment. Open the hood and look for a white tank (not all are white), which is a large square or rectangular container with markings above the filler port. If you can't locate the radiator, find the cooling fan first, as the fan is the device that dissipates heat for the radiator - locating the fan will help you find the radiator. Relevant information about automotive radiators: 1. Introduction: Automotive radiator generally refers to the heat exchanger (car radiator). As part of the vehicle's cooling system, the radiator in an engine's water cooling system consists of three main components: the inlet tank, outlet tank, and radiator core with main plates. 2. Installation methods: Radiators can be installed in three configurations: same-side inlet/outlet, opposite-side inlet/outlet, and bottom inlet/outlet. Regardless of the method, it's essential to minimize the number of pipe fittings, as more fittings not only increase costs but also potential failure points.
9
0
Share

How to Solve the Problem of a Motorcycle Lacking Power?

Motorcycle lacking power can be solved mainly by: 1. Exhaust pipe exhaust: blue indicates a problem with the cylinder, black indicates a problem with the carburetor or air filter. 2. Observe the engine's RPM when the throttle is opened to about 50-60 km/h and then further increased: if the RPM increases but the speed remains unchanged, it's a transmission system issue such as the belt. 3. If the RPM does not increase: focus on adjusting the carburetor and checking the cylinder's air tightness. Here are some additional details: 1. Introduction: Motorcycles, powered by gasoline engines and steered by handlebars for front-wheel direction, are two or three-wheeled vehicles that are lightweight, flexible, and fast, widely used for patrol, passenger and cargo transport, and also as sports equipment. 2. Classification: Motorcycles are categorized into street bikes, road racing motorcycles, off-road motorcycles, cruisers, touring bikes, etc.
8
1
Share

Why does the Kia Forte have high fuel consumption?

The reasons for high fuel consumption in a car include inadequate driving skills, poor engine condition, and lack of maintenance during vehicle use. The combined fuel consumption of the Kia Forte is 5.3-5.7L/100km. Currently, there are 8 models of the Kia Forte available for sale: the Manual Luxury Sunroof Edition, Manual Comfort Edition, Manual Comfort Edition (China VI), Manual Luxury Sunroof Edition (China VI), with a combined fuel consumption of 5.3L/100km. The Automatic Luxury Connected Edition, Automatic Trend Edition, Automatic Trend Edition (China VI), and Automatic Luxury Connected Edition (China VI) have a combined fuel consumption of 5.7L/100km. The above figures are the NEDC combined fuel consumption, which is the fuel consumption data measured under the NEDC test cycle. The actual fuel consumption is higher than this value, around 8.6L. Here are 5 tips to help reduce fuel consumption while driving: When starting the vehicle, use a low gear, gently press the accelerator, and gradually increase speed. Avoid suddenly pressing the accelerator hard, as this can multiply fuel consumption. Light acceleration, light braking, and early braking: While driving, gently press the accelerator to avoid sudden increases in engine speed and prevent the car from shaking, making it more fuel-efficient. By anticipating road conditions and applying slow, even acceleration or braking, fuel economy can be improved by up to 20%. Maintain proper tire pressure: Keep tire pressure at the level recommended by the manufacturer. For every 2 PSI below the recommended value (equivalent to about 0.2 in metric units relative to the standard pressure of 2.4), fuel consumption increases by 1%. Regular maintenance or vehicle inspection: Timely oil changes can reduce carbon buildup (carbon buildup can cause ignition issues, sluggish acceleration, increased fuel consumption, and even cylinder misfires in severe cases). Regularly check and replace dirty air filters, clean or replace fuel injectors, spark plugs, and throttle bodies as per mileage. Close windows while driving. Driving with windows open increases wind resistance, which in turn increases the resistance on the car, requiring more power and thus increasing fuel consumption.
15
2
Share

Why is there a standard size for roadside parking space markings?

According to the national 'Road Traffic Signs and Markings': 1. Free parking: Parking spaces marked with blue lines are free. 2. Paid parking: Parking spaces marked with white lines are paid. 3. Special parking: Parking spaces marked with yellow lines are designated for special use. The dimensions of parking spaces are as follows: 1. Straight parking space: The length of a straight parking space ranges from 5 meters to 5.5 meters, with a width requirement of 2.3-2.5 meters and a standard line width of 15 centimeters. 2. Angled parking space: The length requirement for an angled parking space is 6-8 meters, with a width requirement of 2.8-3 meters and an inclination angle of 60°. 3. Medium bus and truck parking space: Width of 3.0 meters and length greater than 6 meters. 4. Large bus parking space: Based on the current design standards for large buses, which are generally around 10-12 meters in length, the width is ensured to be 4 meters, and the parking space length is determined considering the turning radius.
3
1
Share

Is it illegal to modify motorcycle exhaust?

Modifying a motorcycle's exhaust system is considered illegal modification. However, it's important to note: 1. Registration after modification: You must apply for modification registration at the local vehicle management office where the motorcycle is registered to avoid it being classified as illegal modification. 2. Consequences of not registering: If the motorcycle's engine type or exhaust pipe is modified without registration, you will be ordered to restore it to its original condition and may face a warning or fine. According to Article 16 of the Road Traffic Safety Law of the People's Republic of China, no unit or individual may engage in the following activities: 1. Modifying the vehicle structure: Assembling a motor vehicle or altering the registered structure, construction, or characteristics of a motor vehicle without authorization. 2. Changing the model, etc.: Changing the model, engine number, frame number, or vehicle identification number of a motor vehicle. 3. Forging marks: Forging, altering, or using forged or altered motor vehicle registration certificates, license plates, driving licenses, inspection qualification marks, or insurance marks. 4. Using others' motor vehicle documents: Using another motor vehicle's registration certificate, license plate, driving license, inspection qualification mark, or insurance mark.
2
0
Share

What is the ideal tire pressure for the Nissan X-Trail?

The standard tire pressure for the Nissan X-Trail ranges between 2.4-2.5 bar. Seasonal factors may influence this, with winter tire pressure appropriately increased by 0.2 bar and summer pressure reduced by 0.1 bar. These figures comply with the international GBT2978-2008 standard. Higher-end models of the Nissan X-Trail come equipped with a tire pressure monitoring and alert system, which displays real-time tire pressure data on the dashboard while driving. For other models, external instruments are required to check tire pressure, and it is advisable to inspect both tire condition and pressure before long-distance trips. Generally, a tire pressure exceeding 2.8 bar is considered too high, while a pressure below 2.0 bar is too low. Hazards of overinflation: Reduced tire friction and adhesion, impairing braking effectiveness; increased steering wheel vibration and drift, diminishing ride comfort; accelerated wear on the central tread pattern, shortening tire lifespan; heightened vehicle vibration, indirectly affecting other components' longevity; excessive stretching of tire cords, reducing elasticity and increasing driving load. Hazards of underinflation: Increased friction coefficient with the road surface, raising fuel consumption; heavier steering and drift, compromising driving safety; amplified movement across tire sections, causing abnormal heat from excessive rolling; degradation of cord and rubber functionality, leading to delamination, cord breakage, or rim friction damage; multiplied ground friction, rapidly escalating tire temperature and softening, drastically reducing strength. High-speed driving may result in tire blowouts. If the tire pressure monitoring indicator illuminates (a yellow symbol featuring an irregular circle without a seal, four small spikes below, and an exclamation mark inside), it typically indicates one of three causes: Abnormal tire pressure: Usually triggers an alert below 1.8 bar or above 3.0 bar, necessitating immediate inspection and adjustment. Unreset tire pressure monitoring: Failure to reset the system after inflation retains outdated data, causing the light to stay on. A simple reset resolves this issue. Damaged tire pressure sensor: Mounted internally and connected to the tire valve, physical impact can damage the sensor, requiring replacement to extinguish the warning light.
12
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.