How to turn off the always-on brake light of Dongfeng Fengguang 580?

1 Answers
VanAmir
07/29/25 11:48pm
You can check if the brake pads have worn to their limit. The brake light switch can be adjusted by removing, adjusting, and reinstalling it. It might be a faulty brake switch, which needs to be inspected. The switch is installed above the brake pedal.
Was this review help?
11
3
Share
More Forum Discussions

Are Polarized Sunglasses Suitable for Driving?

Polarized sunglasses are suitable for wearing while driving. Here are the specific details: 1. The function of wearing polarized sunglasses while driving: Polarized sunglasses can block glaring sunlight, ensuring the driver's safety. 2. Polarized lenses allow directional light to pass through: The lenses are unaffected by glaring sunlight, and polarized lenses can filter out dazzling glare caused by scattering, refraction, reflection, and other factors. Moreover, the overall ambient light does not significantly dim, which is crucial for drivers on the road. 3. After wearing polarized sunglasses, harmful reflections are filtered out: During driving, the glaring sun, various dazzling stray lights, and reflections from the rear windshield or chrome trim can be filtered out by polarized lenses, ensuring the driver is not affected by reflections.
15
5
Share

Where is the cabin air filter located in the Mazda5?

The cabin air filter in the Mazda5 is located under the dashboard in front of the front passenger seat, near the evaporator unit. The recommended replacement interval for the cabin air filter is generally every 12,000 kilometers. The replacement procedure for the Mazda5's cabin air filter is as follows: 1. The cabin air filter is installed behind the glove compartment. To replace it, first open the glove compartment lid. 2. Locate the fixing clip on the right side of the glove compartment and pull it outward firmly to remove it. 3. Use both hands to squeeze the sides of the glove compartment toward the center, and the glove compartment can then be removed. 4. Once the glove compartment is removed, you will see the cabin air filter cover. Press firmly on the fixing clips on both sides of the cover to remove it. 5. Pull the old cabin air filter outward. Install the new cabin air filter and reassemble everything in the reverse order of removal.
2
3
Share

How to Wire a Dash Cam?

Here are the wiring methods for a dash cam: 1. Cigarette lighter wiring. Simply plug it into the cigarette lighter, then route the wires through the glove box, A-pillar, etc. This method occupies the cigarette lighter, and since the wires in the glove box area cannot be hidden, a section of the wiring will be exposed. The advantage is that you can manually turn the dash cam on or off by simply unplugging the cigarette lighter or pressing the switch. 2. Direct battery wiring. Run the wires from the cabin into the engine compartment and connect them directly to the battery's positive and negative terminals. This method does not allow for manual power-off, making it inconvenient to turn off manually, and there may be issues with battery discharge. This method requires using the A-pillar to hide the exposed wires.
4
3
Share

What is the FAW-Volkswagen GTI?

Volkswagen GTI could be the Golf GTI or the Polo GTI. Here are some relevant details about the Volkswagen GTI: 1. The Golf GTI is equipped with a 2.0-liter turbocharged engine, codenamed EA888. This engine delivers a maximum power of 162 kW, a maximum torque of 350 Nm, with the maximum power achieved between 4,500 and 6,200 rpm and the maximum torque available from 1,500 to 4,400 rpm. 2. The Polo GTI uses a 1.4-liter turbocharged engine, which produces a maximum power of 110 kW and a maximum torque of 250 Nm. The maximum power is reached at 5,000 rpm, while the maximum torque is available between 1,750 and 3,500 rpm.
9
4
Share

What causes the engine to be very loud when the car just starts?

The main reasons why the engine is very loud when the car just starts are as follows: 1. When the vehicle is started cold, the temperature of various internal components is very low, and the engine oil inside the vehicle has flowed back into the oil pan due to prolonged parking, thus significantly increasing the starting noise. 2. During a cold start, the vehicle's RPM is much higher than normal, so the accompanying noise will also be relatively loud. Below are some related explanations: 1. It is normal for the vehicle to produce loud noises during a cold start, and there is no need to worry excessively. As the temperature of each component rises to the normal operating range, the noise will gradually decrease or even disappear. 2. If you are particularly concerned about the noise when the vehicle starts, you can take measures such as keeping the RPM around 1000 when the car just starts and avoiding high-speed driving for the first 5 minutes or so, which can minimize the noise to the greatest extent.
16
0
Share

Must the tires be straightened when parking?

When parking, the car tires must be straightened. Here are the detailed explanations: 1. Not straightening the tires on flat ground can damage the suspension and the hydraulic power steering gear: When parking on flat ground, the wheels bear the full weight of the car. If the tires are not straightened, the shock absorbers, lower control arms, and the rubber at the suspension connection points will be stretched or squeezed, leading to loose and deformed suspension. Additionally, the hydraulic power steering gear generates assistance through the pressure difference of the hydraulic oil. After the engine is turned off, the hydraulic oil pressure will disappear, causing the steering gear's rack and pinion to tighten, which may result in damage. 2. On slopes, the tires do not need to be straightened: Parking on a slope carries the risk of the car rolling backward. If the tires are angled, they can prevent the car from continuing to roll backward in case of such an event. 3. If the tires are not straightened, the sidewalls might get scratched: Issues like tire bulges or scratches often occur on the sidewalls, which are the thinnest and most fragile part of the tire. Once damaged, the tire can only be scrapped.
9
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.