How to Tell the Difference Between Lead-Acid Batteries and Lithium Batteries?

1 Answers
DeHeidi
07/29/25 8:31pm
Generally, lead-acid battery packs are larger in size, while lithium batteries are relatively lighter and more compact, making them easier to ride with and transport. It's hard to define which one is better, but consumers can choose high-quality batteries produced by reputable manufacturers based on their actual needs.
Was this review help?
20
0
Share
More Forum Discussions

Audi Q5 Sunshade Initialization Settings?

Turn on the ignition. Press and hold the sunshade button on the roof to close the sunshade, maintaining this position throughout the standardization process (approximately 20 seconds). During standardization, the sunshade first closes completely, then moves backward about 200mm. After the sunshade closes again, the initialization process is complete. Release the sunshade button.
2
3
Share

How to Check Where a Vehicle is Sealed?

You need to bring relevant documents for on-site inquiry. For example, the owner of the motor vehicle can bring their ID card and vehicle license to the vehicle management office to check the records, or they can go to the court's enforcement division to check the records. If the person subject to enforcement actively fulfills the court's judgment, they can apply to the court to lift the seizure after fulfillment is completed.
7
2
Share

What to Do When Several Warning Lights Come On After Vehicle Inspection?

After turning off the engine for 5-10 minutes, do not press the brake pedal. Simply press the start button once, or turn the car key halfway to the 'on' position without depressing the clutch. If only the engine warning light remains on, restart the vehicle and observe whether the engine warning light stays illuminated. If it remains on constantly, it is necessary to have it inspected at a 4S dealership.
14
0
Share

What to do if the trunk of Audi A3 cannot be opened?

First, release the rear seat hook from the steel plate, fold down the rear seat, and lift the fluffy cover inside the trunk, then pull it out and lay it down. Find a suitable-sized binder clip and clamp it onto the hook of the S-shaped linkage. If the binder clip is large enough, it will extend a few millimeters, which is sufficient. Once clamped, it will be very sturdy, and the trunk will open with a gentle pull.
13
5
Share

How to Set the BMW X5 Mirror Tilt Function in Reverse Gear?

First, you need to confirm that your vehicle is equipped with the automatic mirror tilt function. Select the side mirror you wish to set by pressing the mirror adjustment selection button (left or right). The selected mirror will automatically tilt down to the factory preset position. Use the 4-way adjustment button to set it to your desired position. Press and hold the seat memory button for about 2 seconds, step on the brake, shift into P gear, and press the mirror adjustment selection button once more to complete the setup.
18
2
Share

How to Replace a Solid Tire?

Park the vehicle on a nearly level and safe area, and turn on the hazard lights. If you experience a flat tire while driving, remember to stay calm and keep both hands firmly on the steering wheel. Loosen the wheel nuts in a diagonal pattern. Then, place the jack on the chassis support and slowly raise the vehicle until the tire is slightly touching the ground. Next, remove the tire from under the vehicle and slowly lower the jack. Once the tire touches the ground, tighten the nuts one by one in a diagonal pattern again.
13
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.