How to Take the Driving Test Subject 2 in Heavy Rain?

How to Install an Auxiliary Battery in a Sedan?

To install an auxiliary battery in a sedan, follow these steps: 1. Install a battery isolator; 2. Secure the auxiliary battery next to the main battery. The usage method is as follows: 1. When charging, connect the main and auxiliary batteries in parallel for simultaneous charging; 2. When not charging, the battery isolator automatically separates the main and auxiliary batteries, ensuring the main battery does not discharge when the auxiliary battery is in use; 3. In case of main battery failure or depletion, use the emergency auxiliary switch to draw power from the auxiliary battery to start the car. The functions of a car battery include: 1. Providing power to the starting system, ignition system, and electronic fuel injection system when starting the engine; 2. Supplying power to the car's electrical equipment when the engine is off or at low idle; 3. Providing power to electrical devices when the generator's output is insufficient.

17

3

Share

Where is the OBD interface located on the Chery A1?

The OBD interface of the Chery A1 is located under the hood, at the upper left corner of the engine, next to the battery. The steps to locate the OBD interface on the Chery A1 are as follows: 1. Open the car door; 2. Pull the hood release lever located on the left side near the driver's leg area; 3. Lift the engine hood and secure it with the support rod; 4. Locate the OBD interface at the upper left corner of the engine, next to the battery. OBD is a system that monitors the vehicle's operating status and promptly reports any abnormalities. It primarily monitors the engine condition and exhaust emissions, providing real-time data and standardized fault codes. Specialized equipment can be used to read the vehicle's OBD fault information and related data, which is also used as a criterion to determine whether the vehicle passes inspection.

9

3

Share

What Are the Causes of Severe Car Vibration?

Severe car vibration is caused by issues with wheel dynamic balance. Performing a dynamic balance test on each wheel can prevent car vibration. The steps for car dynamic balancing are: 1. Remove the lead weights from the rim and clean the rim thoroughly; 2. Mount the tire with the installation surface facing inward onto the balancing shaft, select the cone, and secure the tire with the locking device; 3. Turn on the balancer power and measure the rim data; 4. Rotate the tire until all position lights on the balancer light up, and continue until the balancer displays 0. The dynamic balance process is complete, and the tire can be removed. The benefits of dynamic balancing include: 1. Enhanced driving comfort; 2. Extended tire lifespan; 3. Improved straight-line stability of the vehicle; 4. Reduced wear on chassis suspension components; 5. Increased driving safety.

13

2

Share

How much engine oil should be added to a BMW X5?

BMW X5 requires 6.5 liters of engine oil. The replacement steps are as follows: 1. Lift the vehicle, remove the underbody panel, and place a container with a capacity of about 10 liters under the oil drain plug. 2. Unscrew the oil drain plug, use an air gun to blow for two minutes at the oil filler port, then tighten the oil drain plug after draining and wipe it with a tissue to check for oil leakage. 3. Reinstall the underbody panel and lower the vehicle, then use a funnel to add engine oil through the oil filler port. The dimensions of the BMW X5 are: length 4930mm, width 2004mm, height 1776mm, with a wheelbase of 2975mm. It is equipped with a 2.0T inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 260PS, maximum torque of 400Nm, and maximum power of 195kW, paired with an 8-speed automatic transmission.

17

5

Share

What are the causes of a generator carbon brush failure?

Generator carbon brush failure is caused by: 1. Contamination on the surfaces of the slip ring, carbon brush, brush holder, and brush frame; 2. Sticking of the brush holder edges or uneven spring pressure; 3. Excessive vibration in the unit's shaft system, causing the slip ring to vibrate as well. The solutions for generator carbon brush failure are: 1. Completely remove the burnt mica, eliminate grounding faults, fill the groove with asbestos thread, compact and smooth it, then continue using; 2. If the diode is damaged, cut its lead wire or replace the diode; 3. If the carbon brush is broken, remove it, shape the carbon rod from a dry battery into a carbon brush shape, cut a small groove at the top of the carbon brush, wind a wire around it, and use it as an emergency measure; 4. If the pulley is loose, insert hard objects such as iron wire into the half-round key to tighten the pulley and shaft, securing the pulley.

13

3

Share

Should the handbrake be released or pulled up?

Whether the handbrake should be released or pulled up depends on different situations: the handbrake needs to be released when starting the car and pulled up when parking. The function of the handbrake: it is used for braking when parking on flat ground or slopes to prevent the vehicle from sliding automatically when unattended, avoiding traffic accidents. The official name of the handbrake is the parking brake, which mainly controls the rear wheels. Its principle is based on the lever principle, using a steel cable to activate the rear wheel braking device, causing the locking tooth and gear to automatically engage. The dangers of driving without releasing the handbrake are: 1. The brake pump cannot provide sufficient braking force, causing the engine to stall; 2. Accelerated wear of the brake disc and hardening of the brake pads due to friction heat; 3. The handbrake cable may stretch; 4. It may lead to brake caliper oil leakage and brake failure.

20

2

Share

How to Take the Driving Test Subject 2 in Heavy Rain?

How to Install an Auxiliary Battery in a Sedan?

Where is the OBD interface located on the Chery A1?

What Are the Causes of Severe Car Vibration?

How much engine oil should be added to a BMW X5?

What are the causes of a generator carbon brush failure?

Should the handbrake be released or pulled up?

What colors are available for the 2019 New Sagitar?

How to Open the Car Door When the Golf Remote Control Runs Out of Battery?

How Often Are New Energy Vehicles Inspected?

Is the Impact of Replacing the Steering Knuckle on the Vehicle Significant?