How to Study After 6 Points Deducted from a B2 Driving License?

1 Answers
MackenzieDella
07/30/25 4:23am
Within 30 days after the end of the current scoring cycle, the person concerned must go to the vehicle management office with their ID card, driving license, and health certificate for study and review of the driving license. The following is extended information on the handling of point deductions for a B2 driving license: 1. Less than 12 points: If the traffic violation points in each scoring cycle (generally a 12-month period from the date of first obtaining the driving license) are less than 12 points, and there are no violations (any violations must be dealt with), the points will automatically reset to zero in the next scoring cycle. 2. 12 to 24 points: For the first time reaching 12 to 24 points (excluding 24), the driver only needs to pass the subject one test to clear the traffic violation points. For those who reach 12 points or more twice or accumulate 24 points (including) or more in the same cycle, they must pass both subject one and subject three tests each time before the traffic management department archives and clears the points. The period from the date of first obtaining the driving license to the same date the following year is considered one traffic violation scoring cycle.
Was this review help?
19
4
Share
More Forum Discussions

Why is there water dripping under the front of the car?

There are two possible reasons for water dripping under the front of the car: air conditioning system drainage and radiator leakage. The details are as follows: 1. Air conditioning system drainage: In summer, when the outdoor temperature is high and the air-conditioned car interior is cold, a temperature difference forms, causing water to drip from the chassis. The low-pressure pipes of the car air conditioning system are not wrapped with insulation foam, making the pipe surfaces prone to condensing moisture from the air. Water droplets will also condense and gather at the lowest point of the pipes and drip down. 2. Radiator leakage: The radiator is located next to the car engine. If the radiator connections are loose, leakage may occur. In this case, the dripping water will be colored, usually red or green.
9
5
Share

How to Permanently Disable the Auto Start-Stop Function in X-Trail?

X-Trail's auto start-stop function cannot be permanently disabled. It can only be manually turned off each time, and it will default to the enabled state upon the next startup. Here is some information about the X-Trail: 1. The X-Trail is a 4x4 vehicle designed for challenging terrains, with "TRAIL" symbolizing rugged roads, making it an SUV suitable for various road conditions. 2. The X-Trail is equipped with a 2.0L engine and a 2.5L engine, delivering 154 horsepower and 186 horsepower respectively, paired with a CVT transmission. 3. The X-Trail features front-wheel drive as standard, with an available four-wheel-drive version, distinguishing it from traditional off-road vehicles. 4. The X-Trail offers excellent interior space, ranking first among its peers in the same category.
5
0
Share

Where is the crankshaft position sensor located on the Audi A6L 2.4?

The crankshaft position sensor on the Audi A6L 2.4 is located in front of the firewall, where there are many connectors such as the mass airflow sensor and oxygen sensors. Functions of the crankshaft position sensor: 1. Detects engine speed to determine fuel injection quantity and ignition timing. 2. Identifies the reference position of the engine's reference cylinder for cylinder sequence discrimination, further determining the position of any piston. 3. Measures the rotation angle of the crankshaft to determine the position of any piston, thereby establishing the ignition and fuel injection timing. 4. In addition to controlling fuel injection and ignition, it is also used for idle speed control, exhaust gas recirculation control, and fuel evaporation control.
5
4
Share

What is the difference between 5W-30 and 0W-20?

0W-20 and 5W-30 are different types of engine oil, differing in aspects such as minimum temperature, high-temperature viscosity, and oil specifications. The differences are as follows: 1. Oil application: 0W-20 oil is more suitable for regions with consistently low temperatures throughout the year, while 5W-30 is better for areas with higher average temperatures. 2. Minimum starting temperature: The lowest operating temperature for 0W-20 oil is -35°C, whereas for 5W-30 oil, it is -30°C. 3. High-temperature viscosity: 0W-20 oil has slightly poorer high-temperature viscosity compared to 5W-30, making it less suitable for high-temperature conditions than 5W-30 oil.
18
5
Share

Does the Audi A4 come with a built-in dash cam?

Audi A4 comes with a built-in dash cam. The Audi A4 dash cam automatically starts and begins recording when the vehicle is turned on. When the memory card is full, it can automatically delete the earliest recordings and start looping. Different dash cam products have different appearances, but their basic components include: 1. Main unit: Includes a microprocessor, data storage, real-time clock, display, lens module, operation keys, printer, data communication interface, and other devices. If the main unit does not include a display or printer, it should have corresponding data display and print output interfaces. 2. Speed sensor. 3. Data analysis software. 4. Infrared camera, an essential component for night vision functionality.
18
2
Share

What is the reason for engine shaking at startup but not while running?

The reasons for engine shaking at startup but not while running are: 1. Damaged spark plugs, where the wear of the spark plug electrode gap leads to insufficient spark ignition, resulting in incomplete combustion of the air-fuel mixture; 2. Poor quality gasoline, causing poor atomization effect of the fuel injector and incomplete combustion of the mixture in the cylinder; 3. Dirty throttle body or excessive carbon buildup on the fuel injector; 4. Abnormal fuel pump supply pressure or incorrect and malfunctioning intake pressure sensor readings. The function of the engine is to convert thermal energy into mechanical energy by burning and expanding gas in a sealed cylinder, pushing the piston to do work, thereby providing power to the vehicle. The maintenance methods for the engine include: 1. Cleaning the air filter; 2. Removing sludge from the throttle body; 3. Cleaning carbon deposits from the fuel injector.
3
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.