How to Start the New BMW 3 Series?

1 Answers
PatrickDella
07/29/25 9:56pm
The method to start the new BMW 3 Series is: 1. Sit in the driver's seat and press the start button, the ACC light will turn on; 2. Press the start button again for the vehicle to perform a self-check; 3. Depress the brake and press the start button to ignite and start the engine; 4. Depress the foot brake, shift to D gear, and release the handbrake. The BMW 3 Series is a mid-size 4-door 5-seater sedan with body dimensions of: length 4719mm, width 1827mm, height 1459mm, and a wheelbase of 2851mm. It is equipped with a 2.0T turbocharged engine and an 8-speed automatic transmission, delivering a maximum power of 115 kW and a maximum torque of 250 Nm. Its drivetrain is front-engine rear-wheel drive, with front suspension using a double-joint spring strut front axle and rear suspension using a multi-link independent suspension.
Was this review help?
15
3
Share
More Forum Discussions

What are the hazards of P130A cylinder compression ratio fault with misfire in cylinder 1?

P130A cylinder compression ratio fault and misfire in cylinder 1 have the following hazards: 1. Decrease in engine speed and power: Abnormal engine operation or insufficient power; The engine operates unevenly and shakes rhythmically at high, medium, and low speeds, with black smoke emitted from the muffler. 2. Increased fuel consumption and emission pollution: Engine misfire may lead to phenomena such as high fuel consumption, black smoke emission, lack of power, decreased horsepower, inability to accelerate, and severe shaking. 3. Accelerated wear of moving parts: Shortens the service cycle of lubricating oil.
7
4
Share

What type of oil is used in rotary vane vacuum pumps?

Introduction to oil for rotary vane vacuum pumps: 1. General conditions: For applications requiring a total pressure above 6X10-2 Pa, high-speed vacuum pump oil produced in Shanghai is recommended. For small pumps below 4L/s, No.1 vacuum pump oil can be used as a substitute. For direct-drive pumps above 8L/s, No.3 diffusion pump oil can be used as an alternative. 2. If the vacuum requirement is not high: and oil contamination and replacement are frequent, or vacuum pump oil supply is difficult, No.50 mechanical oil can be used as a substitute. 3. If the ambient temperature is low: and starting is difficult with no high requirement for ultimate vacuum, vacuum pump oil or mechanical oil with slightly lower viscosity can be used.
15
1
Share

What Are the Consequences of a 6-Point Deduction?

A 6-point deduction on your driver's license has no impact as long as you do not accumulate 12 points within one cycle. According to regulations: If a motor vehicle driver's accumulated points do not reach 12 within a scoring cycle and all fines have been paid, the points will be cleared. However, if there are unpaid fines even if the points are below 12, the points will carry over to the next scoring cycle. The following behaviors result in a one-time 6-point deduction, as detailed below: 1. Driving a motor vehicle in violation of traffic signals (previously 3 points). 2. Operating a commercial passenger vehicle (excluding buses) or school bus with passengers exceeding the approved capacity by less than 20%, or driving other passenger vehicles with passengers exceeding the approved capacity by more than 20%. 3. Driving medium-sized or larger passenger vehicles or hazardous material transport vehicles on highways or urban expressways at speeds exceeding the limit by less than 20%. 4. Driving medium-sized or larger passenger vehicles or hazardous material transport vehicles on roads other than highways or urban expressways, or driving other motor vehicles at speeds exceeding the limit by more than 20% but less than 50%.
20
1
Share

What is the difference between S gear and L gear? How to use S gear and L gear?

Introduction to the differences between S gear and L gear: 1. Different nature: L gear is the low gear; S gear is the sport gear. 2. Different characteristics: In S gear sport mode, the gearbox delays the upshift timing, keeping the engine at high speed for a longer time, allowing the car to move at low gear and high speed for a longer time, thereby obtaining greater torque output and acceleration. When the user engages L gear, the car will not upshift and will continue to move forward at high speed and low gear, which can better pull cargo. 3. Different functions: L gear can be used to control speed, climb slopes with heavy loads, and increase traction when driving on muddy roads. S gear can be used for overtaking and acceleration, fully releasing the engine's power.
6
1
Share

How to Read the Refrigerant Pressure Gauge?

Introduction to reading the refrigerant pressure gauge: The automotive refrigerant pressure gauge typically has two dials, one blue and one red. The blue dial indicates low pressure, while the red dial indicates high pressure. Under normal operation of the air conditioning system, the low pressure should be between 1.0—2.5 bar, and the high pressure should be between 15—18 bar. If the low pressure is higher or lower than this range, it indicates abnormal expansion valve regulation or issues with the compressor's performance. Below are more details: 1. To measure the high and low pressure of the air conditioning system, the engine should be idling, and the measurement should be taken at an ambient temperature of 35℃, with the internal circulation air volume as the standard. 2. Normal high pressure: should be 1.3-1.7 MPa (13-17 kg/cm2 or 190-250 Lbf/in2). 3. Normal low pressure: should be between 0.20-0.25 MPa (2-2.5 kg/cm2 or 25-35 Lbf/in2), and must never exceed 0.25 MPa (approximately 2.5 kg/cm2).
4
4
Share

What are the speed limits for urban roads and highways with or without center lines?

For motor vehicles on roads without center lines, the speed limit is no more than 30km/h on urban roads and no more than 40km/h on highways. For motor vehicles on roads with center lines, the speed limit is no more than 50km/h on urban roads and no more than 70km/h on highways. Below is the relevant introduction: Reasons for speed limits on roads without center lines: Primarily for driving safety, these roads often have non-motorized vehicles present, so high-speed driving is not allowed. Especially on village or rural roads, extra caution is needed as there may be pedestrians crossing or animals appearing on the road. Driving too fast may result in insufficient time to avoid, leading to other traffic accidents. Moreover, these roads are generally narrow, and accidents often result in more severe consequences. Reasons for vehicle speed limits: Excessive vehicle speed can easily cause traffic accidents.
12
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.