How to Start the Engine of Qoros 5?
4 Answers
To start the engine of Qoros 5, after getting into the car, press the start button twice until the system is powered on. Wait for the self-check to complete, then press the brake and press the ignition switch. An engine is a machine that can convert other forms of energy into mechanical energy. It was invented in the UK and can be used either as a power generation device or to refer to the entire machine including the power unit. The Qoros 5 is equipped with a multimedia display, multifunction steering wheel, one-button start, and rear air vents. The dimensions of the Qoros 5 are 4600mm in length, 1869mm in width, and 1658mm in height, with a wheelbase of 2710mm. Its engine has a maximum horsepower of 197Ps, a maximum power of 145kW, and a maximum torque of 290Nm.
Driving the Qoros 5 is quite simple. Just sit in the driver's seat, press the brake pedal, and wait for the dashboard lights to come on. You don't need to take out the key—just press the start button on the center console with the circular arrow, and the engine will start with a hum. I used to start it with the key in my pocket, but if the key battery is low, it might not be detected. In that case, you'll need to place the key next to the logo near the start button. During cold starts in winter, the car will preheat itself for a few seconds, and the tachometer will show slightly higher RPMs. It's better to wait about half a minute until the idle stabilizes before driving off, as it's better for the engine. Also, make sure the gear is in P (Park) before starting, or the button won't respond.
Last time I drove my friend's Qoros 5, starting it was much more convenient than older cars. Just press the silver button on the right side of the steering wheel while stepping on the brake—no need to turn a key at all. At startup, all dashboard lights briefly illuminate for self-check, and after a few seconds when the warning lights go out, you can shift and drive. New drivers should note the key must be inside the car—once I forgot it on the back seat and couldn't start. Also, with auto start-stop enabled, the engine stops at red lights and restarts automatically when you press the accelerator at green lights, no need to press the button again. The car starts up quite quietly; if you suddenly have difficulty igniting, the battery might be low or the key fob battery needs replacement.
Starting the Qoros 5 is a two-step process: sit down and press the brake pedal, then press the start button. The button is located in front of the gear lever, the silver metal one. I usually press it once without stepping on the brake to power on the car first, let it complete the self-check, and then start the engine. The key can be sensed even when it's in your bag, but avoid placing it near your phone as it may cause interference. Turning on the air conditioner immediately after starting is not good for the engine; it's better to let the car run for a minute first. Remember to close the windows when starting on rainy days to prevent rainwater from splashing in.
