How to Start the Car in Subject 2?
3 Answers
Correct starting method for Subject 2: 1. Before starting, check whether the gear shift lever is in the neutral position. 2. Ignite and start the car, with both the clutch and brake fully depressed. 3. Engage the first gear, turn on the left turn signal, and release the handbrake. 4. If on flat ground, you can first fully release the brake, then slowly release the clutch to the semi-engaged state while gently pressing the accelerator pedal to start; if on a slope, you need to stabilize the brake and clutch to avoid stalling. Below is an introduction to Subject 2: 1. Subject 2 requires students to master the basic driving operation essentials and possess the basic ability to control the vehicle. They should be proficient in the basic methods of driving on the site and internal roads, have the ability to reasonably use vehicle control components and correctly control the spatial position of the vehicle, and be able to accurately control the vehicle's driving position, speed, and route. 2. If the Subject 2 test is failed, the applicant needs to first pay the retake fee at the vehicle management office and schedule a retake.
When starting the subject two (Parking Lot) driving test, I always remind students to first sit firmly in the car, adjust the seat distance to ensure easy pedal operation, and then adjust the rearview mirrors to clearly see behind them—no blind driving. The key step is to press the clutch pedal all the way down and confirm the gear is in neutral position; otherwise, the car may lurch forward dangerously upon starting. Then, use the right hand to turn the key or press the start button to ignite the engine. After starting, check the dashboard for any warning lights—if none, everything is normal. Don’t rush to release the clutch; let the car warm up for a few seconds until the RPM stabilizes. During the test, always fasten the seatbelt before starting—I’ve seen too many students forget this and lose all their points. Also, check if the doors are fully closed. Stay calm when starting; with more practice, it will become muscle memory. If a mistake occurs during startup, such as not pressing the clutch or stalling, immediately press the clutch again and restart without panicking—don’t let it affect your mindset. During regular practice, incorporate related techniques, such as lightly pressing the accelerator right after starting to feel its response. Mastering this step ensures a safe pass. Starting is just the beginning—focus more on the subsequent test items.
When I was learning to drive and taking the Subject 2 test, I often made silly mistakes when starting the car. First, I would sit down and adjust the seat to a comfortable position where my feet could easily reach the pedals. Then, I would confirm that the rearview mirrors were angled just right to see all around. Next, I would press the clutch pedal all the way down and always check that the gear was in neutral before turning the key to start the engine. I would hold my breath while starting, afraid of stalling. Only after a successful start would my heartbeat stabilize. After starting, I wouldn’t rush to move but wait a few seconds to let the engine warm up. Every time I practiced, I had to repeat this process. Before starting, I had to remember to fasten the seatbelt—I once forgot during the test and got scolded by the instructor. I also had to check if the doors were properly closed. If I made a mistake during startup, I would immediately try again without getting discouraged—practice makes perfect. The starting process is simple, but details determine success or failure. For example, after starting the engine, I had to observe the fuel gauge and air pressure. Don’t forget to combine these with the actual test conditions. A smooth start puts you in a good mood, making it easier to pass Subject 2.
