How to Start the Baojun 510 When the Key Fob Battery is Dead?

[PresleyDella]

To start the Baojun 510 when the key fob battery is dead, follow these methods: 1. Use the mechanical key to start the ignition; 2. Connect the ignition wire below the ignition switch to the starter wire. The steps to replace the key fob battery for Baojun 510 are: 1. Pull out the metal mechanical key; 2. Use a flathead screwdriver to pry open the key fob casing along the side gap to reveal the battery; 3. Remove the old battery, replace it with a new one, and reassemble the key fob casing. Taking the 2021 Baojun 510 as an example, its body dimensions are: length 4220mm, width 1740mm, height 1615mm, wheelbase 2500mm, fuel tank capacity 45l, luggage compartment capacity 318 to 1210l, and curb weight 1206kg.

[VonCarmen]

When my Baojun 510's key fob ran out of battery, I immediately recalled the solution from a similar situation last time—first, don't panic. Find the small mechanical key on the side of the fob, pull it out firmly, insert it into the tiny hole on the door handle, and twist to unlock. Then, get inside the car, place the entire key fob near the start button, and press—the engine should start. This trick works for most car models, and the Baojun 510 manual mentions a sensing area near the button where a depleted key fob can still be detected if placed close enough. After starting, promptly replace the battery to avoid future hassles. I always keep spare CR2032 batteries in the car for emergencies—a small habit that saves big headaches. Never force the start button in such cases, as it might lock the system; consulting an authorized service center is wiser.

[Tess]

I've personally experienced the issue of a key fob running out of battery. When I first bought the Baojun 510, I didn't know what to do and fumbled around. Later, I learned the tricks: First, check the mechanical key slot on the side of the key fob, pull out the small piece and insert it into the door lock to unlock. Second, sit in the driver's seat, press the key fob tightly against the start button, hold it for two seconds, and the car will start with a hum. Third, changing the battery is super easy—just open the key cover, pop out the old battery, and insert a new CR2032. I think many people overlook reading the manual. The Baojun 510 manual explains how to start the car in an emergency, and there are online videos teaching it too. Preparing in advance saves you from getting stuck on the road. Also, pay attention to the car's power stability to avoid voltage fluctuations causing other issues. Carrying spare keys and batteries is the most reliable. During regular car maintenance, check the key fob's condition—don't neglect these small safety details.

[MacMatteo]

When my Baojun 510 key fob ran out of battery, I followed the manual's instructions: I pulled out the mechanical key, inserted it into the door lock to open the car, then placed the key close to the start button and tried a few times until the engine started. The process was quick, but don't forget to replace the CR2032 battery afterward, or you'll face the same hassle every time you start the car. I also noticed that occasional poor key detection might be due to environmental interference—moving away phones or metal objects before trying again can help. Regularly checking the key fob can prevent such issues. This simple and practical experience is worth sharing with you.