How to start an Audi A4 with the key?

1 Answers
DeEmilia
07/24/25 6:00pm
Audi A4 key starting method: 1. Press the black buttons on both sides of the top of the remote control, then pull out the mechanical key; 2. The remote key sensing area of the Audi A4 is located at the front left of the gear lever, which is the right side of the steering wheel, or in some models, inside the center armrest storage compartment; 3. After placing the remote key on the sensing area, press the brake and hold the one-touch start button for 3 to 5 seconds until the engine starts normally. For older Audi A4 models without a one-touch start button, insert the mechanical key into the ignition keyhole and rotate the remote key clockwise one full turn to start the vehicle. The Audi A4 is a B-class vehicle manufactured by FAW-Volkswagen. In terms of powertrain, the Audi A4 3.0 comes standard with Audi's patented quattro all-wheel-drive system, providing the vehicle with double the traction.
Was this review help?
19
0
Share
More Forum Discussions

What is the brake warning light?

brake is the brake system warning light. The braking device generates friction between the brake pads and the drum or disc, converting the kinetic energy of the moving vehicle into heat energy during the friction process, thereby dissipating it. The brake system consists of the control system, hydraulic system, and power assist system. Most small vehicles use hydraulic braking because liquids are incompressible and can transmit force almost 100%. The basic principle of hydraulic braking is: when the driver presses the brake pedal, pressure is applied to the brake fluid in the master cylinder. The liquid transmits the pressure through the pipelines to the pistons of the brake calipers on each wheel. The pistons drive the brake calipers to clamp the brake discs, generating significant friction to slow down the vehicle.
3
4
Share

What are the three pedals of a dual-clutch transmission?

The three pedals of a dual-clutch transmission are the parking brake device, brake pedal, and accelerator pedal. The parking brake device, also known as the foot brake, replaces the handbrake on the center console. This design aims to save space on the center console for additional storage compartments. The parking brake is commonly referred to as the handbrake, and its function is to provide resistance to the car when parked, preventing it from rolling. The brake pedal is the pedal that limits power, also known as the foot brake (service brake), used for deceleration and stopping. The accelerator pedal is a car accessory that allows the driver to operate the pedal more comfortably, enhancing driving safety. Most accelerator pedals are designed with aluminum alloy, and adding an accelerator pedal cover can significantly increase the vertical contact area of the pedal.
4
3
Share

What does shiftlock mean in a car?

Shiftlock in a car refers to the gear shift lock, where 'shift' means gear shifting and 'lock' means locking. Usage: Pressing the shiftlock button can release the gear lock, allowing free switching from P gear to D gear without starting the circuit. Shiftlock: Shiftlock is a specialized device that unlocks under specific circumstances. For example, when the vehicle cannot start due to a dead battery and is stuck in P gear, pressing the shiftlock button allows the gear lever to move to N gear, enabling the vehicle to start. This feature is present in all automatic transmission vehicles.
9
2
Share

What is the principle behind the 3-minute illegal parking capture by electronic surveillance?

The principle behind the 3-minute illegal parking capture by electronic surveillance is: When a vehicle enters a no-parking zone, the electronic surveillance automatically takes a photo. If the vehicle leaves within 3 minutes, the photo is automatically deleted; if the vehicle remains parked for more than 3 minutes, the electronic surveillance captures the photo and uploads it along with the previous photo to the relevant traffic authorities for violation assessment and subsequent penalties. Electronic surveillance, also known as electronic police, is the colloquial term for the 'Intelligent Traffic Violation Monitoring and Management System'. It was successfully developed in Shenzhen in 1997 and has been gradually promoted for use since then. Electronic surveillance utilizes various technologies such as vehicle detection, photoelectric imaging, automatic control, network communication, and computer technology to monitor violations such as running red lights, driving in the wrong direction, speeding, crossing lines, and illegal parking. It operates around the clock to capture images and information of traffic violations, which are then processed after the fact based on the violation data.
19
3
Share

Can Subject One be scheduled for two days at the same time?

Subject One can be scheduled for two days at the same time, with a maximum scheduling period of 5 days. This is to increase the probability of successful scheduling. Once one appointment is successfully scheduled, the others will be automatically canceled. Subject One Exam Content: Basic knowledge of motor vehicles; laws, regulations, and road traffic signals; basic knowledge of safe driving and civilized driving; fundamental knowledge related to motor vehicle driving operations. Subject One Passing Score: The total duration of the Subject One exam is 45 minutes. The exam consists of 100 questions, including true/false and multiple-choice questions, with a full score of 100 points. A score of 90 or above is required to pass. The exam questions are randomly selected and combined by the computer driver examination system according to the proportion specified in the "Motor Vehicle Driver's License Work Regulations." Subject One Exam Attempts: There is no limit to the number of attempts for Subject One. Each exam session offers two chances. If both attempts fail, the exam must be rescheduled.
16
3
Share

The Probability of Passing the Subject Three Test in One Attempt

Subject Three pass rates vary, generally ranging between 40% to 70%. Subject Three, which includes the road driving skills test and the safety and civilized driving knowledge test, is part of the motor vehicle driver's license assessment. It is the abbreviated name for the road driving skills and safety and civilized driving knowledge test subjects in the motor vehicle driver's examination. Additional Information: Notes for the Subject Three Test: If a candidate's fingerprint verification fails, they should exit the vehicle to re-collect their fingerprint before rejoining the queue for the test. During the test, if a candidate's score falls below the passing threshold, the system will automatically prompt the candidate to pull over. Once the pulling over action is completed, the system will prompt the candidate to proceed with the next test.
9
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.