How to Start a Nissan Sylphy Automatic Transmission?
1 Answers
Starting steps for Nissan Sylphy automatic transmission: First, press the start button, step on the brake, then shift from P to D gear, release the brake, and start. Below is an introduction to starting an automatic transmission: 1. The driver sits properly in the driver's seat, without stepping on the brake, directly presses the start button, at this time the ACC light turns on, press the start button again, and the vehicle performs a self-check. Note: It is recommended not to skip the self-check step every time during a cold start, while a hot start can choose to skip. 2. Step on the brake, then press the start button to ignite and start. Normally, pressing the ignition switch for 3 seconds can start the engine. If the engine is difficult to start, do not start frequently; let the engine rest for a while every 5 attempts to avoid burning out the starter. 3. Release the foot brake. You can choose to warm up the car in place, and the time can be determined according to the environment. Specifically, you can look at the water temperature gauge on the dashboard. When the water temperature reaches and stabilizes at around 90 degrees, it means the warm-up is complete. 4. Step on the foot brake again, shift to D gear, and release the handbrake. Before starting, observe the road conditions clearly through the rearview mirror to see if it is suitable to start, and also honk the horn and turn on the turn signal to alert other vehicles and pedestrians. 5. Slowly release the foot brake and start. After starting, you should quickly enter the road and drive at the prescribed speed.