How to Start a Car After It Stalls in Water?
1 Answers
After a car stalls in water, it can only be started after being towed out of the water and the moisture is cleared. More knowledge about vehicle wading is as follows: 1. Before wading: Before driving through water, observe the depth, flow direction, and speed of the water, and determine if there are obstacles such as mud or quicksand underwater. Before wading, wrap the distributor and high-voltage wires with plastic film, etc. Pay attention to the route and speed of the vehicle ahead to judge whether your car can pass by observing the depth of the accumulated water. 2. In the water: For hard roads, engage a low gear and slowly drive into the water. While driving, hold the steering wheel steady and maintain a steady throttle to ensure the car has sufficient and stable power to pass through in one go. Avoid stopping, shifting gears, or making sharp turns midway, especially if the underwater road is sandy or muddy. If the wheels slip or sink, do not accelerate suddenly to rush through. Instead, with the engine still running, seek assistance from manpower or other vehicles to drive out of the water area. Since water pressure is much lower than the exhaust pressure of the cylinder, as long as the vehicle does not stall, water will not flow back into the engine. 3. After wading: Immediately remove the waterproof coverings from the electrical parts, dry the wet areas, and reinstall the fan belt. Check each gearbox for water ingress, ensure there are no debris blocking the radiator fins of the water tank, inspect the tires for damage, and remove any water weeds tangled under the chassis. Clean the vehicle promptly to restore braking effectiveness. Do not attempt to start the car until it is confirmed that the electrical system, engine components, and other parts are free from water ingress to avoid causing greater damage.
