How to solve the overly upright rear seats in Q5L?

1 Answers
Pamela
07/28/25 2:42pm
Adjust the seat headrest so that the back of your head rests exactly on the most protruding part of the headrest. Adjust the seat height according to personal preference, leaving a fist's distance between the top of your head and the car roof. Lean against the backrest, extend your arms straight to rest on the upper edge of the steering wheel, with each hand holding the steering wheel at the three and nine o'clock positions, keeping your arms naturally bent.
Was this review help?
5
4
Share
More Forum Discussions

What to Do When a Car Won't Start?

Jump-starting: Bring two vehicles close together, connect the positive and negative terminals of their batteries, turn off all auxiliary electrical equipment in the vehicles, and start the vehicle with the dead battery. After starting, lightly press the accelerator pedal, turn off the ignition switches of both vehicles, and carefully remove the cables. Push-starting: Utilize a downhill slope, turn on the ignition switch before pushing the vehicle. Once the desired speed is reached, shift the transmission into second gear, quickly release the clutch pedal, and apply throttle. Analysis of Fault Symptoms: If a whirring sound is heard when the starter drive gear engages with the engine flywheel ring gear during startup, there are two possible causes: First, the engagement surface of the flywheel ring gear may be deformed. Second, the gap between the starter drive gear and the flywheel ring gear may be too large. If they cannot mesh properly, the engine will not start. When the main power switch is turned on, the starter drive gear engages with the flywheel ring gear and rotates together. This issue can arise due to two reasons: First, the holding coil of the starter solenoid may be incorrectly connected to the power terminal. Second, the three wires on the ignition switch may be misconnected. The diagnostic method is as follows: When the key is in the "0" position, the starter drive gear does not rotate; when in the "2" position, the starter motor drive gear engages with the flywheel ring gear and rotates together. If the engine does not start when the ignition switch is turned to the start position and no other symptoms appear, the possible causes are: First, the key or switch may be worn out and fails to complete the starter circuit. Second, the starter relay may not be connecting the starter solenoid circuit. Third, the power switch may not be completing the main circuit. Using a screwdriver to bridge the terminals at the rear of the starter can complete the starter circuit, allowing the engine to start. Testing the Starting System: The starting system's circuit generally includes the following basic components: the battery, the starter motor, and the cables connecting these parts. Additionally, the ignition switch, starter relay, solenoid coil, and the vehicle's anti-theft system are also critical components of the starting system. Malfunctions in any of these parts can lead to difficulty starting the engine or complete failure to start.
7
0
Share

Do the speed display screens on highways take photos?

The speed display screens on highways do not have the function of capturing speeding violations. Speed reminder screens: They are designed to provide speed feedback to drivers. In fact, the complete system of a speed reminder screen consists of a speed measurement screen (the core speed measurement and display component) and a speed limit sign. Each sign features a prominent number indicating the speed limit for that lane. When a detected vehicle exceeds this speed limit, the speed displayed on the LED screen turns red to alert the driver. Principle: The speed reminder screen is composed of a radar and an LED screen, operating on the principle of radar speed measurement. When a vehicle enters the radar detection zone, the radar continuously emits electromagnetic waves towards the moving vehicle, which are then reflected back. The speed of the detected vehicle is calculated based on the frequency difference between the emitted and reflected waves.
5
1
Share

Which car models feature suicide doors?

Car models featuring suicide doors include: Mazda RX-8, BMW i3, Lincoln Continental, MINI, Honda Land Cruiser, etc. Toyota Land Cruiser: The 4.0L Toyota Land Cruiser Automatic GX-R is equipped with a 5-speed automatic manual transmission, with a top speed of 190 km/h, maximum torque of 385 N·m, and peak torque at 4400 rpm. The front suspension features a double-wishbone independent suspension with coil springs, while the rear suspension adopts a four-link non-independent suspension. Hyundai Coupe: The Hyundai Coupe sports car was developed based on the HCD-II concept vehicle. The concept car was powered by a 5.0L V8 engine, delivering maximum power of 309 kW at 6000 rpm and peak torque of 518 N·m. Available colors include Emerald Black, Obsidian Black, Tungsten Gray, Topaz Brown, Coral Red, and Pearl White.
5
2
Share

Is it safe to drive on the highway with a tire pressure of 2.9 bar?

It is not recommended to drive on the highway with a tire pressure of 2.9 bar. A tire pressure of 2.9 bar is already quite high, which can easily lead to tire blowouts and increased braking distances, posing significant dangers. Introduction to standard tire pressure: According to the international GBT2978-2008 standard, the recommended tire pressures for different types of tires are as follows: Standard tires: 2.4-2.5 bar; Reinforced tires: 2.8-2.9 bar; Maximum pressure: should not exceed 3.5 bar. The hazards of excessive tire pressure include: Reduced friction and adhesion of the tires, affecting braking performance; Increased steering wheel vibration and deviation, reducing driving comfort; Accelerated wear of the central tread pattern, shortening tire lifespan; Increased vehicle vibration, indirectly affecting the lifespan of other components. Additionally, it reduces the contact area between the tires and the road, diminishing the vehicle's handling and driving stability.
9
5
Share

What is the approximate temperature for 60% oil heat?

During normal vehicle operation, the engine's standard working temperature for oil is approximately between 90~110 degrees Celsius. Therefore, 60% oil heat should be in the range of 70-90 degrees Celsius. Before reaching normal temperature: The engine's standard working temperature is around 90~110 degrees Celsius. Before reaching this temperature, the fuel supply system remains cold, making it difficult to fully vaporize gasoline efficiently. Under such conditions, combustion is less effective for engine startup. During this phase, the engine relies on the choke valve to restrict some air from entering the cylinders, increasing the fuel-air mixture ratio and raising the engine speed to prevent stalling. After reaching normal temperature: Once normal operating temperature is achieved, the automatic choke valve returns to its standard position through mechanical action. Hence, for vehicles that have been idle for extended periods, it is advisable not to drive within the first minute after startup. Instead, let the engine idle for about a minute to warm up.
12
0
Share

What are the consequences of driving 20 kilometers without engine oil?

When a car continues to drive without engine oil, the lubrication effect becomes very poor. In severe cases, the lack of lubrication can cause the engine to seize. The less oil there is, the more severe the consequences will be. When the engine is started again, dry or semi-dry friction may occur between the cylinder and piston, accelerating the wear of parts and significantly increasing the resistance during startup, making it difficult to start. Functions of engine oil: Lubrication: The primary function of engine oil is to provide proper lubrication to the engine's pistons, bearings, and other components; Sealing: During the "power" stroke of the engine, it prevents high-temperature and high-pressure gases in the combustion chamber from leaking into the crankcase through the gap between the piston and cylinder. Symptoms of a car without engine oil: The oil light on the dashboard will illuminate. Therefore, when the oil light comes on, engine oil should be added immediately; Elevated water temperature and valve noise; There may also be knocking sounds in the engine.
13
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.