How to Solve the Oil Burning Issue in Tiguan?

1 Answers
LaElla
07/29/25 3:32pm
Here are the solutions: 1. Use high-quality engine oil: Engine oil is prone to corrosion and aging under prolonged high temperatures, causing the oil film to thin and more likely to enter the combustion chamber. Using high-quality engine oil can delay this phenomenon. 2. Pay attention to the cleanliness of the fuel system: Carbon deposits are generated during fuel combustion, which are the root cause of various car problems, such as aging of valve seals and increased piston-cylinder wall gaps. Maintaining the cleanliness of the fuel system is very helpful in solving and preventing oil burning issues. 3. External assistance: The cleanliness of the fuel system and the anti-aging properties of the engine oil are key factors in solving and preventing oil burning issues. This requires the use of high-quality engine oil and fuel additives.
Was this review help?
11
3
Share
More Forum Discussions

Where is the water added in a car?

Car water is added to the car radiator, which consists of three parts: the inlet chamber, the outlet chamber, the main plate, and the radiator core. It is located on the right side of the engine compartment next to the windshield washer fluid filler port. The radiator cap has a warning sign to open carefully and beware of burns. The function of the car radiator is: the coolant flows inside the radiator core, and air passes outside the radiator core. The hot coolant dissipates heat to the air and cools down, while the cold air absorbs the heat dissipated by the coolant and warms up, thereby achieving heat exchange. The reasons for a car radiator lacking water are: 1. Water pipe joints or the pipes themselves leak; 2. The engine block has cracks, the cylinder head gasket is not tight or damaged, causing water leakage; 3. The oil cooler seal is damaged or has sand holes, leading to water leakage; 4. The radiator cap is not tight; 5. The heater radiator leaks; 6. The three-way pipe leaks.
14
3
Share

What to Do When the Dashboard Warning Light Comes On and Power Loss Occurs?

In the event of a dashboard warning light indicating a fault and power loss, you should immediately stop the vehicle and call for a tow truck or wait for assistance. For safety reasons, do not attempt to continue driving. There are three main reasons why the engine warning light may come on, accompanied by insufficient power or a complete loss of power: 1. Poor combustion of the air-fuel mixture in the engine: When the mixture in the cylinders is too rich, the vehicle may experience knocking or shaking. Conversely, if the mixture is too lean, the vehicle may exhibit poor acceleration. 2. Issues with the air-fuel mixture: This could be due to faults in the spark plugs, high-voltage wires, or ignition coils. Poor performance in the ignition system or weak sparking from the spark plugs can also trigger the engine warning light, causing the vehicle to shake and lose power. 3. Abnormal fuel supply pressure or faults in the intake pressure sensor: If the fuel pump's supply pressure is irregular or the intake pressure sensor provides incorrect readings or malfunctions, it can lead to vehicle shaking and insufficient power.
18
2
Share

What is the difference between the S gear and D gear in an automatic car?

D gear stands for Drive, while S gear represents Sport mode. Below are the specific differences between D gear and S gear: 1. Performance: D gear is the standard forward gear found in all automatic transmissions. When engaged, the vehicle's computer shifts gears according to preset programming, maintaining a consistent driving state. In contrast, S gear isn't limited to automatic transmissions but also includes semi-automatic (manual-automatic) options. As a sport mode, it's designed for dynamic driving. When S gear is selected, the computer alters its shifting logic - delaying upshifts to deliver stronger power output. Additionally, S gear allows manual gear changes, either via paddle shifters or by pushing/pulling the gear lever. 2. Fuel consumption: S gear consumes more fuel due to prolonged lower-gear operation with increased fuel injection. D gear offers better fuel efficiency compared to S gear, though with less immediate power response. 3. Usage scenarios: S gear is primarily used for overtaking maneuvers, while D gear is employed when returning to the original lane after completing an overtake.
19
5
Share

Where is the hidden keyhole of the Zotye T600?

The mechanical keyhole of the Zotye T600 is installed on the driver's side door. You can see the keyhole by prying open the rear cover of the left outer handle with the key. The Zotye T600 key is for a car with a one-button start. If the one-button start fails, you can use the mechanical key to open the door. Here is some related information: The Zotye T600 remote key mainly consists of two parts: the transmitter and the receiver: 1. Transmitter: Composed of a transmission switch, transmission antenna (keypad), integrated circuit, etc. It contains an identification code storage circuit and an amplitude modulation circuit, with a button-type lithium battery installed on the opposite side of the circuit. The transmission frequency is selected according to the radio standards of the country of use, and the transmission switch sends a signal each time the button is pressed. 2. Receiver: After the transmitter sends the identification code using shortwave modulation, it is received by the car's shortwave antenna and enters the shortwave high-frequency amplification processor of the receiver's electronic control unit through a distributor for demodulation. The demodulated identification code is then compared; if it is the correct code, it is input into the control circuit to activate the actuator.
10
3
Share

How to Deal with a Malfunctioning Octavia Sunroof Switch?

If the sunroof switch malfunctions, it may be due to an issue with the sunroof control button's microprogram. Performing an initialization of the sunroof control button can resolve this. The initialization procedure is as follows: Turn on the ignition switch and ensure the sunroof is fully closed. If the sunroof cannot close normally, you can use either electrical or mechanical force to close it. Press and hold the sliding or tilt switch and operate the sunroof in the following sequence: tilt up → hold for about 1 second → tilt down → slide open → slide close. The initialization is then complete. Here is additional relevant information: 1. After completing the setup, verification is necessary. Check whether the sunroof has automatic open/close functionality and whether it has an anti-pinch feature. Engage the parking brake and close the sunroof. Press and hold the "UNLOCK" button on the remote for more than 2.4 seconds to check if the sunroof opens automatically. After opening, press and hold the "LOCK" button for more than 2.4 seconds to check if the sunroof closes automatically. If these checks are unsuccessful, reinitialize the sunroof. 2. Octavia Sunroof Closing Method: Disconnect the negative battery terminal, wait for ten minutes, then reconnect it. Open the sunroof fully and hold the switch for 3 seconds. Then close the sunroof fully and hold the switch for another 3 seconds. The manual reset learning is now complete. Pay attention to the lubrication of the sunroof tracks. Insufficient lubrication can lead to noise, poor movement, incomplete closure, or even jamming and misalignment over time, potentially damaging the motor.
16
1
Share

Can motorcycles be equipped with ETC?

Motorcycles cannot be equipped with ETC. How ETC works: Through the on-board electronic tag installed on the vehicle's windshield, dedicated short-range communication is established with the microwave antenna in the ETC lane at the toll station. Computer networking technology is used for backend settlement processing with the bank, enabling vehicles to pass through highway or bridge toll stations without stopping while paying the required fees. ETC usage precautions: The ETC transaction sensing range is 8 meters. When the vehicle in front stops, to prevent issues such as a malfunctioning ETC device or no ETC device at all, maintain a distance of more than 10 meters to avoid automatic fee payment for the vehicle ahead. The recognized speed for ETC lane passage is 20km/h. Driving too fast may prevent the system from reading the vehicle's device information, leading to failed fee deductions. Unauthorized removal or movement of the OBU device, or detachment/loosening of the ETC electronic tag, can render the tag ineffective. It can be taken to the bank where the ETC card was issued or the highway service office for inspection. If the detachment/loosening is not due to human error, reactivation may suffice. When using a debit card linked to ETC, insufficient balance can cause fee deduction failure. Follow the guidance of on-site staff to use the manual MTC lane, paying with cash or card. Excessively thick car windshields can lead to poor signal reception. This is particularly important for vehicles that have had their windshields replaced after accidents or for those with modified front windshields.
17
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.