How to solve the Honda nokey issue?

How serious is the engine knocking sound issue?

This is a very serious issue that requires immediate inspection at a repair facility. Below is relevant information about engine knocking: Definition: Engine knocking refers to a phenomenon where metallic knocking sounds occur when the pressure rise rate inside the cylinder is too high. Engine knocking is categorized into combustion knocking and mechanical knocking. Sharp metallic knocking sounds near top dead center caused by combustion issues are called combustion knocking or hot knocking. Dull heavy knocking or friction sounds caused by abnormal clearances between moving parts and bearings are called mechanical knocking or cold knocking. Causes: Poor lubrication conditions, low oil pressure or excessively low oil viscosity, inadequate splash lubrication on cylinder walls preventing normal oil film formation between piston and cylinder wall, resulting in direct contact between piston and cylinder causing knocking.

1

3

Share

How Often Should a Car Battery Be Replaced Normally?

It is normal to replace a car battery every 3 to 5 years. Here is more information: Signs for Car Battery Replacement: Check the internal resistance and voltage of the battery. If both the internal resistance and voltage fail to meet the specified values, it indicates that the battery needs replacement. If the voltage drops below 10V during discharge, it may suggest that the battery has broken cells and must be replaced. The lower the voltage under load, the greater the internal resistance of the battery, indicating poorer discharge characteristics. Types of Car Batteries: Car batteries are categorized into conventional batteries, dry-charged batteries, and maintenance-free batteries. A car battery, also known as a storage battery, is a type of battery that works by converting chemical energy into electrical energy.

9

3

Share

How Long Does It Take to Check Traffic Light Violations?

Traffic light violations can typically be checked online within five working days. Here is more information: Methods to check traffic light violation results: You can check through online vehicle violation queries, or visit the vehicle management office or traffic police station. Note that when visiting the management office, bring the vehicle's registration certificate and driver's license for the vehicle that ran the red light. Penalties for traffic light violations: Running a red light refers to the act of a motor vehicle violating the prohibition of passage during the red light phase at a signal-controlled intersection or road section, crossing the stop line and continuing to drive. According to the latest revised "Regulations on the Application and Use of Motor Vehicle Driving Licenses," running a red light results in 6 penalty points and a fine.

2

4

Share

Will roadside parking result in penalty points?

Roadside parking will incur penalty points if it constitutes illegal parking. Here is more information: Penalties for illegal roadside parking: Illegal parking refers to situations where a vehicle violates Article 63 of the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China," meaning parking in an unauthorized location. Parking by the roadside in violation of prohibition signs will result in fines and penalty points. Correct roadside parking method: Always park within marked parking spaces when parking roadside. Parking outside the lines or failing to park within a designated space is not allowed. If roadside parking spaces are scarce, park in a parking lot instead, and remember not to violate prohibition signs.

5

2

Share

What is the valve adjustment mnemonic for a 6-cylinder engine?

The firing order is 1-5-3-6-2-4. When piston No.1 reaches top dead center (TDC), you can adjust the intake and exhaust valves of cylinder No.1, the exhaust valves of cylinders No.3 and No.5, and the intake valves of cylinders No.2 and No.4. After rotating the crankshaft one full turn, when piston No.6 reaches TDC, you can adjust the intake and exhaust valves of cylinder No.6, the intake valves of cylinders No.3 and No.5, and the exhaust valves of cylinders No.2 and No.4. Below is an introduction to valve knowledge: Composition: A valve consists of a valve head and stem. The valve head operates at extremely high temperatures (intake valve: 570~670K, exhaust valve: 1050~1200K) and withstands gas pressure, valve spring force, and inertial forces from transmission components. With poor lubrication and cooling conditions, valves must possess sufficient strength, stiffness, heat resistance, and wear resistance. Intake valves are typically made of alloy steel (chromium steel, nickel-chromium steel), while exhaust valves use heat-resistant alloys (silicon-chromium steel). To conserve heat-resistant alloys, some exhaust valves feature a heat-resistant alloy head welded to a chromium steel stem. Current Status: To improve intake and exhaust efficiency, modern engines commonly employ multi-valve technology. The most prevalent configuration is four valves per cylinder (though some designs use 3 or 5 valves per cylinder with the same principle, such as Audi A6 engines), totaling 16 valves for a 4-cylinder engine.

16

4

Share

Does Higher Turbocharger Pressure Mean More Horsepower?

Higher turbocharger pressure does result in more horsepower. Introduction to automotive turbochargers is as follows: Purpose of turbocharging: Turbocharging refers to the technology of compressing air before supplying it to the cylinders to increase air density and intake volume, aiming to enhance air charge, boost power, improve fuel economy, and reduce emissions. Classification of turbochargers: Turbochargers specifically refer to engine intake turbochargers, which come in three forms: exhaust gas turbochargers, mechanical turbochargers, and electrically assisted turbochargers. Currently, the most widely used is the engine exhaust gas turbocharger.

3

Share

How to solve the Honda nokey issue?

How serious is the engine knocking sound issue?

How Often Should a Car Battery Be Replaced Normally?

How Long Does It Take to Check Traffic Light Violations?

Will roadside parking result in penalty points?

What is the valve adjustment mnemonic for a 6-cylinder engine?

Does Higher Turbocharger Pressure Mean More Horsepower?

How Many Kilometers Should a Vehicle Be Driven Before Scrapping?

How many points are deducted for not wearing a seatbelt on the highway?

Should the Car Be Turned Off When Refueling?

Do I need photos for a driver's license renewal?