How to Shift Gears Up and Down in a Manual Transmission?

Is it better to use 92 or 95 octane fuel for the Touran?

The Volkswagen Touran 1.4T uses 92 octane, while the 1.8T uses 95 octane. These fuel grades are recommended in the vehicle's official user manual. In addition to checking the appropriate fuel grade in the user manual, the Touran's fuel cap will also indicate the recommended grade. You can also determine the fuel grade based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane, those between 10.0-11.5 should use 95 octane, and those with higher compression ratios should use 98 octane. However, with the use of new technologies, the compression ratio alone cannot determine the fuel grade, as high-compression engines can be tuned to use lower-octane fuel. Other factors, such as ignition timing, turbocharging technology, and Atkinson cycle technology, also play a role. Generally, the higher the fuel grade, the higher the octane rating and the better the anti-knock performance. 92 octane fuel contains 92% isooctane and 8% n-heptane, while 95 octane fuel contains 95% isooctane and 5% n-heptane. If you accidentally use the wrong fuel grade in the Touran, simply switch back to the correct grade after the current tank is used up. However, long-term use of the wrong fuel grade can have the following effects: Using a higher octane fuel in a vehicle designed for lower octane will not cause damage, but the increased octane rating can alter the fuel's ignition point, leading to delayed combustion. This reduces the engine's power output and thermal efficiency, resulting in poorer performance. Using a lower octane fuel in a vehicle designed for higher octane can cause engine knocking. The lower octane rating reduces the fuel's ignition point, causing it to ignite prematurely during the compression stroke. If the fuel ignites before the spark plug fires, resistance occurs during the upward stroke, making the engine run very unevenly. Mild knocking may only increase noise without significant engine damage, but severe knocking indicates serious engine issues, affecting driving stability and causing abnormal wear on pistons and cylinders, potentially leading to cylinder scoring.

5

4

Share

How to Repair Peeling Clear Coat on Car Surface?

Check the size of the area where the clear coat has peeled off. If the area is small, you can handle it yourself using common DIY methods. If the area is large, take it to an auto repair shop. To treat the clear coat layer, first clean the scratched or peeled area with a cloth. Avoid using tools that could scratch the paint further. Apply toothpaste lightly to the peeled area, then use a pure cotton cloth to gently remove any debris with some pressure. Afterward, clean the cloth and wipe off the toothpaste. Wash and dry the car body thoroughly. Then, apply car paint repair liquid to a towel and polish the area in a circular motion until the surface becomes relatively smooth.

16

4

Share

How to adjust the navigation volume on a GL8?

When waiting for the navigation system's voice announcement, you can adjust the volume through the in-car navigation voice announcement. When waiting for the OnStar announcement, simply press the white OnStar button to adjust the volume while OnStar is speaking. The owner can directly use the knob to adjust the volume, as there are adjustment buttons on the steering wheel or center console for convenient and quick operation. After the vehicle starts and the center console screen turns on, you can adjust the navigation volume using the built-in volume adjustment function in the vehicle's background system.

10

1

Share

How to Remove the Inner Door Handle of a Buick GL8?

Use a flathead screwdriver to pry open the screw cover behind the handle, then unscrew the screw counterclockwise with a Phillips screwdriver. Remove the door trim panel. First, lift the door panel with a flathead screwdriver, then use a Phillips screwdriver to locate and pry off each trim panel clip one by one. Finally, lift the door trim panel upward. After removing the door trim panel, you will see the inner handle cable, small speaker wires, and window controller wires. Grip the window controller inside the door trim panel and push the entire controller upward with force. Observe the connector, press down the elastic buckle on the connector, and pull the connector downward to disconnect it.

3

5

Share

How to Remove the Fuel Pump from an Older Ford Mondeo?

Remove the rear seat cushion of the Ford Mondeo. Use a small flat-head screwdriver to slowly pry open the Ford Mondeo inspection hole cover. Disconnect the Ford Mondeo fuel pump cable from the negative terminal of the battery. Unplug the fuel line of the Ford Mondeo fuel pump. Clean the upper part and edges of the Ford Mondeo fuel pump assembly. Pull the Ford Mondeo fuel pump downward, press the locking tab at the bottom with your hand, and the fuel pump can be removed. Reinstall it in its original position.

18

3

Share

What does LO mean on car air conditioning?

LO on car air conditioning refers to the lowest temperature setting of the car's AC, and it can indicate two situations: 1. It means the AC is currently cooling rather than heating, with the cooling intensity further adjustable via different settings; 2. If the AC can display temperature values but currently only shows LO, it indicates maximum cooling. Some AC units may also display Hi or Me, representing high or medium temperature, respectively. LO stands for LOW, and HI stands for HIGH. Correct usage of car air conditioning: 1. The blue button on the left side of the car represents cold air, the red one represents warm air, and the middle one represents moderate temperature; 2. To activate cold air, adjust the left button towards the blue area. For warm air, adjust it towards the red area and press the AC switch. The middle button controls the fan speed, while the rightmost button adjusts the mode, allowing you to direct airflow to the feet, hands, windshield, or a combination of these; 3. The white line on the left adjusts the temperature. If it feels too warm, adjust it to the middle. To turn off the AC without shutting down the system, simply turn off the middle fan.

4

Share

How to Shift Gears Up and Down in a Manual Transmission?

Is it better to use 92 or 95 octane fuel for the Touran?

How to Repair Peeling Clear Coat on Car Surface?

How to adjust the navigation volume on a GL8?

How to Remove the Inner Door Handle of a Buick GL8?

How to Remove the Fuel Pump from an Older Ford Mondeo?

What does LO mean on car air conditioning?

Can a car with air suspension system failure still be driven?

How to Use Tire Wax?

How to Reset the Maintenance Reminder on Lynk & Co 05?

What to Do About Maintenance When Buying a Car in Another City?