How to Shift Between D and S Gears in an Automatic Transmission?

Must the clutch be pressed when braking to decelerate in Subject Three?

Subject Three requires pressing the clutch when braking. The requirements for vehicle speed are relatively high, and it generally involves high-speed driving. The higher the speed, the greater the inertia. If the clutch is pressed first, the vehicle's inertia will be even greater, potentially leading to the dangerous situation of coasting in neutral. Therefore, when decelerating at high speeds, you should first apply the brake to reduce the speed to a certain level, then press the clutch to downshift and further reduce the speed. The road driving skills test for Subject Three generally includes: 1. Contents: Vehicle preparation, simulated lighting test, starting, driving straight, gear shifting operations, changing lanes, pulling over, driving straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting oncoming vehicles, overtaking, making U-turns, and nighttime driving. 2. Time: Starting from June 1, 2021, the interval for scheduling the Subject Three test was adjusted from 30 days after passing Subject One to 20 days. For those applying for a medium or large passenger or truck driver's license, the interval for scheduling the Subject Three test was adjusted from 40 days after passing Subject One to 30 days.

9

0

Share

Does a Higher Seat Position in Subject 2 Require Earlier Reference Points?

In Subject 2 driving test, a higher seat position requires earlier reference points. When the seat is adjusted higher, each operation should be performed slightly earlier. Conversely, when the seat is lowered, the timing of operations can be slightly delayed. According to the "three-point alignment" principle, these points refer to the driver's eyes, a specific reference point on the vehicle, and the third point where the line connecting these two points projects onto the ground. If the seat height allows better visibility of blind spots beneath the front hood, when aligning the vehicle using a specific reference point, sticking to the original method might actually position the vehicle too far forward, risking crossing the line. Therefore, steering earlier becomes necessary. Conversely, if seated too low, following the original reference point method might leave the vehicle still far from the boundary line, requiring a slight delay in steering operations.

15

5

Share

How to Determine Prolonged Occupancy of the Overtaking Lane?

Methods to determine prolonged occupancy of the overtaking lane: using the overtaking lane as a regular driving lane without the purpose of overtaking, thereby hindering other vehicles from overtaking. The overtaking lane on highways is designated for vehicles that are overtaking or meet the required speed standards. However, some drivers occupy this lane for extended periods, forcing other vehicles to overtake from the slower regular driving lanes. Prolonged use of the overtaking lane increases the speed differential with vehicles attempting to overtake, leading to hazardous situations when overtaking from the regular lanes, as it further widens the speed gap with vehicles already traveling there, raising the risk of accidents. The overtaking lane is the leftmost lane on a highway and is only present on highways that meet the standards of a six-lane dual-carriageway.

4

1

Share

What does the traffic sign with a question mark and a light bulb mean?

The traffic sign with a question mark and a light bulb is a reminder for drivers not to forget to turn off their headlights after exiting a tunnel. This sign is usually placed at the exit of tunnels on highways. Inside tunnels, the lighting is dim, prompting drivers to turn on their headlights for better visibility. However, many drivers forget to turn them off after exiting the tunnel. This behavior is not only harmful to the vehicle but also poses a safety hazard to other drivers. Hence, such signs are installed to remind drivers to switch off their headlights after leaving the tunnel. When driving on highways, always remember two key points: first, turn off your high beams after exiting the tunnel if you had them on inside, and second, make adjustments to your side and rearview mirrors to minimize the impact of other drivers' high beams on your visibility.

3

4

Share

Can Full Synthetic Engine Oil Last for 15,000 Kilometers Before Replacement?

Full synthetic engine oil cannot last for 15,000 kilometers before replacement. The replacement interval for full synthetic oil is 10,000 kilometers or within one year. Methods to determine if engine oil should be replaced: 1. Repeatedly grind the extracted used oil. If impurities are felt, viscosity deteriorates, or it even feels gritty, the oil needs replacement; 2. Hold the extracted oil dipstick at a 45-degree angle under light and observe the oil droplets. If there are excessive wear particles, replacement is required; 3. Take a clean white filter paper or high-quality tissue paper, drip a few drops of oil on it, and wait for the oil to permeate. If the oil shows no powder, feels smooth, appears yellow with clear infiltration, it can still be used. If it appears dark brownish-black with impurities, replacement is necessary.

3

0

Share

What are the conditions for applying for a car lottery?

The conditions for applying for a car lottery are that the applicant must not have a passenger car registered in this city under their name, must not have a motor vehicle that should be scrapped but has not been deregistered, and must hold a valid motor vehicle driver's license issued by the traffic management department of the public security bureau. Methods for the car lottery: First, register and queue up for an appointment by submitting an application. Obtain an application code, and after passing the review, confirm the application code as a valid code to participate in the lottery and obtain an indicator code through the lottery process. The computer randomly selects 10 numbers, from which the lottery participant chooses one. Unsuccessful codes that pass the review automatically participate in the lottery within the validity period. If the lottery time changes for any reason, the Municipal Passenger Car Indicator Control and Management Office will announce it in advance. Notes for the car lottery: When participating in the lottery, note that a driver's license is required, and you must be a local resident or hold a residence permit. Each city has requirements regarding the duration of the residence permit. The indicator must be extended every three months; otherwise, the valid code will expire, and you cannot participate in the lottery.

14

1

Share

How to Shift Between D and S Gears in an Automatic Transmission?

Must the clutch be pressed when braking to decelerate in Subject Three?

Does a Higher Seat Position in Subject 2 Require Earlier Reference Points?

How to Determine Prolonged Occupancy of the Overtaking Lane?

What does the traffic sign with a question mark and a light bulb mean?

Can Full Synthetic Engine Oil Last for 15,000 Kilometers Before Replacement?

What are the conditions for applying for a car lottery?

What Causes the Tire Pressure Warning to Display When the Tires Are Inflated?

What is the Haval GW4G15F engine?

Why doesn't the tire pressure monitoring system reset after tire repair?

What is the method for querying vehicle information through the license plate number?