How to Set Up One-Touch Power Window for Leiling?
3 Answers
To set up the one-touch power window for Leiling, follow these steps: 1. Start the vehicle, press the one-touch start switch, raise the power window to the top, and hold the switch for 5 seconds; 2. Lower the power window to the bottom, and hold the switch for another 5 seconds to complete the setup. Taking the 2021 Leiling Progressive Edition as an example, it is a compact car under GAC Toyota, with body dimensions of 4640mm in length, 1780mm in width, and 1455mm in height, with a wheelbase of 2700mm. The 2021 Leiling Progressive Edition is equipped with a 1.2T turbocharged engine, with a maximum power speed ranging from 5200 to 5600 rpm.
I also encountered this issue when I was driving a Levin before, and it took me quite a while to figure out the one-touch window control function. Simply put, to set it up, you need to first sit in the driver's seat, start the engine but don't drive off. Press the window control button, hold it until the window reaches the top, then keep pressing for about three seconds until you hear a slight click or feel a minor vibration from the window. This indicates the system has memorized the position. Lowering the window follows a similar procedure—hold the button down for three seconds after the window reaches the bottom. Once set, you can open or close the window automatically with just a single press, which is super convenient and effortless. It took me a few tries to get it right because sometimes the car needs to reset its memory. Remember to check if the doors are properly closed—safety first. This feature is really handy in daily driving, saving you from the hassle of holding the button and getting distracted, especially when you need to close the window quickly during rain. If it doesn’t work, it might be due to a worn-out switch or a minor software glitch—just get it adjusted at a Toyota service center, and don’t worry about it costing too much.
From my experience, setting up the one-touch power window feature on the Leiling is actually quite simple. After starting the car, hold the driver's side window button and press it upward until the window is completely closed. Then, keep holding it for another three to five seconds, and the system will recognize and save the position. Similarly, for lowering the window, press the button all the way down and hold for a few seconds. Once set, it lasts for a long time and doesn't need to be done every time. I've noticed that if the setting doesn't work, it might be due to low battery causing a reset or a slightly faulty switch. In such cases, try restarting the engine or checking the door lock status when parked. This small feature significantly enhances driving comfort by reducing hand fatigue, especially during long drives. Don't overlook window system maintenance during car servicing—regularly lubricating the tracks can prevent noise and sticking, improving the overall driving experience.
