How to Set Up Automatic Door Locking When Leaving the Car?

What to Do If an Electric Vehicle Battery Gets Hot While Charging?

Solutions for an electric vehicle battery getting hot while charging: 1. Battery issues: Aging of the battery, increased internal resistance, dried-up electrolyte, or internal short circuits can cause heating. Additionally, the formation of sulfate crystals and sediment sticking to the lead plates during charging and discharging can increase battery resistance and lead to heating. Solution: These issues can be addressed through technical means such as adding water, desulfation, and depolarization. If the battery heats up due to a short circuit or broken cell, it is best to replace the battery. 2. Charger issues: Most chargers lack pulse functionality and negative pulse depolarization capability, often failing to maintain a constant voltage in the later stages of charging. This can cause the battery voltage to exceed permissible limits, leading to excessive gas generation, water loss, and heating. Solution: It is essential to choose the correct charger for the electric vehicle. The charging process is an electrochemical reaction, during which slight heating is normal. However, abnormal heating, when the battery is in good condition, is likely due to the charger.

4

0

Share

What is the fuel tank capacity of the Envision S?

The Envision S has a fuel tank capacity of 60 liters, with dimensions of 4662mm in length, 1883mm in width, and 1631mm in height, and a wheelbase of 2779mm. It boasts a maximum horsepower of 211ps, a maximum power output of 155kw, a torque of 270nm, and features a 9-speed automatic manual transmission with turbocharging. In comparison to vehicles in the same class, the Tiguan L 2022 330TSI automatic two-wheel-drive Comfort Edition has a fuel tank capacity of 60L, while the BMW X1 2022 sDrive20Li Fashion Edition has a fuel tank capacity of 61L. During actual refueling, the amount of fuel may exceed the calibrated capacity. This is because the fuel tank capacity marked by automobile manufacturers is measured from the bottom of the tank to the safety limit. There is additional space from the safety limit to the tank opening, which is reserved to allow for fuel expansion due to temperature increases without causing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked tank capacity. To check the remaining fuel level, drivers can observe the fuel gauge on the right side of the instrument panel, which is marked with E and F. When the needle is close to E, it indicates that the fuel is nearly empty, while being near F means the fuel level is sufficient.

13

1

Share

How to Disassemble a Sagitar Key?

Methods for disassembling a Sagitar key: 1. Open the folding part of the key and insert a flat-head screwdriver into the horizontal slot in the groove; 2. Once a larger gap is pried open, hold the key ring below and pull hard to separate the key into upper and lower parts; 3. Forcefully split the side, and this part of the key will separate into front and back pieces, completing the disassembly. The Sagitar is a joint venture A+ class sedan brand under FAW-Volkswagen, positioned as a German high-performance sedan. The 2019 Sagitar has dimensions of 4702mm in length, 1799mm in width, 1457mm in height, and a wheelbase of 2685mm.

11

1

Share

What is the battery brand and model for the Volkswagen Tayron?

Volkswagen Tayron's original equipment uses Fengfan 6-QW-60 with a capacity of 60-69AH. The original battery of a new vehicle can last for more than 3 years. During battery usage, attention should be paid to the battery's lifespan and usage precautions. Battery usage precautions include: If you notice the battery is not charging properly or the starter is weak, and the headlights are significantly dimmer, the battery should be removed and charged for 12-24 hours with a charger. If the issue persists and the mileage exceeds 50,000 KM, and the generator is functioning properly, consider replacing the battery. Owners should regularly inspect and conduct preliminary tests, addressing or replacing any issues early. After replacing the battery, the new battery may not be fully charged, including the original battery on new vehicles, which might not be at 100% capacity. Battery maintenance methods include: Avoid overusing the battery; regularly clean the positive and negative terminals; periodically check the vent holes on non-maintenance-free battery covers to prevent clogging; avoid low battery water levels; when parking for extended periods, start the vehicle once a week to charge the battery.

1

2

Share

Where is the air conditioning filter located in the Benben Mini?

The air conditioning filter in the Benben Mini is located behind the glove box on the passenger side. There are two screws each inside and below the glove box. After removing them, you can take off the glove box to access the filter's position. The Benben Mini does not come with an original air conditioning filter from the factory, but it has a designated space for one. The Benben Mini's dimensions are 3580mm in length, 1570mm in width, and 1490mm in height, with a wheelbase of 2345mm. Its front track is 1330mm, rear track is 1310mm, minimum ground clearance is 145mm, and it has a top speed of 158km/h. It is equipped with a Changan C10 engine, delivering a maximum power of 51.2kw.

13

2

Share

Is a Carbon Fiber Intake Pipe Useful?

Carbon fiber intake pipes are useful as they can reduce intake air temperature and ensure the engine's power output. Typically, a car's intake pipe is made of plastic, which does not provide thermal insulation. When the engine is running, the high temperature in the engine compartment can increase the intake air temperature, reducing the oxygen content in the air and affecting the engine's power output. Carbon fiber intake pipes offer thermal insulation, preventing the intake air temperature from being affected by the engine compartment's heat, thereby improving power output and stability. Some car owners modify their engines to enhance power and reduce intake air temperature by installing an alcohol injection system (including upgrading to a carbon fiber intake pipe), which can lower intake air temperature and boost power output.

9

3

Share

How to Set Up Automatic Door Locking When Leaving the Car?

What to Do If an Electric Vehicle Battery Gets Hot While Charging?

What is the fuel tank capacity of the Envision S?

How to Disassemble a Sagitar Key?

What is the battery brand and model for the Volkswagen Tayron?

Where is the air conditioning filter located in the Benben Mini?

Is a Carbon Fiber Intake Pipe Useful?

What to Do When the Windshield Wiper Doesn't Clean Properly?

What does the mild hybrid of the Envision Plus mean?

How to Turn on the Cold Air in Baojun 510?

How to start the Civic with one key?