
The method to set the time on an 8th generation Civic: 1. Press and hold the 'clock' button until you hear a beep, then release the button, and the time display will start flashing; 2. Set the hour by pressing and holding the 'H' preset button to select the correct hour; 3. Set the minutes by pressing and holding the 'M' button to select the correct minutes; 4. Press the 'clock' button to complete the setup. The 8th generation Civic is a compact sedan produced by Dongfeng , with body dimensions of 4517mm in length, 1799mm in width, and 1434mm in height, and a wheelbase of 2700mm. The front suspension of the vehicle is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension.

I usually drive an eighth-generation Civic, and setting the time is actually quite easy to remember. There's a small screen in the middle of the dashboard displaying the time, with a small button on each side. Press and hold the left button for a few seconds, and the hour digits will start blinking; then, short presses will increase the hour. The right button works the same way for adjusting the minutes. After setting, wait about ten seconds, and it will save automatically without any confirmation steps. It's safest to do this when the car is parked and turned off—doing it while driving can be distracting. By the way, here's a fun fact: the time resets when the car loses power. If you notice the time resetting to zero every time you start the car, you should check the or alternator.

I know the time setting of my old Civic like the back of my hand. Those two small knobs on either side of the electronic display in the instrument cluster are the control buttons. The left one adjusts hours while the right controls minutes. Hold down the corresponding button for a few seconds until the numbers flash, then gently tap to adjust. Last time I adjusted it, I noticed the minutes were always off by a few. Turned out it was due to poor button contact - cleaning the contacts with alcohol swabs fixed it. This generation doesn't have clock memory function, so you must reset it after replacement. Best to keep a setup guide in the glovebox so you don't forget.

To set the time on an 8th-gen Civic, just remember two things: left button adjusts hours, right button adjusts minutes. With the engine off, press and hold the left button until the numbers flash, then briefly press to adjust to the correct time; the same goes for minutes. Don't rush to release the button—wait until the numbers stop flashing to confirm the setting is saved. Once, I noticed the time was half an hour slow while driving at night and tried adjusting it one-handed at a red light, nearly causing a rear-end collision. Safety first.

Adjusting the time on our 2008 Civic is very simple. After starting the vehicle, look at the dashboard where there are two small black buttons on each side. The left button controls the hours, while the right one adjusts the minutes. Press and hold until the display blinks, then tap to set. Once I found a button stuck—turned out cola had spilled inside. After cleaning, it worked fine again. I recommend regularly checking button responsiveness since plastic parts age easily. Setting the time is much easier than changing wiper blades—even beginners can do it in three minutes.

As a veteran Civic owner, adjusting the time is something I can do with my eyes closed. Those two inconspicuous buttons behind the steering wheel on the instrument panel—the left one adjusts hours while the right adjusts minutes. Hold them down for three seconds to enter setup mode. Just a heads-up: the plastic buttons might get sticky after summer sun exposure, but a quick rub with an eraser restores responsiveness. Also worth noting—this generation's clock and AC system run on independent circuits, so even if the AC panel fails, the clock keeps working.


