How to Set the One-Touch Power Window for Nissan Sylphy?

[LaAubree]

The method to set the one-touch power window for Nissan Sylphy is as follows: 1. Lower the driver's side window; 2. Turn off the ignition switch and then turn it back to the ON position; 3. Pull up the window switch; 4. Hold the window switch for 5 to 10 seconds after the window is fully raised; 5. Turn off the ignition switch and wait for 10 seconds to complete the setup. The Nissan Sylphy has a body size of 4631mm in length, 1760mm in width, and 1503mm in height, with a wheelbase of 2700mm. Its minimum ground clearance is 166mm, fuel tank capacity is 50 liters, trunk capacity is 510 liters, and it features a 4-door, 5-seater sedan body structure.

[LaQuinn]

When setting the one-touch window lift function for the Sylphy, I found the key is to let the system relearn the window position. The specific steps are: First, sit in the driver's seat, turn the key to the ON position to power on (do not start the engine), then press and hold the driver's side window switch to raise the glass completely to the top. At this point, do not release the switch—keep holding it in the up position for about 5 seconds. When you hear a click or see the window slightly lower and then rise back up, it means the setting is successful. This function may fail after car washes or battery replacements, but simply resetting it will restore it. As a side note, the one-touch up/down feature is only available for the driver's side window—the passenger and other windows do not have this convenience feature.

[AuroraFitz]

The method I use to set the one-touch window lift for the Sylphy is to operate it with the power on: First, completely close the window, then hold the window lift button on the driver's side without releasing it. After the window reaches the top, continue holding for about 5 seconds until the system beeps to indicate recalibration is complete. Remember, only the driver's side window supports one-touch up and down; the other windows require holding the switch continuously. If the setting still doesn't work after configuration, it might be due to the battery being disconnected or the anti-pinch function being triggered. In this case, lower the window and repeat the setting process. Accumulated dust on the window tracks can affect sensitivity, so it's recommended to clean the tracks and apply lubricant annually.