How to Set the Horn Sound When Locking a Toyota Corolla?
4 Answers
Toyota Corolla's method for setting the horn sound when locking is: simultaneously press the unlock and lock buttons on the remote control for more than three seconds to switch modes. Taking the Corolla 2021 1.2T S-CVT Elite SPORT Edition as an example, the car's length, width, and height are 4635mm, 1780mm, and 1435mm respectively, with a wheelbase of 2700mm, a fuel tank capacity of 50 liters, a trunk capacity of 470 liters, and a curb weight of 1330kg. This car is equipped with a 1.2L inline four-cylinder turbocharged engine, with a maximum power of 85 kilowatts, a maximum power speed of 5200 to 5600 revolutions per minute, a maximum torque of 185 Newton meters, and a maximum torque speed of 1500 to 4000 revolutions per minute.
I remember helping my friend set up the horn sound for locking his Toyota Corolla last time, and it was actually quite simple. The main steps involve going into the car's settings menu step by step. You sit in the car without starting the engine, just turn on the ignition to light up the center display screen. Then, look for 'Settings' or 'Vehicle Settings' on the screen, go in and select the 'Door Lock' option. There should be a 'Confirmation Sound' or a similar name, click on it to enable the function. After saving the settings, press the lock button and you should hear the horn sound. After setting it up, it's recommended to test it to avoid going through the trouble for nothing. Why set it up? I think it's quite practical—the horn sound confirms that the doors are locked, especially when parking at night for added safety. However, be aware that different model years of the Corolla may vary slightly. For older models or lower trim levels, you might need to refer to the manual, as some require holding the lock button on the remote key for more than three seconds to set it up. Always check the settings before driving to avoid accidentally changing them and forgetting about it when you're out.
I've been driving a Corolla for several years and have researched the issue of adjusting the lock beep sound quite a bit. The key is to operate the vehicle's central control system. After starting the car, there's no need to turn on the engine—just rotate the key to the ACC position to activate the dashboard. Then, through the center touchscreen, navigate to the 'Vehicle Customization' menu, where you'll find the 'Door Lock Settings' section. Enable the 'Horn Feedback' function, and you're done. The whole process isn't technically difficult; the main thing is to patiently follow the on-screen prompts. Personally, I think setting this up is quite useful—a single beep can prevent accidental key presses when locking the door, saving you the worry of whether the car is properly locked. However, I'd advise testing it a few times after setting it up. Don't just set it and forget to check, as a glitch might prevent the horn from sounding, which could cause issues later. Note that the process varies slightly between different Corolla models. For example, the path changed a bit in post-2020 systems, so you might need to try a couple of times to find it. Asking a technician during maintenance can also help prevent setup failures.
Want to set the Corolla's lock beep? Quick method: Get in the driver's seat, insert the key and turn to the second position (no need to start the engine), open the center console screen, select the door lock option in settings, find the alarm sound related item and turn it on. Usually just a few clicks will do, save and press the remote lock button to test the horn response. The process is super simple and takes just minutes. Setting it up adds security, in case you press the wrong key you can confirm by sound, which is quite thoughtful. Settings may vary for different models, with higher trims having more intuitive menus and lower trims being slightly more complicated. Note that if it doesn't work, it might be a battery or signal issue—try a new key.
