How to Set Manual Maintenance for Maxus G20
2 Answers
Here is the introduction to the manual maintenance setting method for Maxus G20: 1. Method 1: Turn off the ignition switch. 2. Method 2: While turning on the ignition switch, press and hold the odometer hour reset button. 3. Method 3: Press and hold the odometer hour reset button again for a few seconds until the prompt message is completely cleared. 4. Method 4: Turn off the ignition switch. 5. Method 5: Press the clock adjustment button SET while turning on the ignition switch. 6. Method 6: Release the SET button, then press the SET button once more to complete the maintenance light reset.
I'm very familiar with this maintenance reminder setup—I've done it myself on my G20. First, make sure the car is turned off. Then, press and hold the menu button on the left side of the steering wheel (the one with the book icon) without releasing it. Next, press the start button without stepping on the brake to power up the instrument cluster. Keep holding the menu button—after about 5 to 10 seconds, the maintenance info will pop up on the dashboard. Don't let go yet! Wait until the prompt starts flashing and disappears before releasing the button. Honestly, it's simpler than it sounds—the key is to keep the button pressed the whole time without letting go midway. After resetting, it's best to drive for a couple of days to confirm the indicator light doesn't come back on, as the maintenance reminder is crucial for engine health.
