How to Set Cruise Control on Changan Oshan X7?
2 Answers
After the system is activated, press button B (SET) when the car reaches the desired speed. Here is an introduction to setting cruise control on the Changan Oshan X7: 1. After setting the cruise speed, you can still accelerate using the accelerator pedal as usual. When the accelerator is released, the system will restore the speed to the set cruise speed. 2. If after acceleration, the speed exceeds the cruise speed by more than 10 km/h and continues at this speed for more than 5 minutes, the cruise speed must be reset. Here are the steps to set cruise control on the Changan Oshan X7: 1. Press the ON button to activate the cruise control function and accelerate to the desired speed. 2. Move the lever towards SET to complete the speed setting. 3. Remove your foot from the accelerator.
The cruise control setup on the Changan Oshan X7 is actually quite intuitive. When I first used this car, I also took some time to figure it out. After starting the vehicle, make sure you're driving and preferably reach a speed above 40km/h, as cruise control may not function at low speeds. On the left side of the steering wheel, there's a cruise control lever with a CRUISE button and a SET key. Gently press the CRUISE button to activate the system, then accelerate to your desired speed and press the SET key to lock in the speed. To adjust the speed, use the "+" and "-" buttons for slight increments or decrements, which is quite convenient. To cancel, press the CANCEL key or lightly tap the brake, and it will stop immediately. I often use this feature on long drives, which saves a lot of energy and reduces fuel consumption. However, I’d advise against using it in rainy weather or congested areas to avoid accidents. If the cruise control suddenly fails, check if the fuse is blown or visit a 4S shop to inspect the sensors.