···
Log in / Register

How to See the 30 cm Right Side Line Without a Wiper?

4 Answers
VanAyla
07/29/25 6:23pm

Methods to see the 30 cm right side line without a wiper include: 1. Method One: Look at the Hood: The test site has side lines. From the driver's seat, if the right one-third of the hood aligns with the right side line, the car is about 30 cm away from the right side line. 2. Method Two: Look at the Wiper: From the driver's seat, when the raised part of the left wiper aligns with the right side line on the ground, the car is approximately 30 cm away from the right side line. If unsure, you can also confirm through the right rearview mirror to find the precise point. 3. Method Three: Look at the Right Rearview Mirror: Observe the front door handle in the right rearview mirror. When it is tangent to the right side line, the distance between the car body and the right side of the road is about 30 cm.

Was this review help?
2
4
Share
AmeliaMarie
08/14/25 11:10am

As a veteran taxi driver with over 20 years of experience, I always rely on familiarizing myself with vehicle dimensions to solve this problem. Without windshield wipers as a reference, I use the right-side body lines or window frames as new reference points; when parking by the curb, I reverse slowly and carefully observe the position of the curb line in the rearview mirror—30 centimeters usually corresponds to the lower half of the mirror. Practice in an open area by placing a cardboard box to simulate the curb line, adjusting repeatedly until you develop a sense of distance. Road safety cannot be overlooked; beginners tend to panic, so I recommend setting aside ten minutes each week to practice—experience will naturally turn it into a habit. Vehicle differences are significant, and the perspective changes when the seat is raised, so it's better to observe after fixing the seat position. Remember, don't rush to get it right all at once—safety comes first.

Was this review help?
12
1
Share
Expand All
LeLucas
10/14/25 5:49am

As a new driver who just got my license, this issue used to give me a headache. When the wipers are gone, I learned a practical trick: slow down and pull over, use your phone to take a photo or get out to check the distance directly. Although it's a bit troublesome, it's reliable. Most modern cars come with rearview cameras or radar systems, installing one can display the distance in centimeters in real-time, or even DIY a cheap sensor will do. In the initial stage, don't be afraid of being laughed at, moving slowly is key; safety first, practice a few times in an open area of the community and you'll get the hang of it. I also found that adjusting the rearview mirror angle helps, the roadside line reflected in it will appear narrow when it's 30 centimeters away. Additional tip: be extra careful when the road is slippery in rainy weather, adding an anti-slip mat can assist in observation.

Was this review help?
14
1
Share
Expand All
LeBarrett
11/27/25 6:45am

From a teaching perspective, the key lies in establishing new reference points. I recommend using the right side mirror as a benchmark, slowly approaching the curb to observe the line position; practice repeatedly in parking lots, setting 30-centimeter markers such as tape or small poles to gradually familiarize yourself with the distance. Maintain straight vehicle movement and use the side mirrors and intuition to judge. Expand safety considerations: avoid focusing only on one side, scan the environment comprehensively. Persist with a few days of practice, and your visual judgment will improve.

Was this review help?
17
1
Share
Expand All
More Forum Discussions

What engine does the Lynk & Co 01 New Energy use?

Lynk & Co 01 New Energy model is equipped with the Drive-E series VEP4-2.0TD engine. This engine has a displacement of 2.0L and adopts an inline four-cylinder structure. The engine follows a modular design concept and is equipped with different turbocharging forms. Below is an introduction to the Drive-E series VEP4-2.0TD engine used in the Lynk & Co 01 New Energy model: 1. The engine used in the Lynk & Co 01 achieves maximum torque at 1400 rpm. This engine has a maximum power of 140kw and a maximum torque of 300 N·m. When it comes to this series of engines, it's worth mentioning its achievements—this engine has won the Ward's 10 Best Engines award for three consecutive years. 2. The 2.0TD engine used in the Lynk & Co 01 shares the same basic parameters as the Volvo T4 engine, but this engine has undergone special tuning for different vehicle models, ensuring perfect compatibility with various models. 3. The significance of the Drive-E powertrain lies in breaking through the limitations of cylinder count while also constraining engine performance. Although the engine has a small displacement, it is more efficient and has lower emissions. In summary, this engine achieves a perfect balance between power and environmental friendliness. Because this engine adopts a centrally located fuel injector design, it allows for more thorough mixing of fuel and air, improving the engine's fuel efficiency and reducing the vehicle's fuel consumption.
15
5
Share

What to Do If the Car Water Pump Is Leaking?

Solutions for car water pump leakage: 1. If the leakage is at the pipe connection, it is less likely to occur with a newly installed pump. It is recommended to disassemble and reinstall. 2. If the pump leaks while pumping water, it is usually due to a leaking water seal. It is advised to disassemble the pump and replace the water seal. 3. Long-term leakage may be caused by the absence of a check valve on the outlet side of the pump. It is recommended to install a check valve. Working principle of the car water pump: The engine drives the pump bearing and impeller through the pulley. The coolant in the pump is rotated by the impeller and, under centrifugal force, is thrown to the edge of the pump housing, generating pressure before flowing out through the outlet or pipe. The center of the impeller experiences reduced pressure as the coolant is thrown outward, causing coolant from the radiator to be drawn into the impeller through the pipe due to the pressure difference between the pump inlet and the impeller center, achieving a reciprocating cycle of the coolant.
20
1
Share

Where is the battery located in the Mercedes-Benz ML350?

The battery of the Mercedes-Benz ML350 is located under the front passenger seat. You need to move the seat all the way forward or backward, then remove the cover panel to access it. During the battery replacement process for the ML350, it is crucial not to disconnect the power, as this could lock the vehicle's computer system. To maintain continuous power supply, ensure the new battery is fully charged and use a jump-start method when replacing. The Mercedes-Benz ML350 is a model under the Mercedes-Benz brand, with body dimensions of 4804mm in length, 1926mm in width, and 1796mm in height, and a wheelbase of 2915mm. The ML350 features a predominantly dark color scheme for its body, with the dashboard adorned with high-quality wood trim. The steering wheel offers a visually robust feel, and the meticulously designed smooth lines contribute to an extraordinary interior aesthetic.
19
4
Share

What class of car is the Bora?

The Bora belongs to the compact sedan category, meaning it has an overall length between 4.2 to 4.6 meters, a wheelbase ranging from 2.4 to 2.7 meters, and typically features an engine displacement of around 1.6 to 2.0 liters. The Bora is FAW-Volkswagen's first independently designed model, with body dimensions measuring 4663mm in length, 1815mm in width, and 1473mm in height, along with a wheelbase of 2688mm. The Bora is equipped with two engine options: a 1.4-liter turbocharged engine and a 1.5-liter naturally aspirated engine. The 1.5-liter naturally aspirated engine delivers a maximum power of 83 kilowatts and a peak torque of 145 Newton-meters, paired with either a 5-speed manual transmission or a 6-speed automatic transmission. The 1.4-liter turbocharged engine produces a maximum power of 110 kilowatts and a peak torque of 250 Newton-meters, mated to a 7-speed dual-clutch transmission.
12
0
Share

What is the cooling principle of car air conditioning?

Car air conditioning cooling principle refers to the operational mechanism of air conditioning refrigeration. After the air conditioner is powered on, the low-pressure refrigerant vapor in the refrigeration system is sucked in and compressed into high-pressure vapor by the compressor, then discharged to the condenser. The indoor air continuously circulates, achieving the purpose of lowering the temperature. The outdoor air drawn in by the axial fan flows through the condenser, carrying away the heat released by the refrigerant, causing the high-pressure refrigerant vapor to condense into high-pressure liquid. The high-pressure liquid passes through the filter and throttle mechanism before being sprayed into the evaporator, where it evaporates under the corresponding low pressure, absorbing heat from the surroundings. Simultaneously, the cross-flow fan causes air to continuously enter the spaces between the evaporator fins for heat exchange, and the cooled air after releasing heat is directed into the cabin.
4
2
Share

Is the engine of the Geely Boyue a three-cylinder or four-cylinder?

Geely Boyue 2018 model is equipped with a four-cylinder engine, while the 2019 1.5T model features a three-cylinder turbocharged engine. The Geely Boyue is a compact SUV with body dimensions of 4519mm in length, 1831mm in width, and 1694mm in height, and a wheelbase of 2670mm. In terms of configuration, the vehicle is equipped with convenience and entertainment features such as electric mirror adjustment, one-button start, an 8-inch central control screen, and the GKUI vehicle system. It also offers ESP, TCS, brake assist, emergency braking reminder, front dual airbags, cruise control, tire pressure monitoring, electronic handbrake, and automatic parking.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.