How to restart the black screen of X-Trail's large screen navigation?
2 Answers
First, check if the display screen is damaged. If the display on the screen appears normal, then the issue is not with the display screen. Inspect each connector one by one. If there is poor contact in a connector, there may be a gap. If you find a poorly connected wire connector, you can directly remove it. Press the screen switch continuously to force a restart. If the above methods do not resolve the issue, you will need to visit a 4S shop for repairs.
When the navigation screen of the X-Trail goes black, the restart method is quite simple. I've encountered this situation myself—just press and hold the power button on the screen for about ten seconds until the system completely shuts down and reboots. Remember, don’t press too hard; a steady hold is enough to trigger a hardware reset. If the screen remains black after restarting, it might be due to a system software freeze. In that case, try again or wait a few minutes for it to cool down, as overheating can also cause malfunctions, especially during summer drives in high temperatures. Additionally, check the relevant fuses in the car, usually located in the fuse box on the driver’s side, to see if any have blown. To minimize lag, avoid running too many background apps on the system. If the screen goes black while driving, find a safe place to pull over and address the issue to avoid distracted driving. These small fixes can resolve most problems, saving both money and hassle.
